Material Safety Data Sheet
For Health Emergencies: CALL A POISON CONTROL CENTER
For Transportation Emergencies ONLY: Call Chem-Tel
USA, Canada, Puerto Rico, US Virgin Islands: Call 800-255-3924
Outside North America: Call Collect 813-248-0585
Date Prepared
Rev: 21 May 2007
Replaces: 11 May 2007
Section 1 - PRODUCT AND COMPANY IDENTIFICATION
1.1 PRODUCT NAME: Odorless Turpenoid庐 - Turpentine Substitute
1.2 ITEM NUMBER AND SIZES: 1681 - 118ml, 1682 - 236ml, 1683 - 473ml, 1684 - 946ml,
1685 - 3.79l, 1689 - Display Assortment, 974658 鈥? 30ml.
1.3 COMPANY IDENTIFICATION:
Martin/F. Weber Co.
2727 Southampton Road 鈥? Philadelphia, PA 19154 USA
Phone: 215-677-5600 鈥? Fax: 215-677-3336
Email: info@weberart.com 鈥? Web: www.weberart.com
SECTION 2 鈥? COMPOSTION INFORMATION
COMPONENT CAS # MAX. AMOUNT
(% Weight)
Aliphatic Hydrocarbon 8052-41-3 100
SECTION 3 鈥? HAZARDS IDENTIFICATION
3.1 EMERGENCY OVERVIEW
Appearance: Clear liquid
Physical State: Liquid
Odor: Light to negligible petroleum solvent
Hazards of Product: Eye - May cause mild eye irritation. Symptoms include stinging, tearing and redness.
Skin - may cause mild irritation. Prolonged or repeated contact may dry the skin. Symptoms include redness,
burning, drying, cracking of the skin and skin burns. This material may pass into the body through the skin. It is
unlikely that this would result in harmful effects during safe handling and use.
Swallowing - Swallowing large amounts may be harmful. This material can also get into the lungs during
swallowing or vomiting. This can result in lung inflammation and other lung injury
Inhalation - Breathing of vapor or mist is possible. Breathing large amounts may be harmful. Symptoms usually
occur at air concentrations higher than the recommended exposure limits. (See section 8.)
3.2 POTENTIAL HEALTH EFFECTS
EFFECTS OF SINGLE ACUTE OVEREXPOSURE:
Nausea, headache, confusion, instability, weakness, fatigue, vomiting diarrhea, irritation of eyes and chest.
CHRONIC, PROLONGED OR REPEATED OVEREXPOSURE:
Nausea, headache, confusion, instability, weakness, fatigue, vomiting diarrhea, irritation of eyes and chest..
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Preexisting disorders of the following organs (or
organ systems) may be aggravated by exposure to this material: skin, lung (for example, asthma-like conditions.)
3. 3 POTENTIAL ENVIRONMENTAL EFFECTS: n/a
SECTION 4 鈥? FIRST AID PROCEDURES
4.1 INHALATION: If symptoms develop, move individual away from exposure and into fresh air. If symptoms
persist, seek medical attention. If breathing is difficult, administer oxygen. Keep person warm and quiet; seek
immediate medical attention.
4.2 EYE CONTACT: Move from exposure. Wash eyes liberally with water for 10 minutes or more. If symptoms
persist or there is any visual difficulty, seek prompt medical attention.
4.3 SKIN CONTACT: Remove contaminated clothing, Wash exposed area with soap and water. Apply hand
cream to affected areas to minimize drying of skin. If symptoms persist, seek prompt medical attention. Launder
contaminated clothing before reuse.
4.4 SWALLOWING: Call Physician or Poison Control Center immediately. Do not induce vomiting unless so
advised by a physician, medical facility or poison control center. (Aspiration Hazard.) If individual is drowsy or
unconscious, do not give anything by mouth. If possible, do not leave individual unattended.
4.2 NOTES TO PHYSICIAN: This material is an aspiration hazard. Potential danger from aspiration must be
weighed against possible oral toxicity (see section 3 - Swallowing,) when deciding whether to induce vomiting.
SECTION 5 - FIRE FIGHTING MEASURES
5.1 FLAMMABLE PROPERTIES
Identification Number: UN 1263
Flash Point 鈥? Closed Cup: 110潞 F (43潞 C) - 130潞 F (54.4潞 C)
Flash Point 鈥? Open Cup: n/a
Auto-Ignition Temperature: n/a
Flammable Limits in Air: LEL 0.7%, UEL 5.0%
5.2 EXTINGUISHING MEDIA Regular Foam, Carbon Dioxide, Dry Chemical
5.3 EXTINGUISHING MEDIA
TO AVOID Water
5.4 SPECIAL FIRE FIGHTING
PROCEDURES n/a
5.5 SPECIAL PROTECTIVE
EQUIPMENT FOR FIREFIGHTERS Wear a self contained breathing apparatus with a full-face piece
operated in the positive pressure demand mode with appropriate turnout gear and chemical resistant personal
protective equipment. Refer to the personal protective equipment section of this MSDS.
