Distributed By: MSDS 080
Invensys Foxboro Foxboro Rev Date: January 2007
Foxboro, MA 02035 U.S.A. Part Number B1271HT
1-866-746-6477 Page 1 of 5
Material Safety Data Sheet
Revision Date: 11/10/2003 Issue date: 11/10/2003
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product name: Item number: 41650
416 Super Bonder庐 Instant Adhesive
Product type: Cyanoacrylate Region: United States
Company address: Contact Information:
Henkel Loctite Corporation Telephone: 860.571.5100
1001 Trout Brook Crossing Emergency telephone: 860.571.5100
Rocky Hill, Connecticut 06067 Internet: www.loctite.com
2. COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous components % ACGIH TLV OSHA PEL OTHER
Ethyl cyanoacrylate 60-100 0.2 ppm TWA None None
7085-85-0
3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
HMIS:
Physical state: Liquid HEALTH: 2
Color: Clear FLAMMABILITY: 2
Odor: Sharp, Irritating PHYSICAL HAZARD: 1
Personal Protection: See Section 8
WARNING: BONDS SKIN IN SECONDS.
MAY CAUSE EYE AND RESPIRATORY IRRITATION.
COMBUSTIBLE LIQUID AND VAPOR.
Relevant routes of exposure: Skin, inhalation, eyes
Potential Health Effects
Inhalation: Exposure to vapors above the established exposure limit results in respiratory irritation which may lead
to difficulty in breathing and tightness in the chest.
Skin contact: Bonds skin in seconds. May cause skin irritation. Cyanoacrylates have been reported to cause
allergic reaction but due to rapid polymerization at the skin surface, an allergic response is rare.
Cyanoacrylates generate heat on solidification. In rare circumstances a large drop will burn the skin.
Cured adhesive does not present a health even if bonded to the skin.
Eye contact: Irritating to eyes. Causes excessive tearing. Eyelids may bond.
Ingestion: Not expected to be harmful by ingestion. Rapidly polymerizes (solidifies) and bonds in mouth. It is
almost impossible to swallow.
Existing conditions aggravated by Eye, skin, and respiratory disorders.
exposure:
See Section 11 for additional toxicological information.
Item number: 41650 Product name: 416 Super Bonder庐 Instant Adhesive
MSDS 080
Part Number B1271HT
Page 2 of 5
4. FIRST AID MEASURES
Inhalation: Remove to fresh air. If discomfort persists seek medical attention.
Skin contact: Do not pull bonded skin apart. Soak in warm soapy water. Gently peel apart using a blunt instrument.
If skin is burned due to the rapid generation of heat by a large drop, seek medical attention. If lips are
bonded, apply warm water to the lips and encourage wetting and pressure from saliva in mouth. Peel
or roll lips apart. Do not pull lips apart with direct opposing force.
Eye contact: Immediately flush with plenty of water for at least 15 minutes. Get medical attention. If eyelids are
bonded closed, release eyelashes with warm water by covering with a wet pad. Do not force eye open.
Cyanoacrylate will bond to eye protein and will cause a lachrymatory effect which will help to debond
the adhesive. Keep eye covered until debonding is complete, usually within 1-3 days. Medical attention
should be sought in case solid particles of polymerized cyanoacrylate trapped behind the eyelid
caused abrasive damage.
Ingestion: Ensure breathing passages are not obstructed. The product will polymerize rapidly and bond to the
mouth making it almost impossible to swallow. Saliva will separate any solidified product in several
hours. Prevent the patient from swallowing any separated mass.
Notes to physician: Surgery is not necessary to separate accidentally bonded tissues. Experience has shown that bonded
tissues are best treated by passive, non-surgical first aid. If rapid curing has caused thermal burns
they should be treated symptomatically after adhesive is removed.
5. FIRE-FIGHTING MEASURES
Flash point: 65潞C (150潞F) to 93.4潞C (200潞F) Tagliabue closed cup
Autoignition temperature: 485掳C (905掳F)
Flammable/Explosive limits-lower %: Not determined
Flammable/Explosive limits-upper %: Not determined
Extinguishing media: Dry powder. Foam. Carbon dioxide.
Special fire fighting procedures: Fire fighters should wear positive pressure self-contained breathing apparatus (SCBA).
Unusual fire or explosion hazards: None
Hazardous combustion products: Trace amounts of toxic and/or irritating fumes may be released and the use of breathing apparatus is
recommended.
6. ACCIDENTAL RELEASE MEASURES
Environmental precautions: Ventilate area. Prevent product from entering the drains.
Clean-up methods: Do not use cloths for mopping up. Flood with water to complete polymerization and scrape off the
floor. Cured material can be disposed of as non-hazardous waste.
庐
MSDS 080
Part Number B1271HT
Page 3 of 5
7. HANDLING AND STORAGE
Handling: Avoid contact with eyes, skin and clothing. Avoid breathing vapor and mist. Wash thoroughly after
handling. Avoid contact with fabric or paper goods. Contact with these materials may cause rapid
polymerization which can generate smoke and strong irritating vapors, and cause thermal burns.
