===================== Product Identification =====================
MSDS NAME:COATING, POLYURETHANE SAND 33303 ID754208
NIIN:01-131-6259
Kit Part:Y
MSDS Number: BHGFN
=== Responsible Party ===
Company:PRATT & LAMBERT, INC.
Address:16116 E 13TH ST
Box:2153
City:WICHITA
State:KS
ZIP:67201
Country:US
Preparer's Name:CLARA 67201
CAGE:FO127
=== Contractor Identification ===
Company:PRATT & LAMBERT, INC/BUFFALO, NY 14240
Box:22
CAGE:FO127
Company:PRATT AND LAMBERT INC
Address:Box:6027
City:CLEVELAND
State:OH
ZIP:44101-1027
Country:US
Phone:216-566-2902
CAGE:61196
============= Composition/Information on Ingredients =============
Name:PROPYLENE GLYCOL METHYL ETHER ACETATE (VP MM HG @ 20 DEG C
2)
CAS:108-65-6
RTECS #:AI8925000
OSHA PEL:NONE ESTABLISHED
ACGIH TLV:NONE ESTABLLISHED
Name:TOLUENE (SARA III)
CAS:108-88-3
RTECS #:XS5250000
OSHA PEL:200 PPM/150 STEL
ACGIH TLV:50 PPM; 9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:METHYL ETHYL KETONE (2-BUTANONE) (MEK) (SARA III)
CAS:78-93-3
RTECS #:EL6475000
OSHA PEL:200 PPM/300 STEL
ACGIH TLV:200 PPM/300STEL 9192
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS
Name:SILICA, CRYSTALLINE - CRISTOBALITE
CAS:14464-46-1
RTECS #:VV7325000
OSHA PEL:SEE TABLE Z3
ACGIH TLV:0.05 MG/M3 RDUST9293
Name:SILICA, CRYSTALLINE - CRISTOBALITE
CAS:14464-46-1
RTECS #:VV7325000
OSHA PEL:SEE TABLE Z3
ACGIH TLV:0.05 MG/M3 RDUST9293
Name:SILICA, CRYSTALLINE - QUARTZ
CAS:14808-60-7
RTECS #:VV7330000
OSHA PEL:SEE TABLE Z3
ACGIH TLV:0.1 MG/M3 RDUST;9293
Name:TITANIUM DIOXIDE
CAS:13463-67-7
RTECS #:XR2275000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9293
Name:VOL ORGANIC CMPD 4.5 LB/GL LESS WATER & NPRS* 540 G/L LESS
WATER VOC 12.4 LB/GAL SOLIDS 1488 G/L SOLIDS CALCULATED
RTECS #:9999999VO
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:SWALLOWING-GASTROINTESTINAL
IRRITATION, ASPIRATION OF MATERIAL INTO LUNG MAY CAUSE CHEMICAL
PNEUMONITIS. EYE AND SKIN-IRRITATION. HIGH CONCENTRATIONS MAY CAUSE
ACUTE CENTRAL NERVOUS SYSTEM DEPRESSION CHARACTERIZED BY
HEADACHED,DIZZINESS,NAUSEA AND CONFUSION.
Explanation of Carcinogenicity:AT THE TLV THE TIO2 MANUFACTURER
CONCLUDES THAT THERE IS NO SIGNIFICANT HAZARD FOR MAN.
Effects of Overexposure:INTENTIONAL MISUSE BY DELIBERATELY INHALING THE
CONTENTS MAY BE HARMFUL OR FATAL.OVEREXPOSURE TO TOLUENE MAY CAUSE
LIVER DAMAGE.OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN/NERVOUS
SYSTEM DAMAGE.
Medical Cond Aggravated by Exposure:PREEXISTING RESPIRATORY CONDITIONS
MAY BE AGGRAVATED BY EXPOSURE TO CRYSTALLINE SILICA.
======================= First Aid Measures =======================
First Aid:SWALLOWING-CALL POISON CENTER AND GET MED ATTN.
