MSDS
庐 Date of Issue:
ZP RODENT BAIT (AG) AUGUST 1995
EMERGENCY PHONE: NO.:
TELEPHONE NO.:
MANUFACTURERS ADDRESS: Prepared by: Contact your local
BELL LABORATORIES INC.
(608) 241-0202
VJD
3699 KINSMAN BLVD. MADISON WI 53704 Poison Control Center
CAS NO.:
PRODUCT NAME:
1314-84-7
ZP庐RODENT BAIT AG
CHEMICAL NAME & SYNONYMS:
CHEMICAL FAMILY:
Zinc Phosphide
Inorganic
TRADE NAME & SYNONYMS:
CHEMICAL FORMULA:
Zinc Phosphide
Zn3 P2
SECTION I. HAZARDOUS INGREDIENTS
% CURRENT TLV
ACTlVE INGREDIENTS:
N.E.
2.0
Zinc Phosphide
SECTION II. PHYSICAL DATA OF ACTIVE INGREDIENT
SPECIFIC GRAVITY:
MELT POINT:
APPEARANCE & ODOR: MOLECULAR WEIGHT:
420掳C
Crystalline powder, 4.55 gm/ml
258.09
garlic-like odor.
BOILlNG POINT:
BULK DENSITY:
VAPOR DENSlTY (AR=l): COLOR:
1100掳C
NA
Grey powder
NA
EVAPORATION RATE:
WATER REACTIVE:
SOLUBILITY.
VAPOR PRESSURE:
NA
Insoluble in water. NA
NA
SECTION III. FIRE & EXPLOSION DATA OF PRODUCT
AUTOIGNITION TEMP.:
FLAMMABLE LIMIT:
FLASH POINT F (METHOD USED):
NA NA
NA
EXTINGUISHING MEDIA:
Extinguish with water, foam or inert gas.
SPECIAL FIRE FIGHTING PROCEDURES:
None
UNUSUAL FIRE OR EXPLOSlON HAZARDS:
Avoid contact with acids.
SECTION IV. REACTIVITY HAZARD DATA OF ACTIVE INGREDIENT
CONDITIONS TO AVOID:
STABILITY:
Keep dry and away from acids.
Stable.
CONDITIONS TO AVOID:
POLYMERIZATION:
NA
Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS:
INCOMPATABlLlTY (MATERIALS TO AVOID):
Phosphine gas.
Oxidizing agents and acids.
S E C T I O N V. TOXICITY DATA
INHALATION:
LD50, DERMAL (SKIN CON TACT): (94% AI)
LD50, ORAL (INGESTION): (2% AI)
LC50(10% AI) >19.6 mg/l of air.
[Rabbit] 2000-5000 mg/kg
[Rat] 1375 mg/kg
OTHER:
FISH, LC50 (LETHAL CONCENTRATION): SKIN IRRITATION:
(94% AI) [Rainbow trout] 0.5 mg/kg NE
Not considered to be an irritant.
[Blue gill] 0.8 mg/kg
SECTION VI. HEALTH HAZARD DATA OF PRODUCT
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
PRIMARY ROUTE OF ENTRY: SIGNAL WORD:
Ingestion Skin & Eye contact
CAUTION
None
Inhalation Skin absorption
HEALTH HAZARDS: SIGNS AND SYMPTOMS OF EXPOSURE:
1- Caution: May be irritating. Nausea, abdominal pain, tightness in chest, chills.
EMERGENCY FIRST AID PROCEDURES:
Any persons applying zinc phosphide products and experiencing signs and symptoms such as nausea, abdominal pain, tightness in the chest, or weakness, should be
seen by a physician immediately.
IF SWALLOWED: Immediately call a Poison Control Center or physician, or transport the patient to the nearest hospital. Do not drink water. Do not administer
anything by mouth or make the patient vomit unless adivsed to do so by a physician.
IF IN EYES: Flush with plenty of water. Get medical attention if irritation persists.
IF ON SKIN: Remove contaminated clothing and wash affected areas with soap and water.
SPECIAL PROTECTION INFORMATION:
Wash hands thoroughly after use.
SECTION VII. CONTROL & PROTECTIVE MEASURES OF PRODUCT
RESPIRATOR TYPE:
None
VENTILATION:
GLOVES:
EYE PROTECTION:
None
Rubber Gloves
None
OTHER PROTECTIVE MEASURES:
None
SECTION VIII. SPILL OR LEAK PROCEDURES OF PRODUCT
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
General clean-up.
WASTE DISPOSAL METHOD:
If waste cannot be disposed of by use according to label instruction, contact your State Pesticide or Environmental
Control Agency, or the Hazardous Waste Representative at the nearest EPA Regional Office for guidance.
SECTION IX. SPECIAL PRECAUTIONS & STORAGE DATA OF PRODUCT
AVERAGE SHELF LlFE:
STORAGE TEMPERATURE:
Under exposed acid free conditions, will remain active for long periods of time.
Room temperature.
SPECIAL SENSITIVITY (HEAT, LIGHT, MOISTURE):
Stable under dry conditions.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
Avoid acidic conditions - in presence of dilute acids, phosphine gas is liberated.
SECTION X. SHIPPING DATA OF PRODUCT
D.O.T. SHIPPING NAME: TECHNICAL SHIPPING NAME:
Rodenticide containing Zinc Phosphide
ZP Rodent Bait (AG)
D.O.T. HAZARD CLASSIFICATION:
Non-hazardous
FREIGHT CLASSIFICATION:
D.O.T. LABELS REQUIRED:
Class 60
None
WARRANTY
The information provided in this Material Safety Data Sheet has been obtained from sources believed to be reliable. Bell Labs provides no warranties,
either expressed or implied and assumes no responsibility for the accuracy or completeness of the data contained herein. This information is offered
for your consideration and investigation. You should satisfy yourself that you have all current data relevant to your particular use.
|