Search   
MSDS 
:
 Acrolein dimethyl acetal, 99%
CAS 
:
 6044-68-4
SYNONYMS 
:
 3,3-Dimethoxy-1-propene.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 6044-68-4 |3,3-Dimethoxypropene | 99 | 227-936-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: T+ F
Risk Phrases: 11 23/25 27 33

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Highly flammable. Toxic by inhalation and if swallowed. Very toxic
in contact with skin. Danger of cumulative effects.

Potential Health Effects
Eye:
May cause eye irritation. May cause chemical conjunctivitis and
corneal damage.
Skin:
May cause irritation and dermatitis. May cause cyanosis of the
extremities.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated. Ingestion of large amounts may cause CNS
depression.
Inhalation:
The toxicological properties of this substance have not been fully
investigated. Aspiration may lead to pulmonary edema. Vapors may
cause dizziness or suffocation. May cause burning sensation in the
chest.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. During a
fire, irritating and highly toxic gases may be generated by thermal
decomposition or combustion. Will burn if involved in a fire. Use
water spray to keep fire-exposed containers cool. Water may be
ineffective. Material is lighter than water and a fire may be spread
by the use of water. Containers may explode in the heat of a fire.
Flammable liquid and vapor. Vapors may be heavier than air. They
can spread along the ground and collect in low or confined areas.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Water may be ineffective. Use agent most appropriate to
extinguish fire. Do NOT use straight streams of water.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. Provide ventilation. A
vapor suppressing foam may be used to reduce vapors.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Ground and bond containers when transferring material. Use
spark-proof tools and explosion proof equipment. Avoid contact with
eyes, skin, and clothing. Empty containers retain product residue,
(liquid and/or vapor), and can be dangerous. Keep container tightly
closed. Keep away from heat, sparks and flame. Avoid ingestion and
inhalation. Do not pressurize, cut, weld, braze, solder, drill,
grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
Flammables-area.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate general or
local explosion-proof ventilation to keep airborne levels to
acceptable levels.
Exposure Limits
CAS# 6044-68-4:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear, colorless
Odor: acetic odor
pH: Not available.
Vapor Pressure: 114 mbar @ 21 C
Viscosity: 0.48 MPA 25.00 deg
Boiling Point: 89.0 - 90.0 deg C @ 760.00mm
Freezing/Melting Point: Not available.
Autoignition Temperature: 260 deg C ( 500.00 deg F)
Flash Point: -9 deg C ( 15.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Slightly soluble.
Specific Gravity/Density: .8620g/cm3
Molecular Formula: C5H10O2
Molecular Weight: 102.13

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat.
Incompatibilities with Other Materials:
Acids, moisture, strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 6044-68-4: UC8500000
LD50/LC50:
Not available.
Carcinogenicity:
3,3-Dimethoxypropene -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Other
No information available.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: TOXIC LIQUID, FLAMMABLE, ORGANIC, N.O.S.*
Hazard Class: 6.1 (3)
UN Number: 2929
Packing Group: I
IMO
Shipping Name: TOXIC LIQUID, FLAMMABLE, ORGANIC, N.O.S.
Hazard Class: 6.1 (3)
UN Number: 2929
Packing Group: I
RID/ADR
Shipping Name: TOXIC LIQUID, FLAMMABLE, ORGANIC, N.O.S.
Hazard Class: 6.1
UN Number: 2929
Packing group: I

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: T+ F
Risk Phrases:
R 11 Highly flammable.
R 23/25 Toxic by inhalation and if swallowed.
R 27 Very toxic in contact with skin.
R 33 Danger of cumulative effects.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
S 27 Take off immediately all contaminated clothing.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 6044-68-4: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 6044-68-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 6044-68-4 is not listed on the TSCA inventory.
It is for research and development use only.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/02/1997 Revision #6 Date: 4/11/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
L-Ascorbic acid 50-81-7
L-Asparagine Monohydrate 5794-13-8
L-Tryptophan 73-22-3
L-Tyrosine 60-18-4
L-Methionine 63-68-3
Methyl 5-oxazolecarboxylate, 96% 121432-12-0
L-Histidine 71-00-1
L-Histidine Hydrochloride Monohydrate 5934-29-2
Cycloheptatriene, 90% 544-25-2
2-Iodobenzyl alcohol, 99% 5159-41-1
5-Chlorovaleryl Chloride, 96% 1575-61-7
2-Nitro-p-phenylenediamine, 95-99% 5307-14-2
1,4-Dioxaspiro[4.5]decan-8-ol, 98+% 22428-87-1
Pyrazino[2,3-f]Quinoxaline, 99+% 231-23-2
Lanthanum chloride heptahydrate 10025-84-0
Lanthanum Oxide 1312-81-8
Lanthanum Nitrate Hexahydrate 10099-59-9
2,3-Pentanedione, 97% 600-14-6
Lauric Acid 143-07-7
Alpha-NPO, Scintillation Grade 846-63-9
4-Benzylpiperidine, 98% 31252-42-3
2-(2-Quinoxalinyl)malondialdehyde 0-00-0
4-Nitro-Benzylthiocyanate, 99% 13287-49-5
Methyl vinyl ketone 78-94-4
Lead 7439-92-1
2-Methoxy-5-nitroaniline, 99% 99-59-2
Methyltriphenylphosphonium iodide, 97% 2065-66-9
Lead(II) acetate trihydrate 301-04-2
4-Ethylbiphenyl-4'-carboxylic acid, 98% 5731-13-5
Mono-(Trimethylsilyl)Phosphite 91076-68-5
N-Acetylanthranilic acid, 99% 89-52-1
1,2,2,6,6-Pentamethylpiperidine, 95% (GC) 79-55-0
Dihydrogentrifluoride Polymer-Supported, ca 7 mMol HF/g of Amberlyst 12260-12-7
Lead (II) Chloride 7758-95-4
Triisopropanolamine borate, 98+% 101-00-8
(S)-3-tert.-Butyl-2,5-piperazinedione 65016-62-8
2-Methoxynaphthalene, 98% 93-04-9
Lead chromate 7758-97-6
1-(2'-Thienyl)Ethylmercaptan, 98% 94089-02-8
4-Bromobenzotrifluoride, 99% 402-43-7
Lead Dioxide 1309-60-0
N-Hydroxymaleimide, 97% 4814-74-8
1-Dodecanethiol, 98.5+% (gc) 112-55-0
2,4,6-Trimethylaniline, 97% 88-05-1
Iodobenzene diacetate, 98% 3240-34-4
Trans 2, cis 6-nonadienol, 94% 28069-72-9
1,5-Dihydroxy-1,2,3,4-Tetrahydro-Naphthalene, Tech. 40771-26-4
Acrolein dimethyl acetal, 99% 6044-68-4
Lead(II) nitrate 10099-74-8
Lead Oxide Yellow 1317-36-8

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net