===================== Product Identification =====================
MSDS NAME:TT-P-29
NIIN:00-559-3257
MSDS Number: BFFLB
=== Responsible Party ===
Company:STIC-ADHESIVE PROD CO, INC
Emergency Phone Num:213-268-2956
CAGE:59142
=== Contractor Identification ===
Company:STIC-ADHESIVE PRODUCTS CO INC
Address:3950 MEDFORD ST
Box:City:LOS ANGELES
State:CA
ZIP:90063-1675
Country:US
CAGE:59142
============= Composition/Information on Ingredients =============
Name:1-3-(CHLOROALLYL)-3,5,7-TRIAZA-1-AZONIAADAMANTANE CHLORIDE
CAS:4080-31-3
RTECS #:XX8450000
ACGIH TLV:200PPM
Name:FORMALDEHYDE (SARA III)
CAS:50-00-0
RTECS #:LP8925000
OSHA PEL:SEE 1910.1048
ACGIH TLV:C 0.3 PPM; A2; 9293
EPA Rpt Qty:100 LBS
DOT Rpt Qty:100 LBS
===================== Hazards Identification =====================
Effects of Overexposure:IRRIT OF EYES/NASAL PASSAGE/SKIN
======================= First Aid Measures =======================
First Aid:SKIN: WASH W/SOAP & WATER. EYE: FLUSH W/COLD WATER.
SWALLOWED: INDUCE VOMIT, CALL MD.
===================== Fire Fighting Measures =====================
Fire Fighting Procedures:NONE
Unusual Fire/Explosion Hazard:NONE
================== Accidental Release Measures ==================
Spill Release Procedures:CLEAN UP W/WATER BEFORE DRYING. SPRINKLE
SODIUM CHLORIDE OR CALCIUM ON SPILL TO FACILITATE CLEANUP.
====================== Handling and Storage ======================
Handling and Storage Precautions:USE W/ADEQUATE VENT. STORE BETWEEN
40-100F. REMOVE FROM SKIN AS SOON AS PRACTICAL AFTER CNTCT.
Other Precautions:PIPELINES SHOULD BE FILLED AT ALL TIMES, OR
THOROUGHLY RINSED AFTER USE. KEEP CNTNRS TIGHTLY SEALED.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:MASK WORN TO PREVENT INH OF SPRAY MIST OR HEATED
VAPORS
Ventilation:LOCAL &/OR MECH
Protective Gloves:RUBBER/PLASTIC
Eye Protection:SAFETY GLASSES/GOGGLES
Supplemental Safety and Health
================== Physical/Chemical Properties ==================
HCC:T4
Solubility in Water:COMPLETE
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSE IAW STANDARD PROCEDURES USED W/LATEX
PROD
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|