Search   
MSDS 
:
 Tetrabromo-O-Sulfobenzoic Acid Cyclic Anhydride, 95%
CAS 
:
 68460-01-5
SYNONYMS 
:
 3H-2,1-Benzoxathiol-3-One, 4,5,6,7-Tetrabromo-,1,1-Dioxide.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 68460-01-5 |3H-2,1-Benzoxathiol-3-One,4,5,6,7-Tetr| 95 | 270-624-8 |
| |abromo-,1,1-Dioxide | | |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 34

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Causes burns.Corrosive.The toxicological properties of this material
have not been fully investigated.

Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes
gastrointestinal tract burns. The toxicological properties of this
substance have not been fully investigated.
Inhalation:
May cause severe irritation of the respiratory tract with sore
throat, coughing, shortness of breath and delayed lung edema. Causes
chemical burns to the respiratory tract. The toxicological
properties of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Get medical aid. Do NOT allow victim to rub or keep eyes closed.
Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
soap and water for at least 15 minutes while removing contaminated
clothing and shoes. Wash clothing before reuse. Destroy contaminated
shoes.
Ingestion:
Get medical aid. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure to fresh air immediately. If not breathing,
give artificial respiration. If breathing is difficult, give oxygen.
Get medical aid. Do NOT use mouth-to-mouth resuscitation. If
breathing has ceased apply artificial respiration using oxygen and a
suitable mechanical device such as a bag and a mask.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Minimize dust generation and accumulation. Avoid contact with eyes,
skin, and clothing. Keep container tightly closed. Do not ingest or
inhale. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Corrosives
area.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR ??1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant a respirator's use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Powder
Appearance: white to gray
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 220.00 - 222.00 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C7Br4O4S
Molecular Weight: 499.75

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat.
Incompatibilities with Other Materials:
Strong bases, strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide, sulfur oxides (SOx), including sulfur oxide and sulfur
dioxide, bromine fumes.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 68460-01-5 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
3H-2,1-Benzoxathiol-3-One,4,5,6,7-Tetrabromo-,1,1-Dioxide -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: CORROSIVE SOLID, N.O.S.*
Hazard Class: 8
UN Number: 1759
Packing Group: III
IMO
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing Group: III
RID/ADR
Shipping Name: CORROSIVE SOLID, N.O.S.
Dangerous Goods Code: 8(65C)
UN Number: 1759

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 68460-01-5: No information available.
United Kingdom Occupational Exposure Limits

Canada
CAS# 68460-01-5 is listed on Canada's NDSL List.
CAS# 68460-01-5 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 68460-01-5 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 5/25/1999 Revision #1 Date: 8/02/2000

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Ninhydrin, reagent ACS 485-47-2
p-Nitrophenyl-alpha-D-Maltoside Hydrate, 99% 17400-77-0
Molybdenum(VI) oxide 1313-27-5
4-Nitrophenyl-alpha-D-Galactopyranoside. 7493-95-0
4-Methylumbelliferylphosphate disodium salt trihydrate, 99% 22919-26-2
4-Methylumbelliferyl palmitate, 99% 17695-48-6
Sodium cyanoborodeuteride, 98 atom % d 25895-62-9
Tetrabromo-O-Sulfobenzoic Acid Cyclic Anhydride, 95% 68460-01-5
4-Methylumbelliferyl-beta-D-glucopyranoside, 99% 18997-57-4
Sodium phosphate, monobasic monohydrate, reagent ACS (crystals) 7558-80-7
Methyl-alpha-D-galacatopyranoside, 98+% 3396-99-4
Morpholine, Reagent ACS, 99+% (Titr.) 110-91-8
N-Acetyl-L-Cysteine, 98% 616-91-1
N-Amyl Acetate, P.A. 628-63-7
1-Pentanol, 99% 71-41-0
(2-Hydroxyethyl)triphenylphosphonium chloride, 98% 23250-03-5
3-Indoxyl sulfate potassium salt 2642-37-7
Indoxyl-beta-D-glucuronide cyclohexylammonium salt 35804-66-1
n-Butyl acetate, spectrophotometric grade, 99+% 123-86-4
alpha-D-Galactose 1-phosphate dipotassium salt pentahydrate 19046-60-7
Glycine-7-amido-4-methylcoumarin hydrobromide 113728-13-5
N-Acetyl-L-tyrosine ethyl ester monohydrate, 99% 840-97-1
5-Bromo-6-Chloro-3-Indolyl-Beta-D-Galactopyranoside 93863-88-8
5-Bromo-4-Chloro-3-Indolyl-Beta-D-Glucuronide Cyclohexylammonium Salt 18656-96-7
5-Bromo-6-Chloro-3-Indolyl Phosphate p-Toluidine Salt 6769-80-8
L-Alanine-4-Methyl-7-Coumarinylamide Trifluoroacetate 96594-10-4
4-Methylumbelliferyl-alpha-D-glucopyranoside hydrate, 99% 17833-43-1
(S)-(+)-gamma-(Trityloxymethyl)-gamma-butyrolactone, 96% 73968-62-4
(R)-(+)-alpha, alpha-Diphenyl-2-pyrrolidinemethanol, 98% 22348-32-9
(R)-(+)-2-Hydroxy-1,2,2-triphenylethyl acetate, 99% 95061-47-5
(S)-(-)-2-Hydroxy-1,2,2-triphenylethyl acetate, 99% 95061-51-1
(-)-Bis[(S)-1-phenylethyl]amine hydrochloride, 99% 40648-92-8
1-Butanol, reagent ACS, 99.4% 71-36-3
(4S,5R)-(-)-4-Methyl-5-phenyl-2-oxazolidinone, 99% 16251-45-9
1-Bromobutane, 99+% 109-65-9
(4R,5S)-(+)-4-Methyl-5-phenyl-2-oxazolidinone, 99% 77943-39-6
(S)-??5-Hydroxymethyl-??5-butyrolactone, 97% 32780-06-6
(R)-(-)-O-ACETYLMANDELIC ACID, 99% 51019-43-3
N-Isopropylethylenediamine, 98% 19522-67-9
Ammonium Acetate 631-61-8
(1R,2R)-trans-1,2-Cyclohexanediol, 98% 1072-86-2
1-Chlorobutane, Sequenation Grade 109-69-3
(1S,2S)-trans-1,2-Cyclohexanediol, 98% 57794-08-8
Normal-Butylamine, P.A. 109-73-9
Decane, 99+% 124-18-5
Ethyl Chlorothiolformate, 97+% 2941-64-2
Triisopropylnaphthalenesulfonic Acid Sodium Salt (pract), 90% 1323-19-9
n-Ethylmaleimide, 99+% 128-53-0
(+)-Bis[(R)-1-phenylethyl]amine hydrochloride, 99% 82398-30-9
(R)-(+)-N-Benzyl-1-phenylethylamine hydrochloride, 99% 128593-66-8

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net