5.6 UNUSUAL FIRE AND
EXPLOSION HAZARDS n/a
5.7 HAZARDOUS COMBUSTION
PRODUCTS May form: Carbon Dioxide (CO2), Carbon Monoxide (CO), various
hydrocarbons.
SECTION 6 鈥? ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Eliminate all sources of ignition, such as
flares, flames, (including pilot lights,) and electrical sparks. Clean up small spills with rags or paper towels. Place
into air-tight metal container for disposal.
SECTION 7 鈥? HANDLING AND STORAGE
7.1 GENERAL HANDLING: Avoid contact with skin. Use exhaust fan to remove vapors and assure adequate
cross ventilation. Do not use near heat, sparks or flame.
7.2 STORAGE: Keep containers closed when not in use. Store containers in a dry well-ventilated area. Keep
from heat, sparks or flame. KEEP OUT OF THE REACH OF CHILDREN.
SECTION 8 鈥? EXPOSURE CONTROLS AND PERSONAL PROTECTION
8.1 EXPOSURE LIMITS: OSHA PEL 500ppm TWA, OSHA VPEL 100ppm TWA,
ACGIH TLV-100ppm.
8.2 PERSONAL PROTECTION:
Respiratory Protection: Not required if adequate cross ventilation is maintained.
Ventilation: Use a local exhaust fan along with fresh air source to avoid vapor
buildup
Eye Protection: Use OSHA approved chemical splash goggles with side shields
Protective Gloves: Wear resistant (Rubber or vinyl) gloves to minimize skin contact.
Other Protective Equipment: Body protection suitable for the work environment
8.3 ENGINEERING CONTROLS: n/a
SECTION 9 鈥? PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Appearance: Transparent colorless liquid
pH: n/a
Solubility in Water (by weight): Negligible < 5%
Odor: Light to negligible petroleum solvent
Flash Point 鈥? Closed Cup: 110潞 F (43潞 C) - 130潞 F (54.4潞 C)
Flash Point 鈥? Open Cup: n/a
Percent Volatiles: 100% - VOC = 758g/l
Boiling Point (760mm Hg): 340 - 400潞 F (171潞 - 204潞 C)
Freezing Point: n/a
Specific Gravity (H2O = 1): 0.758 @16潞C
Vapor Pressure at 20潞C: 2mm Hg @68潞F (16潞C)
Vapor Density (air = 1): 4.9
Evaporation Rate 0.11
(Butyl Acetate = 1):
Melting Point: n/a
Section 10 鈥? STABILITY AND REACTIVITY
10.1 STABILITY / INSTABILITY Stable under ordinary conditions of use and storage
Conditions to Avoid Keep from heat, open flame and sources of ignition
Incompatible Materials Avoid contact with: excessive heat, strong oxidizing agents
10.2 HAZARDOUS
POLYMERIZATION Will not occur
10.3 INHIBITORS / STABILIZERS n/a
SECTION 11 鈥? TOXICOLOGICAL INFORMATION
ACUTE TOXICITY: ACUTE TOXICITY: LD 50 and LC 50 Data
Petroleum Distillates (CAS# 8052-41-3)
Oral LD (rat): >5000mg/kg
Dermal LD (rabbit): >3000mg/kg
Inhalation LC (rat, 4 hour): >5500mg/m3
CHRONIC TOXICITY: n/a
SECTION 12 鈥? ECOLOGICAL INFORMATION
12.1 ENVIRONMENTAL FATE n/a
12.2 ECOTOXICITY n/a
12.3 FURTHER INFORMATION n/a
SECTION 13 鈥? DISPOSAL CONSIDERATIONS
13.1 WASTE DISPOSAL METHOD Dispose of in accordance with local, state and federal regulations
13.2 DISPOSAL CONSIDERATIONS Keep from heat, open flame, sparks and sources of ignition
SECTION 14 鈥? TRANSPORTATION INFORMATION
U.S. D.O.T Ground Transportation: ORM-D Consumer Commodity
Ocean Transportation: Paint Related Material, 3.3, UN 1263, PG III,
Limited Quantity
DO NOT SHIP via air freight without special packaging and
labeling. Contact your air carrier for detailed instructions.
SECTION 15 鈥? REGULATORY INFORMATION
15.1 FEDERAL / NATIONAL n/a
15.2 STATE / LOCAL n/a
15.3 CANADA Class A - Compressed Gas - Does Not Meet Criteria
Class B - Flammable & Combustible Material - B3 Flammable &
Combustible Material - Combustible Liquid
Class C - Oxidizing Material - Does Not Meet Criteria
Class D - Poisonous & Infectious - Division 1 - Does Not Meet Criteria
Class D - Poisonous & Infectious - Division 2 - Does Not Meet Criteria
Class E - Corrosive Material - Does Not Meet Criteria
Class F- Dangerously Reactive Material - - Does Not Meet Criteria
SECTION 16 鈥? OTHER INFORMATION
The information presented here is current as of the date of this Material Safety Data Sheet and is believed to be
accurate but is not warranted to be, whether originating with the company or not. Since use of this information
and the product are not under the control of Martin/F. Weber Company, it is the user's obligation to determine
conditions of safe use, in advance of use, and to carefully read the product label and follow all instructions for
safe use of the product.
|