=====================  Product Identification  =====================

MSDS NAME:SKL-LO SPOTCHECK PENETRANT(LOW ODOR)POST 86
NIIN:00-782-2734
MSDS Number: BFPMB
=== Responsible Party ===
Company:MAGNAFLUX CORPORATION
Address:7300 W.LAWRENCE AVENUE
City:CHICAGO
State:IL
ZIP:60656-3504
Country:US
Info Phone Num:312-867-8000
Emergency Phone Num:312-867-8000
Preparer's Name:BRUCE C.GRAHAM
CAGE:37676
=== Contractor Identification ===
Company:ILLINOIS TOOL WORKS INC MAGNAFLUX DIV
Address:3624 WEST LAKE AVENUE
Box:City:GLENVIEW
State:IL
ZIP:60025
Country:US
Phone:847-657-5300/
CAGE:37676

=============  Composition/Information on Ingredients  =============

Name:DISTILLATES (PETROLEUM),CATALYTIC REFORMER FRACTIONATER
    RESIDUE,LOW BOILING
CAS:68477-31-6
Fraction by Wt: 10.0%

Name:PARAFFIN OILS
CAS:64771-72-8
Fraction by Wt: 40.0%

Name:NAPHTHALENE  (SARA III)
CAS:91-20-3
RTECS #:QJ0525000
Fraction by Wt: 02.0%
OSHA PEL:10 PPM/15 STEL
ACGIH TLV:10 PPM/15 STEL; 9192
EPA Rpt Qty:100 LBS
DOT Rpt Qty:100 LBS

Name:UNIDENTIFIED COMPONENTS;PER MFR,CONTAINS NO OTHER
    INGREDIENT SUSPECTED OF BEING HAZARDOUS I/A/W INFO IN
    29CFR1910.1200

=====================  Hazards Identification  =====================

Health Hazards Acute and Chronic:ACUTE:IRRITATING TO SKIN &
    EYES;SIGNIFICANT AMOUNT OF VAPOR INHALATION CAN RESULT IN
    CLUMSINESS & POOR JUDGEMENT,WITH RESULTING DANGER TO THE
    VICTIM.MUCH LIKE ALCOHOL EFFECT.
Effects of Overexposure:INHALATION:CAUSES
    DIZZINESS,NAUSEA,DROWSINESS,FROM INHALATION OF SPRAY MIST;
    SKIN:CAUSES IRRITATION,DISSOLVES SKIN OILS.POSSIBLE DERMATITIS ON
    FREQUENT OR PROLONGED EXPOSURE; EYES:MODERATE IRRITATION  BY
    CONTACT OF LIQUID OR SPRAY; INGESTION:LOW TOXICITY,BUT HAZARDOUS IF
    ASPIRATED INTO LUNGS BY INGESTION OR VOMITING.
Medical Cond Aggravated by Exposure:NOT STATED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:INHALATION:REMOVE TO FRESH AIR.IF NOT BREATHING,GIVE CPR.IF
    BREATHING IS DIFFICULT,GIVE OXYGEN; SKIN:WASH OFF IN FLOWING WATER
    OR SHOWER.RMV CONTAMINATED CLOTHING AND WASH BEFORE RE-USE.USE
    SOOTHING L OTION; EYES:FLUSH EYES WITH A STEADY,GENTLE FLOW OF
    WATER.GET MEDICAL ASST; INGESTION:DO NOT INDUCE VOMITING.IF VOMIT
    IS INHALED,IT MAY CAUSE ASPHYXIATION.GET MED ATTN IMMEDIATELY;IN
    EMERGENCY CALL MD

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:>200F/>93.3C
Lower Limits:1.0
Upper Limits:6.0
Extinguishing Media:CARBON DIOXIDE,FOAM
Fire Fighting Procedures:KEEP CONTAINERS COOL WITH WATER SPRAY
Unusual Fire/Explosion Hazard:WHEN INVOLVE IN COMBUSTION,MAY EMIT TOXIC
    GASES AT OR ABOVE DECOMPOSITION TEMPERATURE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE IGNITION SOURCES.SM QTY:WIPE UP OR MOP
    UP BUT DO NOT BREATHE VAPORS.PLACE RAGS IN CLOSED DRUMS; LG
    QTY:WEAR PERSONAL SAFETY EQUIPMENTS.DIKE AREA FAR AHEAD.ABSORB
    LIQUID WITH COMMERCIAL ABSORBEN T.TRANSFER WASTE MATL IN SALVAGE
    TANKS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE AWAY FROM HEAT SOURCES IN WELL
    VENTILATED AREA.AVOID AGAINST PHYSICAL DAMAGE TO CONTAINERS.KEEP
    CONTAINERS TIGHTLY CLOSED.
Other Precautions:DO NOT BREATHE VAPORS.DO NOT SMOKE WHILE USING.DO NOT
    HEAT ABOVE 130F(54C).AVOID FREQUENT OR PROLONGED SKIN CONTACT.DO
    NOT SPRAY INTO FLAME,ARCS,OR RED HOT SURFACES.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WEAR A RESPIRATOR WITH CHEMICAL CARTRIDGE. IN
    CONFINED AREAS,WEAR A FULL MASK WITH SEPARATE AIR SUPPLY.
Ventilation:GENERAL VENTILATION TO KEEP BELOW 350PPM LIMIT.
Protective Gloves:NITRILE RUBBER GLOVES
Eye Protection:FULL GOGGLES
Other Protective Equipment:EITHER USE IN A SPRAY BOOTH OR NEXT TO AN
    EXHAUST VENT.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING.LAUNDER
    CONTAMINATED CLOTHES BEFORE RE-USE.
Supplemental Safety and Health
ITEM IS ONE PART PRODUCT;SKL-LO PENETRANT CAN GO WITH EMULSIFIER AS A
    PART OF A KIT;NSN WAS FOR GROUP I/IA/II OF MIL-I-25135C;DURING
    1987,SEGMENT M OF THIS NSN WAS CHANGED TO READ TYPE II,METHOD B,FOR
     MIL-I-25135D.QPL-25135-15 QUALIFIED SKL-LO FOR TY II,METH B; FOR
    GROUP I/IA/II MATL,SEE PNI-A,THIS NSN.

==================  Physical/Chemical Properties  ==================

HCC:N1
Boiling Pt:B.P. Text:400F/204C
Vapor Pres:<0.5@100F
Vapor Density:>1.0
Spec Gravity:0.88
Solubility in Water:NEGLIGIBLE
Appearance and Odor:DARK RED LIQUID,LOW ODOR

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HEAT,HIGH TEMPERATURES
Hazardous Decomposition Products:EMITS OXIDES OF CARBON AND NITROGEN.

====================  Disposal Considerations  ====================

Waste Disposal Methods:INCINERATE OR DISPOSE OF AS EPA HAZARDOUS WASTE
    D001 (IGNITABLE WASTE),IN ACCORDANCE WITH ALL APPLICABLE
    FEDERAL,STATE,LOCAL REGULATIONS;IF LOCAL AUTHORITIES PROHIBIT
    DUMPING RINSINGS DOWN THE SEWER,P URIFY RINSINGS WITH MAGNAFLUX
    WASTEWATER SYSTEM.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***