MATERIAL SAFETY DATA SHEET (MSDS)
24 HOUR EMERGENCY PHONE: CHEMTREC 1-800-424-9300
Effective Date: Sept. 1, 2004 / Supersedes: Jan. 1, 2000 / PAGE 1 OF 2
JBS INDUSTRIES
2550 Henkle Drive - Lebanon, Ohio 45036
TELEPHONE: 1-888-745-0720
SECTION 1 PRODUCT & COMPANY IDENTIFICATION
PRODUCT NAME: ACTION TOUCH-FREE PRODUCT NUMBER: AT-165
LIQUID ALKALINE DETERGENT
PRODUCT DESCRIPTION:
JBS Industries
MANUFACTURER: PHONE: 888-745-0720
2550 Henkle Drive FAX: 513-228-2810
Lebanon, Ohio 45036
SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTS
HAZARDOUS INGREDIENTS: EFFECT CAS# PERCENT
SODIUM HYDROXIDE CORROSIVE TO SKIN & EYES 1310-73-2 0-10
SODIUM METASILICATE CORROSIVE TO EYES 6834-92-0 0-5
TETRASODIUM EDTA SKIN & EYE IRRITANT 64-02-8 0-5
PROPRIETARY SURFACTANT BLEND EYE IRRITANT NOT APPLICABLE 0-20
HAZARDOUS INGREDIENTS: EXPOSURE LIMITS OF INGREDIENTS
OSHA PEL ACGIH TLV
SODIUM HYDROXIDE 2MG/M3 2MG/M3
SODIUM METASILICATE NOT ESTABLISHED NOT ESTABLISHED
TETRASODIUM EDTA NOT ESTABLISHED NOT ESTABLISHED
PROPRIETARY SURFACTANT BLEND NOT ESTABLISHED NOT ESTABLISHED
SECTION 3 HEALTH HAZARD DATA
SPECIAL NOTE: MSDS data pertains to the product as dispenses from the container. Adverse health effects would not be expected under
recommended conditions of use (diluted) so long as recommended safety precautions are practiced.
ACUTE EFFECTS OF OVEREXPOSURE: Corrosive on contact. Overexposure will produce tissue destruction particularly on mucuos membranes
of eyes, mouth, and respiratory tract. Eye contact may produce severe irritation and blindness unless immediately flushed. Concentrated solutions may
produce immediate skin damage. Skin contact with dilute solutions may produce severe irritation which intensifies as contact continues. Inhalation of
mists may produce severe nasal and respiratory irritation or permanent damage. Ingestion will produce tissue damage of the gastrointestinal tract.
Ingredients in this product may aggravate existing skin, eye, or respiratory disorders.
CHRONIC EFFECTS OF OVEREXPOSURE: Repeated or prolonged exposure of skin can produce chronic dermatitis characterized by redness,
scaling, and blistering. Repeated exposure to spray mists may lead to chronic eye inflammation, chronic respiratory tract irritation or lung damage. None
of the ingredients are listed as carcinogens by IARC, NTP, or OSHA.
SECTION 4 FIRST AID MEASURES
EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES, OCCASIONALLY LIFTING UPPER AND LOWER
EYELIDS. GET IMMEDIATE MEDICAL ATTENTION.
SKIN: RINSE WELL WITH WATER. REMOVE CONTAMINATED CLOTHING. GET IMMEDIATE MEDICAL
ATTENTION.
INGESTION: GIVE WATER TO DRINK IF CONSCIOUS. DO NOT INDUCE VOMITING. GET IMMEDIATE MEDICAL
ATTENTION.
INHALATION: MOVE TO FRESH AIR AT ONCE. GET IMMEDIATE MEDICAL ATTENTION.
SECTION 5 FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES: FLASH POINT: NONE
METHOD USED: NOT APPLICABLE
PRODUCT WILL NOT BURN. NO KNOWN HAZARDOUS DECOMPOSITION PRODUCTS.
UNUSUAL FIRE & EXPLOSION HAZARDS: UPON CONTACT WITH DUSTS OF AL, SN, OR ZN, MAY PRODUCE
HYDROGEN GAS, WHICH IS FLAMMABLE.
FIRE FIGHTING PROCEDURES: APPROPRIATE FOR SURROUNDING MATERIALS.
SECTION 6 ACCIDENTAL RELEASE MEASURES
SPILLS & LEAKS: SMALL SPILLS: RINSE TO DRAIN.
LARGE SPILLS: CONTAIN FOR RECLAMATION OR DISPOSAL.
