=====================  Product Identification  =====================

MSDS NAME:TT-E-508
NIIN:00N010735
MSDS Number: BHCHY
=== Responsible Party ===
Company:SPECTRA-TONE PAINT CORPORATION
Address:9635 KLINGERMAN STREET
City:S.EL MONTE
State:CA
ZIP:91733
Info Phone Num:213-686-1246
Emergency Phone Num:213-686-1246
CAGE:52100
=== Contractor Identification ===
Company:SPECTRA-TONE PAINT CORP
Address:1595 E SAN BERNADINO AVE
Box:City:SAN BERNADINO
State:CA
ZIP:92408-2946
Country:US
Phone:800-272-4687/818-442-7269
CAGE:52100

=============  Composition/Information on Ingredients  =============

Name:MINERAL SPIRITS
CAS:64742-88-7
Fraction by Wt: 30%
Other REC Limits:500 PPM
OSHA PEL:
ACGIH TLV:

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:SEE SIGNS & SYMPTOMS OF OVEREXPOSURE.
Explanation of Carcinogenicity:N/A FPN
Effects of Overexposure:ACUTE:HEADACHE,NAUSEA,DIZZINESS,LASSITUDE,LOSS
    OF COORDINATION OR CONSCIOUSNESS.CHRONIC;NONE RECOGNIZED.
Medical Cond Aggravated by Exposure:N/K 

=======================  First Aid Measures  =======================

First Aid:INHALATION:REMOVE TO FRESH AIR,GIVE ARTIFICIAL RESPIRATION IF
    BREATHING HAS STOPPED,EYE;FLUSH EYES W/ COPIOUS AMOUNTS OF WATER
    FOR AT LEAST 15 MINUTESSKIN:WASH SKIN WITH SOAP AND WATER CHANGE CL
    OTHES AND SHOES.INGEST:DO NOT INDUCE VOMITING.ASPIRATION OF VOMITUS
    MAY RESULT IN CHEMICAL PNEUMONITIS AND/OR PULMONARY EDEMA,CALL A
    PHYSICIAN.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:130 F.
Lower Limits:
Upper Limits:
Extinguishing Media:USE FOAM,DRY CHRMICAL OR CO#2.
Fire Fighting Procedures:SCBA RECOMMENDED.WATER MAY BE UNSUITABLE AS AN
    EXTINGUISHING MEDIUM,BUT HELPFUL IN COOLING CONTR & SURFACES.NEVER
    USE A DIRECT STREAM OF H*2O.USE H2O(SUP DATA)
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR & MAY
    ACCUMULATE IN LOW AREAS OF POOR VENT.VAPORS CAN TRAVEL ALONG THE
    GROUND TO REMOTE IGNITION SITES.CLOSED CONTRS CAN (SUP DATA)

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE SOURCES OF IGNITION,INCLUDING HOT METAL
    SURFACES,CLEAN UP SPILL IMMEDIATELY BY SOAKING UP W/ ABSORBENTS
    SUCH AS CLAY,SAND,DIATOMACEOUS EARTH,ETC.
Neutralizing Agent:

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP COOL,DRY,AND AWAY FROM IGNITION
    SOURCES.STORE IN WELL VENTILATED AREA.
Other Precautions:AVOID PERSONAL CONTACT (SKIN,EYES,ETC.). USE WITH
    ADEQUARE VENT-DO NOT INHAL VAPORS.GROUND DRUMS WHEN POURING OR
    OTHERWISE DISPENSING.DO NOT WELD,DRILL ,CUT OR HEAT FULL,PARTIAL,OR
    EVEN EMPTY CONTAINE RS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV IS EXCEEDED USE A NIOSH APPROVED
    RESPIRATOR OR A SCBA.USE MECHANICAL FILTER TO REMOVE SOLID AIRBORNE
    PARTICLES DURING SPRAY APPLICATION.
Ventilation:GENERAL MECHANICAL VENT MAY BE SUFFICIENT TO,KEEP EXPOSURE
    BELOW TLV.USE ONLY EXPLOSION PROOF VENT W/ FLAMMABLE MATERIAL
Protective Gloves:NEOPRENE GLOVES ARE SUGGESTED.
Eye Protection:CHEM WORK GOGGLES,FACESHLD OPTIONAL
Other Protective Equipment:APRONS,EYE WASHES,SAFETY SHOWERS.
Work Hygienic Practices:OBSERVE GOOD WORK HYGIENIC PRACTICES
Supplemental Safety and Health
WT PER GALLON 10.7SPECIAL FIRE FIGHTING PROCEDURES:FOG & AVOID SPREDING
    BURNING LIQUID WHICH MAY FLOAT & BURN ON TOP OF H*20
    SURFACE.UNUSUAL FIRE & EXPLOSION HAZARDS:BUILD UP PRESSURE WHEN
    EXPOSED TO	HEAT.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:318-390 F
Melt/Freeze Pt:M.P/F.P Text:N?K FPN
Decomp Temp:Decomp Text:
Vapor Pres:
Vapor Density:HEAV AIR
Spec Gravity:1.286
pH:
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:
Appearance and Odor:
Percent Volatiles by Volume:52
Corrosion Rate:

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS,STRONG ACIDS & BASES SELECTED AMINES.
Stability Condition to Avoid:
Hazardous Decomposition Products:CARBON MONOXIDE,CARBON
    DIOXIDE,UNIDENTIFIED ORGANIC COMPOUNDS.
Conditions to Avoid Polymerization:HEAT,SPARKS,OPEN FLAME.

====================  Disposal Considerations  ====================

Waste Disposal Methods:PLACE IN NON-LEAKING CONTAINERS & DISPOSE OF IN
    ACCORDANCE WITH APPLICABLE LOCAL,COUNTY,STATE AND FEDERAL
    REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***