MATERIAL SAFETY DATA SHEET (MSDS)
24 HOUR EMERGENCY PHONE: CHEMTREC 1-800-424-9300
Effective Date: Sept. 1, 2004 / Supersedes: Jan. 1, 2000 / PAGE 1 OF 2
JBS INDUSTRIES
2550 Henkle Drive - Lebanon, Ohio 45036
TELEPHONE: 1-888-745-0720
SECTION 1 PRODUCT & COMPANY IDENTIFICATION
PRODUCT NAME: HB SPRAY SHINE PC PRODUCT NUMBER: PC-250
LIQUID RINSE AGENT
PRODUCT DESCRIPTION:
JBS Industries
MANUFACTURER: PHONE: 888-745-0720
2550 Henkle Drive FAX: 513-228-2810
Lebanon, Ohio 45036
SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTS
HAZARDOUS INGREDIENTS: EFFECT CAS# PERCENT
2-BUTOXYETHANOL EYE IRRITANT 111-76-2 0-20
QUATERNARY AMINE &
CORROSIVE TO EYES 61789-77-3 0-80
MINERAL OIL MIXTURE
HAZARDOUS INGREDIENTS: EXPOSURE LIMITS OF INGREDIENTS
OSHA PEL ACGIH TLV
2-BUTOXYETHANOL 25 PPM 25 PPM
QUATERNARY AMINE &
MINERAL OIL MIXTURE 400 400
SECTION 3 HAZARDS IDENTIFICATION
>>>>>>>>>>>>>>>>>>>>EMERGENCY OVERVIEW<<<<<<<<<<<<<<<<<<<
CAN BE CORROSIVE TO EYES. INHALATION OF MISTS MAY BE IRRITATING TO THROAT AND RESPIRATORY TRACT. MAY
CAUSE IRRITATION TO SKIN WITH PROLONGED EXPOSURE.
>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
SECTION 4 FIRST AID MEASURES
EYES: FLUSH WITH CLEAR WATER FOR AT LEAST 15 MINUTES. GET IMMEDIATE MEDICAL ATTENTION.
SKIN: RINSE WELL WITH SOAP AND WATER. REMOVE CONTAMINATED CLOTHING.
INGESTION: GIVE WATER IF CONSCIOUS. DO NOT INDUCE VOMITING, ALTHOUGH VOMITING MAY OCCUR
NATUARALLY. GET IMMEDIATE MEDICAL ATTENTION.
INHALATION: MOVE TO FRESH AIR. IF IRRITATION PERSISTS, GET MEDICAL ATTENTION.
SECTION 5 FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES: FLASH POINT: NOT DETERMINED
METHOD USED: NOT APPLICABLE
PRODUCT IS MOSTLY WATER AND WILL NOT BURN. INCOMPLETE COMBUSTION OF VAPORS MAY PRODUCE
CARBON MONOXIDE, WHICH IS POISONOUS.
UNUSUAL FIRE & EXPLOSION HAZARDS: NONE KNOWN
FIRE FIGHTING PROCEDURES: APPROPRIATE FOR SURROUNDING MATERIALS.
SECTION 6 ACCIDENTAL RELEASE MEASURES
SPILLS & LEAKS: SMALL SPILLS: RINSE TO DRAIN.
LARGE SPILLS: CONTAIN FOR RECLAMATION OR DISPOSAL.
CAUTION: SPILLS OF THIS MATERIAL MAY CAUSE FLOOR TO BECOME SLIPPERY.
SECTION 7 HANDLING & STORAGE
STORE IN ORIGINAL CONTAINER AT TEMPERATURES BELOW 120 DEGREES F.
PRODUCT IS BEST WHEN USED WITHIN 6 MONTHS OF DATE OF PURCHASE.
SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
EYES: WEAR CHEMICAL GOGGLES.
SKIN: NEOPRENE GLOVES. RUBBER APRON IF GREATER EXPOSURE IS LIKELY.
RESPIRATORY: GOOD GENERAL VENTILATION. RESPIRATOR NOT NORMALLY REQUIRED.
MSDS - JBS INDUSTRIES (CONT.) HB SPRAY SHINE PC PAGE 2 OF 2
SECTION 9 PHYSICAL & CHEMICAL PROPERTIES
APPEARANCE & ODOR: THIN RED LIQUID WITH CHERRY SCENT.
SOLUBILITY IN WATER: EMULSION
% VOLATILE (W/W): >80 MOSTLY MINERAL OIL FREEZING POINT: N/A
PH FULL STRENGTH: 6.0 SPECIFIC GRAVITY: 1.00
SECTION 10 STABILITY & REACTIVITY
STABILITY: THIS IS A STABLE MATERIAL.
CONDITIONS TO AVOID: NONE KNOWN.
MATERIALS TO AVOID: STRONG OXIDIZING AGENTS.
HAZARDOUS POLYMERIZATION WILL NOT OCCUR.
SECTION 11 TOXICOLOGICAL INFORMATION
NO DATA AVAILABLE ON THIS MIXTURE. FOR INFORMATION ON INGREDIENTS, WRITE TO THE ADDRESS LISTED IN
SECTION 1 OF THIS MSDS.
SECTION 12 ECOLOGICAL INFORMATION
NO DATA AVAILABLE ON THIS MIXTURE. ALL SURFACTANT COMPONENTS ARE BIODEGRADABLE. THIS PRODUCT
CONTAINS NO PHOSPHATES.
SECTION 13 DISPOSAL CONSIDERATIONS
FOLLOW ALL FEDERAL, STATE, AND LOCAL REGULATIONS APPROPRIATE FOR THIS MATERIAL.
SECTION 14 TRANSPORTATION INFORMATION
D.O.T. HAZARDOUS MATERIAL CLASS: NOT A D.O.T. HAZARDOUS MATERIAL.
UN NUMBER: NOT APPLICABLE NA NUMBER: NOT APPLICABLE
SECTION 15 REGULATORY INFORMATION
THIS MATERIAL IS NOT SARA TITLE III REPORTABLE.
SECTION 16 OTHER INFORMATION
***HAZARD RATINGS PROVIDED FOR USE BY TRAINED INDIVIDUALS ONLY.***
HMIS RATINGS (0=MINIMAL, 1=SLIGHT, 2=MODERATE, 3=SERIOUS, 4=SEVERE HAZARD)
FOR CONCENTRATE: HEALTH: 2 FLAMMABILITY: 0 REACTIVITY: 0
NFPA RATINGS (0=MINIMAL, 1=SLIGHT, 2=MODERATE, 3=SERIOUS, 4=SEVERE HAZARD)
FOR CONCENTRATE: HEALTH: 2 FLAMMABILITY: 0 REACTIVITY: 0
DILUTION OVER 30 TO 1: HEALTH: 1 FLAMMABILITY: 0 REACTIVITY: 0
The information relates to this specific material. It may not be valid for this material if used in combination with
any other materials or in any process. JBS Industries makes no warranty, express or implied as to the accuracy
or completeness or adequacy of information herein, except that such information is to the best of JBS Industries'
belief, accurate as of the date indicated. JBS Industries assumes no responsibility for injury from the use of the
product described herein.
JBS INDUSTRIES a Division of Mix Masters, Inc. 2550 HENKLE DRIVE LEBANON, OH 45036, 888-745-0720
|