49-150 Page: 1
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: HI-BILD PRIMER (PART A) HMIS CODES: H F R P
PRODUCT CODE: 49-150 2*1 0
=================== SECTION I - MANUFACTURER IDENTIFICATION ==================
MANUFACTURER'S NAME: ELLIS PAINT CO.
ADDRESS : 3150 E. PICO BLVD.
LOS ANGELES, CA 90023-3683
EMERGENCY PHONE(CHEMTREC) : (800) 424-9300 DATE PRINTED : 09/12/06
INFORMATION PHONE : (323) 261-8114 NAME OF PREPARER : N/A
=========== SECTION II - HAZARDOUS INGREDIENTS/SARA III INFORMATION ==========
VAPOR PRESSURE WEIGHT
REPORTABLE COMPONENTS CAS NUMBER mmHG @TEMP(F) PERCENT
----------------------------------------------------------------------------------
BISPHENOL-A BASED EPOXY,PHENOLIC COPOLYMER 68334-76-9 <20 68 24
OSHA PEL: NE, ACGIH TLV: NE
CALCIUM CARBONATE (as total nuisance dust) 1317-65-3 NA NA 8
ACGIH TLV: 10 mg/m3
~ ETHYLENE GLYCOL MONOPROPYL ETHER 2807-30-9 1.16 68 6.59
OSHA PEL: N/E, ACGIH TLV: N/E
LIGHT AROMATIC SOLVENT NAPHTHA 64742-95-6 3 68 2.5
OSHA PEL: 100 ppm, ACGIH TLV: 100 ppm
TITANIUM DIOXIDE (as total nuisance dust) 13463-67-7 NA NA 2
OSHA PEL: 10 ppm, ACGIH TLV: 10 mg/m3
~Indicates toxic chemical(s) subject to the reporting requirements of section
313 of Title III and of 40 CFR 372.
================ SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS =============
BOILING RANGE (Deg F): 300 - 301 DENSITY: 11.76 lb/gl
VAPOR DENSITY: HEAVIER THAN AIR SPECIFIC GRAVITY (H2O=1): 1.41
COATING V.O.C.: 1.84 lb/gl MATERIAL V.O.C.: 1.07 lb/gl
COATING V.O.C.: 220 g/l MATERIAL V.O.C.: 128 g/l
SOLUBILITY IN WATER: Partial EVAPORATION RATE: SLOWER THAN ETHER
APPEARANCE AND ODOR: White liquid with a slight odor.
================== SECTION IV - FIRE AND EXPLOSION HAZARD DATA ===============
FLASH POINT (Deg F): >200 METHOD USED: TCC
FLAMMABLE LIMITS IN AIR BY % VOLUME- LOWER: .01 UPPER: 15.8
EXTINGUISHING MEDIA: FOAM, CO2, DRY CHEMICAL, WATER FOG
SPECIAL FIREFIGHTING PROCEDURES
Water should be used to keep fire-exposed containers cool.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers may rupture due to buildup of steam pressure when exposed to
extreme heat such as fire.
========================= SECTION V - REACTIVITY DATA ========================
STABILITY: STABLE
CONDITIONS TO AVOID
None known.
49-150 Page: 2
INCOMPATIBILITY (MATERIALS TO AVOID)
Can react vigorously with strong oxidizing agents, strong lewis and mineral
acids, and strong mineral and organic bases.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS
Thermal decomposition may yield carbon dioxide and/or carbon monoxide.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
===================== SECTION VI - HEALTH HAZARD DATA ========================
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Its use in poorly ventilated areas can cause a slight irritation of the mucous
membrane of the nose, throat and respiratory system.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Short-term contact will result in eye irritation. Prolonged and repeated contact
can cause a drying of the skin and irritation.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
May cause skin irritation.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Adverse health effects from ingestion may include irritation of the throat and
stomach lining. Not expected to be acutely toxic by ingestion.
HEALTH HAZARDS (ACUTE AND CHRONIC)
Acute: May cause eye, nose and skin irritation, headache, nausea and vomiting.
Chronic: Reports have associated repeated and prolonged occupational over-
exposure to solvents with permanent brain and nervous system damage.
CARCINOGENICITY: NTP CARCINOGEN: Yes IARC MONOGRAPHS: Yes OSHA REGULATED: No
This material contains crystalline silica, which has been classified as a known
carcinogen for humans (1) by IARC and a probable carcinogen by NTP. Crystalline
silica is also a known cause of silicosis, a non-cancerous lung disease caused
by excessive exposure to crystalline silica.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Pre-existing eye, skin and respiratory disorders may be aggravated. Persons with
skin or respiratory tract allergies may develop increased symptoms when exposed
to this material.
EMERGENCY AND FIRST AID PROCEDURES
INHALATION: MOVE PERSON TO FRESH AIR. EYE AND SKIN CONTACT: FLUSH EYES WITH
WATER FOR AT LEAST 15 MINUTES. WASH AFFECTED AREAS WITH SOAP AND WATER. REMOVE
CONTAMINATED CLOTHING. INGESTION: IF SWALLOWED, DILUTE BY DRINKING 2 GLASSES OF
WATER. GET MEDICAL ATTENTION IF ANY IRRITATION PERSISTS.
============ SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE =============
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
ABSORB WITH INERT MATERIAL (SAND, VERMICULITE, ETC.), SWEEP OR SCOOP UP AND PUT
IN DISPOSAL CONTAINER. FLUSH AREA OF SPILL WITH WATER.
WASTE DISPOSAL METHOD
Incinerate in an approved incinerator or dispose of in accordance with local,
state and federal regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
COMBUSTIBLE! Close container after each use. Keep away from children.
49-150 Page: 3
OTHER PRECAUTIONS
Do not take internally. Avoid prolonged contact.
====================== SECTION VIII - CONTROL MEASURES =======================
VENTILATION
Local exhaust at point of use in closed spaces.
RESPIRATORY PROTECTION
None required in out-of-doors. Maintain good ventilation in closed spaces.
PROTECTIVE GLOVES
Chemical resistant gloves
EYE PROTECTION
Safety glasses
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Eye bath and safety shower
WORK/HYGIENIC PRACTICES
Wash hands thoroughly before eating or using the washroom. Smoke in smoking
areas only.
==================== SECTION IX - REGULATORY INFORMATION =====================
CALIFORNIA PROPOSITION 65
None
========================== SECTION X - DISCLAIMER ============================
The information contained herein is based on the data available to us and is
believed to be correct. However, Ellis Paint Co. makes no warranty expressed or
implied regarding the accuracy of these data or the results to be obtained from
the use thereof. Ellis Paint Co. assumes no responsibility for injury from the
use of the product described herein.
|