**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 21324-39-0 |Sodium Hexafluorophosphate | 98.5+% | 244-333-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Hygroscopic (absorbs
moisture from the air).
Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
Causes respiratory tract irritation. The toxicological properties of
this substance have not been fully investigated. Can produce delayed
pulmonary edema.
Chronic:
Effects may be delayed.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If breathing
is difficult, give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation. If breathing has ceased apply artificial respiration
using oxygen and a suitable mechanical device such as a bag and a
mask.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Runoff from
fire control or dilution water may cause pollution.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Minimize dust generation and accumulation. Avoid breathing dust,
vapor, mist, or gas. Avoid contact with eyes, skin, and clothing.
Keep container tightly closed. Avoid ingestion and inhalation. Use
with adequate ventilation. Use only in a chemical fume hood. Wash
clothing before reuse.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from moisture.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 21324-39-0:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Crystalline powder
Color: white - beige grey
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 450 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: 450 deg C
Solubility in water: soluble in water
Specific Gravity/Density: 2.3690g/cm3
Molecular Formula: NaPF6
Molecular Weight: 167.95
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
High temperatures, incompatible materials, dust generation, acids,
excess heat, strong oxidants, heating to decomposition, exposure to
moist air or water.
Incompatibilities with Other Materials:
Oxidizing agents, acids, moisture.
Hazardous Decomposition Products:
Phosphine, oxides of phosphorus, irritating and toxic fumes and
gases, hydrogen fluoride gas.
Hazardous Polymerization: Will not occur.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 21324-39-0 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Sodium Hexafluorophosphate -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 21324-39-0: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 21324-39-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 21324-39-0 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #5 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
S-(4-Chlorobenzyl)-Thiuronium Chloride, 99+%
| 544-47-8 |
|
N-Formyl-4-(Methylamino)Benzoic Acid
| 51865-84-0 |
|
2,5-Dibromo-4-fluorotoluene
| |
|
Ammonium-d4 deuteroxide, 26 wt % solution in D2O, 99+ atom % D
| 1336-21-6 |
|
3,4-Dihydroxybenzoic Acid, 97%
| 99-50-3 |
|
d-Erythruronolactone acetonide, 95+% (nmr)
| 85254-46-2 |
|
1-Phenyloctane, 99%
| 2189-60-8 |
|
N,N-Dimethyl-M-Phenylenediamine Dihydro-Chloride, 99%
| 3575-32-4 |
|
5-Methyl-5-phenylhydantoin, 99%
| 6843-49-8 |
|
Sodium Hexafluorophosphate, 98.5+%
| 21324-39-0 |
|
Allylurea, 95%
| 557-11-9 |
|
Methyl Trimethylacetate, 99%
| 598-98-1 |
|
m-Anisaldehyde, 97%
| 591-31-1 |
|
Cyclopentadienyltitanium Trichloride
| 1270-98-0 |
|
Erioglaucine disodiumsalt (c.i. 42090)
| 3844-45-9 |
|
Cyclopentadienylsodium (18% in tetrahydrofuran)
| 109-99-9 |
|
Methyl morpholinoacetate, 99+%
| |
|
Thiobenzoic Acid, 90-95%
| 98-91-9 |
|
DL-Serine Methyl Ester Hydrochloride, 99%
| 5619-04-5 |
|
Dl-3,4-dihydroxyphenylglycol
| 28822-73-3 |
|
4-Tert.-butylcyclohexanol, 99%, mixture of isomers
| 98-52-2 |
|
2-Amino-6-Purinethiol, 95%
| 154-42-7 |
|
3-Nitrobenzonitrile, 98%
| 619-24-9 |
|
Direct Blue 71
| 4399-55-7 |
|
4,4'-Sulfonylbis-(Methylbenzoate) Tech.
| 3965-53-5 |
|
5-Chloro-2-Nitroaniline, 97%
| 1635-61-6 |
|
N-Methyl-o-toluidine
| 611-21-2 |
|
2',3'-O-Isopropylideneuridine, 99%
| 362-43-6 |
|
1-Bromo-2,4-difluorobenzene, 99%
| 348-57-2 |
|
2,2-Dimethylglutaric Acid, 98+%
| 681-57-2 |
|
Methyl Benzoylformate, 99%
| 15206-55-0 |
|
1,4-Dibromobenzene, 99%
| 106-37-6 |
|
2',4'-Dichloroacetophenone, 94%
| 2234-16-4 |
|
Formamidinesulfinic Acid, 99%
| 1758-73-2 |
|
2-Naphthalenesulfonic acid sodium salt, 99+% (uv-vis)
| 532-02-5 |
|
2,4,6-Tribromoaniline, 98%
| 147-82-0 |
|
3-(Diethylamino)-1,2-Propanediol, 98%
| 621-56-7 |
|
Diallyl phthalate, 98%
| 131-17-9 |
|
Triethyl 1,1,2-Ethanetricarboxylate, 99%
| 7459-46-3 |
|
3-Amino-3-phenylpropionic acid
| |
|
Trans-2-Hydroxymethyl-1-Cyclohexylamine Hydrochloride, 99+%
| 28250-45-5 |
|
2-Chlorobenzamide, 98%
| 609-66-5 |
|
(D)-(+)-Threitol, 98%
| 2418-52-2 |
|
Magnesium Cyclohexanebutyrate
| 62669-64-1 |
|
d-Isoproterenol d-bitartrate
| 14638-70-1 |
|
3'-Isothiocyanatoacetanilide
| 3137-83-5 |
|
Phenyl sulfone, 97%
| 127-63-9 |
|
o-Neopentyl-s-triphenylstannyl xanthate
| 143037-51-8 |
|
DL-Alpha-Methyltryptamine, 99%
| 299-26-3 |
|
3-Buten-1-ol, 96%
| 627-27-0 |
|
|