Search   
MSDS 
:
 Linseed Oil, Raw or Boiled
CAS 
:
 8001-26-1
SYNONYMS 
:
 Flaxseed Oil
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 8001-26-1 |Linseed Oil | 100.0 | 232-278-6 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Not available.

Potential Health Effects
Eye:
Contact may cause transient eye irritation.
Skin:
Prolonged and/or repeated contact may cause irritation and/or
dermatitis. May cause skin sensitization, an allergic reaction,
which becomes evident upon re-exposure to this material.
Ingestion:
Aspiration hazard. Ingestion of large amounts may cause
gastrointestinal irritation. Aspiration of material into the lungs
may cause chemical pneumonitis, which may be fatal.
Inhalation:
Causes respiratory tract irritation.
Chronic:
May cause allergic skin reaction in some individuals.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Will burn
if involved in a fire. Vapors may be heavier than air. They can
spread along the ground and collect in low or confined areas.
Extinguishing Media:
Use dry chemical to fight fire. Use carbon dioxide.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Avoid runoff into storm sewers and ditches which lead to waterways.
Clean up spills immediately, observing precautions in the Protective
Equipment section. Remove all sources of ignition. Absorb spill using
an absorbent, non-combustible material such as earth, sand, or
vermiculite. Do not use combustible materials such as sawdust.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Wash hands before eating. Remove
contaminated clothing and wash before reuse. Use with adequate
ventilation. Avoid contact with skin and eyes. Keep away from heat,
sparks and flame. Do not ingest or inhale. Wash clothing before
reuse.
Storage:
Keep away from heat, sparks, and flame. Store in a cool, dry place.
Store in a tightly closed container. Keep from contact with
oxidizing materials.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Good general ventilation should be sufficient to control airborne
levels. Facilities storing or utilizing this material should be
equipped with an eyewash facility and a safety shower.
Exposure Limits
CAS# 8001-26-1:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate gloves to prevent skin exposure.
Clothing:
Wear appropriate protective gloves to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: yellow to brown
Odor: peculiar odor
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: > 600 deg F
Freezing/Melting Point: -11 deg F
Autoignition Temperature: 650 deg F ( 343.33 deg C)
Flash Point: 403 deg F ( 206.11 deg C)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: Insoluble in water
Specific Gravity/Density: 0.925 - 0.935
Molecular Formula: Not applicable.
Molecular Weight: Not available

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, excess heat.
Incompatibilities with Other Materials:
Nitric acid, chlorine, strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 8001-26-1: OI9690000
LD50/LC50:
Not available.
Carcinogenicity:
Linseed Oil -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
WGK (Water Danger/Protection)
CAS# 8001-26-1: 1
Canada
CAS# 8001-26-1 is listed on Canada's DSL List.
CAS# 8001-26-1 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 8001-26-1 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 4/15/1999 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Mercury (II) Nitrate 10045-94-0
3-Nitrophenol 554-84-7
Nitroethane 79-24-3
N-(4-Nitrobenzyl)-N-Propylamine Hydrochloride 68133-98-2
2-Nitrobenzoic Acid 552-16-9
Mercury (II) sulfide 1344-48-5
3-Nitrobenzaldehyde 99-61-6
2-Nitrobenzaldehyde 552-89-6
Nitric Acid SG1.5-Fuming 7697-37-2
Nitrate Buffer (Modified) 7664-38-2
4-Nitrobenzaldehyde 555-16-8
Nitrate Buffer Concentrate 7379-28-4
3-Iodobenzyl Alcohol, 99% 57455-06-8
Mercury (II) thiocyanate 592-85-8
Ninhydrin Solution 71-36-3
Mercurochrome 129-16-8
Mercury Chloride 10112-91-1
Furil dioxime 522-27-0
3-Nitroaniline 99-09-2
Nigrosine 8005-03-6
Nicotinic Acid 59-67-6
Nickel (II) Sulfate Heptahydrate 10101-98-1
Mercury(I) nitrate, dihydrate 7782-86-7
1-Naphthylamine-7-Sulfonic Acid 119-28-8
Mesitylene 108-67-8
2-(5-Hydroxycarbonyl-2-nitrophenyl) malondialdehyde monohydrate, 95%
Litmus 1393-92-6
Lithium Sulfate, Monohydrate 10102-25-7
Tetraethyl 1,1,2,2-ethanetetracarboxylate, 97% 632-56-4
Mesityl oxide 141-79-7
Lithium Metaborate 13453-69-5
Methane Sulfonic Acid 75-75-2
Methane sulfonic acid, sodium salt 2386-57-4
Lithium Perchlorate Dried 7791-03-9
Lithium Iodide 10377-51-2
Lithium acetate hydrated 546-89-4
Linseed Oil, Raw or Boiled 8001-26-1
Lithium Metal 98.5% in Liquid Paraffin 7439-93-2
D(+)Limonene 5989-27-5
Methane sulfonyl chloride 124-63-0
Lead (II) Sulfate 7446-14-2
Lead (II) Iodide 10101-63-0
Lead (II) Carbonate, Basic Precipitated 1319-46-6
Methoxylamine Hydrochloride 593-56-6
4-Methoxy-1-Naphthaldehyde, 99% 15971-29-6
p-Ethoxybenzaldehyde, 99% 10031-82-0
Sodium Hydroxide 20-30% 1310-73-2
Sodium Hydroxide 2.000N 1310-73-2
P-Naphtholbenzein 145-50-6
Silver Nitrate 0.001N-0.171N 7732-18-5

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net