**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 8002-74-2 |Paraffin waxes and hydrocarbon waxes | 100 | 232-315-6 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Not available.
Potential Health Effects
Eye:
May cause mild eye irritation.
Skin:
Low hazard for usual industrial handling. Contact with heated
material can cause skin burns and irritation.
Ingestion:
May cause irritation of the digestive tract. Low hazard for usual
industrial handling.
Inhalation:
Low hazard for usual industrial handling. If heated, dust or fume
may cause respiratory tract irritation. Inhalation of a mist of this
material may cause respiratory tract irritation.
Chronic:
Prolonged or repeated skin contact may cause dermatitis.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. If irritation
develops, get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Do NOT induce
vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls
of milk or water. Get medical aid if irritation or symptoms occur.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Sweep up, then place into a suitable container for disposal. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash hands before eating. Avoid contact with skin and eyes. Use with
adequate ventilation.
Storage:
Store in a tightly closed container. Keep refrigerated. (Store below
4C/39F.) Store in a cool, dry area away from incompatible
substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use process enclosure, local exhaust ventilation, or other
engineering controls to control airborne levels below recommended
exposure limits. Facilities storing or utilizing this material should
be equipped with an eyewash facility and a safety shower.
Exposure Limits
CAS# 8002-74-2:
United Kingdom, WEL - TWA: 2 mg/m3 TWA (fume)
United Kingdom, WEL - STEL: 6 mg/m3 STEL (fume)
Belgium - TWA: 2 mg/m3 VLE (fumes)
France - VME: 2 mg/m3 VME (fume)
Malaysia: 2 mg/m3 TWA (fume)
Netherlands: 2 mg/m3 MAC
Spain: 2 mg/m3 VLA-ED
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Pellets
Color: white
Odor: odorless
pH: Not available.
Vapor Pressure: Not available.
Viscosity: mPas 99 deg C
Boiling Point: 322 deg C @ 760.00m
Freezing/Melting Point: 58 - 62 deg C
Autoignition Temperature: 245 deg C ( 473.00 deg F)
Flash Point: 198 deg C ( 388.40 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: insoluble
Specific Gravity/Density: Not available.
Molecular Formula: Not applicable.
Molecular Weight:
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants, heat.
Incompatibilities with Other Materials:
Heat, strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, acrid smoke and fumes.
Hazardous Polymerization: Will not occur.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 8002-74-2: RV0350000
LD50/LC50:
CAS# 8002-74-2: Draize test, rabbit, eye: 100 mg/24H Mild; Draize
test, rabbit, skin: 500 mg/24H Mild.
Carcinogenicity:
Paraffin waxes and hydrocarbon waxes -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 8002-74-2: 0
Canada
CAS# 8002-74-2 is listed on Canada's DSL List.
CAS# 8002-74-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 8002-74-2 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #5 Date: 10/27/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Cyclooctene, 99% (GC)
| 931-86-2 |
|
Paraffin wax (granular)
| 8002-74-2 |
|
Mineral oil
| 8042-47-5 |
|
Celite 521
| 61790-53-2 |
|
Celatom FW-50
| 60676-86-0 |
|
Celatom FW-60
| 60676-86-0 |
|
Celatom FW-80
| 60676-86-0 |
|
1-Penten-3-ol, 99%
| 616-25-1 |
|
Dimethyl Isophthalate, 99%
| 1459-93-4 |
|
2,5-Dimethylphenol, 99+%
| 95-87-4 |
|
Dl-3-octanol, 99+%
| 589-98-0 |
|
Dowex 50x2-100 Ion-Exchange Resin
| 12612-37-2 |
|
Dowex 50x2-400 Ion-Exchange Resin
| 12612-37-2 |
|
meso-2,3-Dibromosuccinic acid
| 526-78-3 |
|
Methylene Blue trihydrate, 95%
| 61-73-4 |
|
Gum arabic
| 9000-01-5 |
|
Propionaldehyde, 97%
| 123-38-6 |
|
Allyl ethyl ether, 95%
| 557-31-3 |
|
n-Nonaphenone, 98% (gc)
| 6008-36-2 |
|
Indole-3-acetic acid hydrazide, 97%
| 5448-47-5 |
|
Acetamide, P.A.
| 60-35-5 |
|
Acetanilide, 99+%
| 103-84-4 |
|
Acetic anhydride, 99+%
| 108-24-7 |
|
Acetic anhydride, reagent ACS, 97+%
| 108-24-7 |
|
n-(2-Acetamidophenethyl)-1-hydroxy-2- naphthamide
| 5254-41-1 |
|
Epsilon-caprolactone monomer, 99%
| 502-44-3 |
|
1,1,2,2-Tetrabromoethane, 99%
| 79-27-6 |
|
Acrylamide, 98.5%
| 79-06-1 |
|
Agarose, Pure Powder (MR = -0.10)
| 9012-36-6 |
|
Agarose, Pure Powder (MR = -0.02)
| 9012-36-6 |
|
Agarose, Pure Powder (MR = -0.25)
| 9012-36-6 |
|
Agarose, Pure Powder (MR = -0.17)
| 9012-36-6 |
|
Agarose, Pure Powder (MR = -0.13+/- 0.01)
| 9012-36-6 |
|
Agarose LE
| 9012-36-6 |
|
Agarose ME
| 9012-36-6 |
|
Gibberellic Acid, 90+%
| 77-06-5 |
|
Gibberellic Acid (in Dibasic Ammonium Phosphate)
| 77-06-5 |
|
Aluminon, p.a.
| 569-58-4 |
|
Aluminum ammonium sulfate dodecahydrate, 99%
| 7784-25-0 |
|
5-Methoxy-2-mercaptobenzimidazole, 99+% (HPLC)
| 37052-78-1 |
|
2-Pentanone 98+%
| 107-87-9 |
|
Ethyl 2-amino-4,5,6,7-tetrahydrobenzo(b)thiophene-3-carboxylate, 97%
| 4506-71-2 |
|
Aluminum chloride, anhydrous, granules, 99%
| 7446-70-0 |
|
Aluminum Oxide, Activated, Basic, for Column Chromatography(50-200
| 1344-28-1 |
|
Aluminum Oxide, Activated, 50-200 Micron, Neutral, for Column
| 1344-28-1 |
|
Aluminum Oxide, 99.9999%, Coarse Granular
| 1344-28-1 |
|
Aluminum Oxide, 99.999%, - 40 Mesh
| 1344-28-1 |
|
Aluminum Oxide, 99.99%
| 1344-28-1 |
|
Aluminum Oxide, 99%
| 1344-28-1 |
|
Aluminum Oxide (Morin Dyed)
| 1344-28-1 |
|
|