CAUTION: SPILLS OF THIS MATERIAL MAY CAUSE FLOOR TO BECOME SLIPPERY.
SECTION 7 HANDLING & STORAGE
STORE IN ORIGINAL CONTAINER AT TEMPERATURES BELOW 120 DEGREES F.
PRODUCT IS BEST WHEN USED WITHIN 6 MONTHS OF DATE OF PURCHASE.
SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Introductory Remarks: These recommendations provide general guidance for handling this product. Because specific work environments and
material handling practices vary, safety procedures should be developed for each intended application. While developing safe handling procedures, do
not overlook the need to clean equipment and piping systems for maintenance and repairs. Waste resulting from these procedures should be handled in
accordance with Section 13: Disposal Considerations.
EYES: WEAR CHEMICAL GOGGLES.
SKIN: NEOPRENE GLOVES. RUBBER APRON IF GREATER EXPOSURE IS LIKELY.
RESPIRATORY: GOOD GENERAL VENTILATION. RESPIRATOR NOT NORMALLY REQUIRED.
MSDS - JBS INDUSTRIES (CONT.) ACTION TOUCH-FREE PAGE 2 OF 2
SECTION 9 PHYSICAL & CHEMICAL PROPERTIES
APPEARANCE & ODOR: BLUE, THIN LIQUID WITH CHARACTERISTIC ODOR.
SOLUBILITY IN WATER: COMPLETE
% VOLATILE (W/W): >65, MOSTLY WATER FREEZING POINT: NEAR WATER.
PH FULL STRENGTH: 13.5 SPECIFIC GRAVITY: 1.11
SECTION 10 STABILITY & REACTIVITY
STABILITY: THIS IS A STABLE MATERIAL.
CONDITIONS TO AVOID: NONE KNOWN.
MATERIALS TO AVOID: STRONG ACIDS, DUSTS OF ALUMINUM, TIN AND ZINC.
HAZARDOUS POLYMERIZATION WILL NOT OCCUR.
SECTION 11 TOXICOLOGICAL INFORMATION
NO DATA AVAILABLE ON THIS MIXTURE. FOR INFORMATION ON INGREDIENTS, WRITE TO THE ADDRESS LISTED IN
SECTION 1 OF THIS MSDS.
SECTION 12 ECOLOGICAL INFORMATION
NO DATA AVAILABLE ON THIS MIXTURE. ALL SURFACTANT COMPONENTS ARE BIODEGRADABLE. THIS PRODUCT
CONTAINS NO PHOSPHATES.
SECTION 13 DISPOSAL CONSIDERATIONS
FOLLOW ALL FEDERAL, STATE, AND LOCAL REGULATIONS APPROPRIATE FOR THIS MATERIAL. NEUTRALIZE PH WITH
DILUTED ACID BEFORE DISPOSAL.
SECTION 14 TRANSPORTATION INFORMATION
D.O.T. HAZARDOUS MATERIAL CLASS: SODIUM HYDROXIDE SOLUTION, CLASS 8, PG II
UN NUMBER: UN1824 NA NUMBER: NOT APPLICABLE
SECTION 15 REGULATORY INFORMATION
FACILITIES STORING MORE THAN 38,000 GALLONS OF THIS MATERIAL MUST FILE A SARA TITLE III FOR SODIUM HYDROXIDE.
SECTION 16 OTHER INFORMATION
***HAZARD RATINGS PROVIDED FOR USE BY TRAINED INDIVIDUALS ONLY.***
HMIS RATINGS (0=MINIMAL, 1=SLIGHT, 2=MODERATE, 3=SERIOUS, 4=SEVERE HAZARD)
FOR CONCENTRATE: HEALTH: 3 FLAMMABILITY: 0 REACTIVITY: 0
NFPA RATINGS (0=MINIMAL, 1=SLIGHT, 2=MODERATE, 3=SERIOUS, 4=SEVERE HAZARD)
FOR CONCENTRATE: HEALTH: 3 FLAMMABILITY: 0 REACTIVITY: 0
DILUTION OVER 30 TO 1: HEALTH: 2 FLAMMABILITY: 0 REACTIVITY: 0
The information relates to this specific material. It may not be valid for this material if used in combination with
any other materials or in any process. JBS Industries makes no warranty, express or implied as to the accuracy
or completeness or adequacy of information herein, except that such information is to the best of JBS Industries'
belief, accurate as of the date indicated. JBS Industries assumes no responsibility for injury from the use of the
product described herein.
JBS INDUSTRIES a Division of Mix Masters, Inc. 2550 HENKLE DRIVE LEBANON, OH 45036, 888-745-0720
|