INHALATION-REMOVE TO FRESH AIR AND GET MED ATTN. EYE-FLUSH WITH
WATER FOR 15 MIN. GET MED ATTN. SKIN-REMOVE CONTAMINATED CLOTHING,
WASH AFFECTED AREA IF IRRITATION PERSISTS.GET MED ATTN. NOTETO
PHYSICIAN-ANY TREATMENT THAT MIGHT BE REQUIRED FOR OVEREXPOSURE
SHOULD BE DIRECTED AT THE CONTROL OF SYMPTOMS AND THE CLINICAL
CONDITIONS
===================== Fire Fighting Measures =====================
Flash Point:24F/-4.44C
Extinguishing Media:USE CLASS B FIRE EXTINGUISHERS. POLYMER FOAM IS
PREFERRED FOR LARGE FIRES.
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS. USE
WATER TO COOL EXPOSED CONTAINERS TO PREVENT POSSIBLE AUTO
IGNITION/EXPLOSION. USE FOG NOZZLES IF WATER IS USED.
Unusual Fire/Explosion Hazard:OVEREXPOSURE TO DECOMPOSITION MAY CAUSE
HEALTH HAZARD. SYMPTOMS MAY NOT BE IMMEDIATELY APPARENT. OBTAIN
MEDICAL ATTENTION.
================== Accidental Release Measures ==================
Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES.DIKE AND
CONTAIN SPILL WITH INERT MATERIAL. RECOVERY OR DISPOSAL IN A
COVERED METAL CONTAINER. USE NON-SPARKING TOOLS. PREVENT
CONTAMINATION OF SEWERS,STREAMS,GROUNDWATE R.
Neutralizing Agent:NONE LISTED.
====================== Handling and Storage ======================
Handling and Storage Precautions:DO NOT STORE ABOVE 95F. STORE LARGE
QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106.
Other Precautions:DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER EACH
USE. DO NOT BREATH SANDING DUST. DO NOT RE-USE CONTAINER. DO NOT
WELD/BRAZE OR CUT ON EMPTY CONTAINER. NEVER USE PRESSURE TO EMPTY.
CONT GROUNDED AND BONDED TO THE RECEIVING CONTAINER.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:WHEN SPRAYING OUTDOORS, OR IN OPEN OR
WELL-VENTILATED AREAS, USE NIOSH APPROVED MECHANICAL FILTER
RESPIRATOR TO REMOVE OVERSPRAY. REFER TO OSHA 29CFR1910.134
RESPIRATORY PROTECTION.
Ventilation:GENERAL DILUTION AND LOCAL EXHAUST VENT IN SUFFICIENT
VOLUME & PATTERN TO MAINTAIN CONCENTRATIONS OF HAZARDOUS SUBSTANCE
Protective Gloves:SOLVENT IMPERMEABLE GLOVES ARE REQUIRED.
Eye Protection:WEAR SAFETY SPECTACLES.
Other Protective Equipment:NOT LIKELY TO BE NEEDED.
Work Hygienic Practices:NONE LISTED.
Supplemental Safety and Health
THIS URETHANE BASE IS ONE PART OF A TWO COMPONENT MIXTURE. IT IS
INTENDED TO BE MIXED WITH AN ACTIVATOR. THE CONTENTS OF THIS
PACKAGE MUST BE BLENDED WITH OTHER COMPONENTS BEFORE THE PRODUCT
CAN BE US ED. BEFORE OPENING PACKAGES, BE SURE YOU UNDERSTAND THE
WARNING MESSAGES AND LABELS OF ALL COMPONENTS.
================== Physical/Chemical Properties ==================
HCC:F2
Boiling Pt:B.P. Text:175F/281F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:63
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT AND SOURCES OF
IGNITION.
Hazardous Decomposition Products:BURNING/WELDING/CUTTING WILL PRODUCE
SMOKE,CARBON MONOXIDE AND CARBON DIOXIDE.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT,SPARKS AND
FLAME.
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSE IAW FED/ST/LOCAL LAWS.INCINERATE ONLY IN
EPA FACILITY.DISPOSE IN A HAZARDOUS WASTE LANDFILL. RCRA
CLASSIFICATION WOULD BE D001. ENVIRONMENTAL HAZARD NONE KNOWN.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|