JOHNS MANVILLE CORP -- STATIC-RESISTANT MELT BLOWN NON-WOVEN ROLL GO
=======================================================
Material Safety Data Sheet
=======================================================
NIIN: 01-334-3304
MSDS Num: CKWDX
MSDS NAME: STATIC-RESISTANT MELT BLOWN NON-WOVEN ROLL GOODS
Article: Y
Responsible Party
Name: JOHNS MANVILLE CORP
Address: 286 CARRIER BOULEVARD
City: RICHLAND MS 39218
Info Phone: 800-654-9419
Emergency Phone Number: 800-654-9419
Resp. Party Other MSDS No.: 2084-1.1
Published: Y
=======================================================
Contractor Summary
=======================================================
Name: JOHNS MANVILLE CORP
Address: 286 CARRIER BOULEVARD
City: RICHLAND MS 39218
Phone: 800-654-9419
Name: M AND I SUPPLY INC
Address: 385 CURIE DR
Box: 1127
City: ALPHARETTA GA 30009-1127
Phone: 800-228-3877
Contract Number: SP0450-01-D-4012
=======================================================
Item Description Information
=======================================================
Item Manager: S9G
Item Name: SORBENT, OIL
Unit of Issue: RO
Quantitative Expression: 00000000144FT
=======================================================
Regulated Components
=======================================================
Regulated Component Name: OP 4 (POLYOLEFIN)
CAS: 9003-07-0
=======================================================
Health Hazards Data
=======================================================
Route Of Entry Inds - Inhalation: NO
Skin: NO
Ingestion: NO
Carcinogenicity Inds - NTP: NO
IARC: NO
OSHA: NO
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: FOR LAND SPILLS ELIMINATE SOURCES OF IGNITION.
RECOVER SPILLED MATERIAL AND PLACE IN SUITABLE CONTAINERS FOR RECYCLE OR
DISPOSAL. IF SPILL OCCURS ON WATER, SKIM MATERIAL FROM SURFACE AND ADVISE
AUTHOR ITIES IF FLOATING MATERIAL ENTERS A WATERCOURSE OR SEWER. PICK UP
LARGE PIECES. VACUUM DUST. IF SWEEPING IS NECESSARY, USE A DUST SUPPRESSANT
SUCH AS WATER. DO NOT DRY SWEEP DUST ACCUMULATION (OTHER)
Waste Disposal Methods: WASTES ARE NOT HAZARDOUS AS DEFINED BY RESOURCE
CONSERVATION AND RECOVERY ACT (RCRA 40 CFR 261). COMPLY WITH STATE AND LOCAL
REGULATIONS FOR DISPOSAL OF POLYMERIC PRODUCTS. IF YOU ARE UNAWARE OF THE R
EGULATIONS, CONTACT LOCAL PUBLIC HEALTH DEPARTMENT OR THE LOCAL OFFICE OF THE
ENVIRONMENTAL PROTECTI ON AGENCY (EPA).
Handling And Storage Precautions: GOOD INDUSTRIAL HYGIENE PRACTICE SHOULD BE
FOLLOWED, INCLUDING MINIMIZATION OF SKIN CONTACT, INHALATION OF VAPORS AND
DEGRADATION PRODUCTS.
=======================================================
Fire and Explosion Hazard Information
=======================================================
Flash Point: >316.C, 600.8F
Autoignition Temp: >302.C, 575.6F
Lower Limits: NOT DETERMIN
Upper Limits: NOT DETERMIN
Extinguishing Media: CARBON DIOXIDE(CO2), FOAM, DRY CHEMICAL, OR WATER SPRAY.
WATER SHOULD BE USED TO KEEP FIRE-EXPOSED CONTAINERS COOL.
Fire Fighting Procedures: WATER SHOULD BE USED TO KEEP FIRE-EXPOSED CONTAINERS
COOL. WATER OR DRY CHEMICAL MAY CAUSE DAMAGE TO MACHINERY. SELF-CONTAINED
BREATHING APPARATUS AND PERSONAL PROTECTIVE EQUIPMENT SHOULD BE USED AS N
ECESSARY.
