Product # (s) 7449_________
MATERIAL SAFETY DATA SHEET
Section I 鈥? Product Information
Product Name or Identity: Brilliant Green Bile Agar
Acumedia Manufacturers, Inc. 517/372-9200
Manufacturer鈥檚 Name: Emergency Phone No.:
740 East Shiawassee 517/372-2006
Fax No.:
Lansing, Michigan 48912 foodsafety@neogen.com
e-mail:
Date Prepared or Revised: 01/31/07
Section II 鈥? Hazardous Ingredients / Identity Information
Hazardous Components: OSHA PEL ACGIH TLV Toxicity Data LD50
(Specific Chemical Identity: Common (Permissible (Threshold Limit
Names) Exposure Limits) Value)
Sodium Sulfite TWA N/A ORL RAT, 820 mg/kg
5 ppm
Basic Fuchsin N/A N/A N/A
Section III 鈥? Physical Characteristics
Specific Gravity (H2O = 1): 2.63 g/cm3 (Sodium Sulfite),
Boiling Point: N/A
1.22 g/cm3 (Basic Fuchsin)
Vapor Pressure (mm Hg.): N/A Melting Point: 250掳C (Basic Fuchsin)
Vapor Density (AIR = 1): N/A Evaporation Rate (Butyl Acetate = 1): N/A
Solubility in Water: 1M completely soluble at 20掳C (Sodium Sulfite)
Appearance and Odor: White crystals, odorless (Sodium Sulfite), Deep green, powder (Basic Fuchsin)
Section IV 鈥? Fire and Explosion Hazard Data
Flash Point (Method Used): Not applicable Flammable Limits: LEL (Lower Explosive Limit) - N/A
UEL (Upper Explosive Limit) - N/A
Extinguishing Media: Suitable extinguishing agents. CO2, extinguishing powder, or water spray.
Special Fire Fighting Procedures: Fight larger fires with water or alcohol resistant foam. Firefighters should wear
protective equipment and self-contained breathing apparatus.
Unusual Fire and Explosion Hazards: During heating or in case of fire, poisonous gases are produced.
Section V 鈥? Reactivity Data
Unstable Conditions to Avoid: Stable under ordinary conditions of use and storage. Heat and
Stability:
moisture contribute to instability. May air-oxidize.
Stable X
Incompatibility (Materials to Avoid): Strong acids, strong oxidizing agents and high temperatures.
Hazardous Decomposition or Byproducts: Burning may produce Sulfur oxides, Carbon monoxide, Carbon dioxide,
Nitrogen oxides, and Hydrogen chloride gas.
May Occur Conditions to Avoid: Heat, moisture, and incompatible materials.
Hazardous
Polymerization:
Will Not Occur X
Page 1 of 2
Product # (s) 7449________
Section VI 鈥? Health Hazard Data
Inhalation? N/A Skin? N/A Ingestion? N/A
Route(s) of Entry:
Harmful. Harmful if swallowed, inhaled, or absorbed through skin. May cause allergic reaction and
Health Hazards:
breathing difficulties to sensitive individuals. May cause irritation to skin, eyes, and respiratory
(Acute and Chronic)
tract.
Carcinogenicity: NTP? No IARC Monographs? (International Agency for Research in Cancer) OSHA Regulated? No
(National Toxicology Program) Group 3 (Sodium Selenite)
The agent is not classifiable as to carcinogenicity in humans.
Group 2B (Basic Fuchsin)
This agent is possibly carcinogenic to humans.
Signs and Symptoms of Exposure: Inhalation of dust may cause irritation to the mucous membranes of the upper
respiratory tract. May cause gastric irritation by the liberation of sulfurous acid. May cause irritation, redness, and pain to
the eye. Large doses may result in circulatory disturbances, diarrhea, and central nervous system depression.
Medical Conditions Generally Aggravated by Exposure: Although only moderately toxic in large amounts, sulfites
can pose risk to some asthmatics producing central nervous system depression, bronchconstriction and anaphylaxis.
Basic Fuchsin is a possible carcinogen.
Ingestion: If swallowed, wash out mouth with water provided person is conscious. Seek medical
Emergency /
attention immediately.
First Aid
Procedures: Inhalation: Supply fresh air or oxygen. In case of unconsciousness, place patient on side position for
transportation. Seek medical attention.
Eye Contact: Rinse opened eye for at least 15 minutes under running water. Assure adequate flushing
by separating the eyelids with fingers. Seek medical attention.
Skin Contact: Immediately wash with plenty of soap and water for at least 15 minutes. Seek medical
attention.
Section VII 鈥? Precautions for Safe Handling and Use
Accidental Release Measures: Ventilate area and wash spill site after material is picked up and evacuated. Wear
protective clothing, and discard after use. Exercise appropriate precautions to minimize direct contact with skin or eyes.
Prevent inhalation of dust. Wash contaminated clothing before reuse.
Waste Disposal Method: Dispose in accordance with all applicable federal, state, and local environmental regulations.
Handling and Storing: Keep container tightly closed. Protect from physical damage. Store in a cool, dry, ventilated area
away from sources of heat, moisture, and incompatibilites. Containers of this material may be hazardous when empty
since they retain product residues.
Other Precautions: Air and moisture sensitive. Do not breathe dust. Avoid contact with eyes, skin, and clothing. Ensure
good ventilation / exhaustion at the workplace. Avoid prolonged or repeated exposure.
Section VIII 鈥? Control Measures
Respiratory Protection (Specify Type): None required where adequate ventilation conditions exist.
Local Exhaust: 50 鈥? 100 CFM Special: N/A
Ventilation:
Mechanical (General): N/A Other: N/A
Protective Gloves: Proper disposable gloves Eye Protection: Chemical resistant safety goggles
Other Protective Clothing or Equipment: Uniform, lab coat, or disposable lab wear.
Work / Hygienic Practices: Follow the usual precautionary measures associated with inert powders. Keep away from
food and beverages. Immediately remove all soiled and contaminated clothing. Avoid contact with eyes, skin, and
clothing.
This document is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide.
Acumedia Manufacturers, Inc. shall not be held liable for any damage resulting from handling or from contact with the
above product. These suggestions should not be confused with state, municipal or insurance requirements, and constitute
NO WARRANTY.
Page 2 of 2 Rev 01, 01/07
|