Storage: Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly
closed until ready for use.
Incompatible products: No special restrictions on storage with other products.
For information on product shelf life contact Henkel Loctite Customer Service at (800) 243-4874.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering controls: Use positive down-draft exhaust ventilation if general ventilation is insufficient to maintain vapor
concentration below established exposure limits.
Respiratory protection: Use NIOSH approved respirator if there is potential to exceed exposure limit(s).
Skin protection: Use nitrile gloves and aprons as necessary to prevent contact. Do not use PVC, nylon or cotton.
Eye/face protection: Chemical splash goggles or safety glasses with side shields.
See Section 2 for exposure limits.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Liquid
Color: Clear
Odor: Sharp, Irritating
Vapor pressure: Less than 0.2 mm Hg
pH: Not applicable
Boiling point/range: Greater than 149潞C (300潞F)
Melting point/range: Not determined
Specific gravity: 1.0156 at 25潞C (77潞F)
Vapor density: Approximately 3
Evaporation rate: Not available
Solubility in water: Polymerizes in presence of water
Partition coefficient (n-octanol/water): Not applicable
VOC content: 87.1%; 914.55 grams/liter (EPA Method 24)
10. STABILITY AND REACTIVITY
Stability: Stable under recommended storage conditions.
Hazardous polymerization: Rapid exothermic polymerization will occur in the presence of water, amines, alkalis and alcohols.
Hazardous decomposition products: None
Incompatability: Water, amines, alkalis and alcohols.
Conditions to avoid: Spontaneous polymerization
11. TOXICOLOGICAL INFORMATION
Product toxicity data: Acute oral LD50 >5000mg/kg (rat)(estimated). Acute dermal LD50 >2000mg/kg (rabbit)(estimated).
Carcinogen Status
庐
MSDS 080
Part Number B1271HT
Page 4 of 5
Hazardous components NTP Carcinogen IARC Carcinogen OSHA Carcinogen
Ethyl cyanoacrylate No No No
Literature Referenced Target Organ & Other Health Effects
Hazardous components Health Effects/Target Organs
Ethyl cyanoacrylate Allergen, Irritant, Respiratory
12. ECOLOGICAL INFORMATION
Ecological information: Not known
13. DISPOSAL CONSIDERATIONS
Information provided is for unused product only.
Recommended method of disposal: Dispose of in accordance with Federal, State and local regulations.
EPA hazardous waste number: Not a RCRA hazardous waste.
14. TRANSPORT INFORMATION
U.S. Department of Transportation Ground (49 CFR):
Proper shipping name: Combustible liquids, n.o.s. (Cyanoacrylate ester)
Hazard class or division: 3
Identification number: NA 1993
Packing group: None
Exceptions: (Not more than 450 Liters) Unrestricted
Marine pollutant: None
International Air Transportation (ICAO/IATA):
Proper shipping name: Aviation regulated liquids, n.o.s (Cyanoacrylate ester)
Hazard class or division: 9
Identification number: UN 3334
Packing group: III
Exceptions: (Not more than 500ml) Unrestricted
WaterTransportation (IMO/IMDG):
Proper shipping name: Unrestricted
Hazard class or division: None
Identification number: None
Packing group: None
Marine pollutant: None
庐
MSDS 080
Part Number B1271HT
Page 5 of 5
15. REGULATORY INFORMATION
United States Regulatory Information
TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory.
TSCA 5 (a) (2) SNUR: None.
TSCA 12 (b) Export Notification: None.
CERCLA/SARA Section 302 EHS: None.
CERCLA/SARA Section 311/312: Immediate Health Hazard, Delayed Health Hazard, Fire, Reactive
CERCLA/SARA 313: This product contains the following toxic chemicals subject to the reporting requirements of section
313 of the Emergency Planning and Community Right-To-Know Act of 1986 (40 CFR 372). None.
California Proposition 65: No California Proposition 65 listed chemicals are known to be present.
Canada Regulatory Information
CEPA DSL/NDSL Status: All components are listed on or are exempt from listing on the Domestic Substances List.
WHMIS hazard class: B.3, D.2.B
16. OTHER INFORMATION
This material safety data sheet contains changes from the previous version in sections:
New Material Safety Data Sheet format.
Prepared by: C.J. Michaels, Senior Health & Regulatory Affairs Specialist
DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Loctite
Corporation does not assume responsibility for any results obtained by persons over whose methods Henkel Loctite Corporation has
no control. It is the user's responsibility to determine the suitability of Henkel Loctite's products or any production methods mentioned
herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against
any hazards that may be involved in the handling and use of any of Henkel Loctite Corporation's products. In light of the foregoing,
Henkel Loctite Corporation specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness
for a particular purpose, arising from sale or use of Henkel Loctite Corporation's products. Henkel Loctite Corporation further disclaims
any liability for consequential or incidental damages of any kind, including lost profits.
庐
|