=======================================================
Control Measures
=======================================================
=======================================================
Physical/Chemical Properties
=======================================================
HCC: N1
Melt/Freeze Pt: >107.C, 224.6F
Vapor Pres: NEGLIGIBLE
Spec Gravity: VARIES BY GRADE
Solubility in Water: INSOLUBLE
Appearance and Odor: WHITE MELT BLOWN NON-WOVEN MATERIAL; NO ODOR
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES
Stability Condition To Avoid: TEMPERATURES OVER 249 DEGREES C/480 DEGREES F MAY
CAUSE MATERIAL DEGRADATION.
Materials To Avoid: NONE
Hazardous Decomposition Products: METHANE, ACETONE, AND OTHER KETONES.
Hazardous Polymerization Indicator: NO
=======================================================
Toxicological Information
=======================================================
Toxicological Information: ACUTE EFFECTS: THESE PRODUCTS ARE NOT EXPECTED TO
PRESENT ANY ACUTE TOXICOLOGIC EFFECTS UNDER NORMAL CONDITIONS OF USE, THEY
WILL NOT RELEASE OR OTHERWISE RESULT IN EXPOSURE TO A HAZARDOUS CHEMICAL.
CHRONIC EFFECTS: NO CHRONIC EFFECTS ARE EXPECTED FROM NORMAL USES OF THIS
PRODUCT.
=======================================================
Ecological Information
=======================================================
Ecological: THIS PRODUCT HAS NOT BEEN TESTED.
=======================================================
MSDS Transport Information
=======================================================
Transport Information: THIS PRODUCT IS NOT REGULATED AS A HAZARDOUS MATERIAL
FOR TRANSPORT.
=======================================================
Regulatory Information
=======================================================
Sara Title III Information: THERE ARE NO COMPONENTS IN THIS PRODUCT REGULATED
BY THE ENVIRONEMNTAL PROTECTION AGENCY (EPA) UNDER THE SUPERFUND AMENDMENTS
AND REAUTHORIZATION ACT (SARA TITLE III).
Federal Regulatory Information: THERE ARE NO COMPONENTS IN THIS PRODUCT
REGULATED BY THE ENVIRONEMNTAL PROTECTION AGENCY (EPA) UNDER THE
COMPREHENSIVE ENVIRONMENTAL RESPONSE, COMPENSATION, AND LIABILITY ACT
(CERCLA), OR THE TOXIC S UBSTANCES CONTROL ACT (TSCA). TOXIC SUBSTANCES
CONTROL ACT INVENTORY (TSCA 8(B)): THIS PRODUCT AND ITS COMPONENTS ARE
LISTED.
State Regulatory Information: STATES ENFORCING 1989 AIR CONTAMINANTS STANDARD:
AK, CA, CT, ME, MI, MN, NM, TN, WA, WI.
=======================================================
Other Information
=======================================================
=======================================================
Transportation Information
=======================================================
Trans ID NO: 155408
MSDS NAME: STATIC-RESISTANT MELT BLOWN NON-WOVEN ROLL GOODS
MSDS Prepared Date: 07/30/1998
Review Date: 11/21/2000
Multiple KIT Number: 0
Unit Of Issue: RO
=======================================================
Detail DOT Information
=======================================================
DOT PSN Code: ZZZ
DOT Proper Shipping Name: NOT REGULATED BY THIS MODE OF TRANSPORTATION
=======================================================
Detail IMO Information
=======================================================
IMO PSN Code: ZZZ
IMO Proper Shipping Name: NOT REGULATED FOR THIS MODE OF TRANSPORTATION
=======================================================
Detail IATA Information
=======================================================
IATA PSN Code: ZZZ
IATA Proper Shipping Name: NOT REGULATED BY THIS MODE OF TRANSPORTATION
=======================================================
Detail AFI Information
=======================================================
AFI PSN Code: ZZZ
AFI Proper Shipping Name: NOT REGULATED BY THIS MODE OF TRANSPORTATION
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: STATIC-RESISTANT MELT BLOWN NON-WOVEN ROLL GOODS
Assigned IND: Y
Company: JOHNS MANVILLE CORP
Street: 286 CARRIER BOULEVARD
City: RICHLAND MS
Zipcode: 39218
Health Emergency Phone: 800-654-9419
Label Required IND: Y
Date Of Label Review: 11/21/2000
Status Code: A
Origination Code: F
Eye Protection IND: NO
Skin Protection IND: NO
Signal Word: CAUTION
Respiratory Protection IND: NO
Health Hazard: None
Contact Hazard: None
Fire Hazard: Slight
Reactivity Hazard: None
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.
*** END OF RECORD *** |
|
|