===================== Product Identification =====================
MSDS NAME:F-102 BASMILE15145B
NIIN:00-290-6645
Kit Part:Y
MSDS Number: BWCWT
=== Responsible Party ===
Company:SEAGRAVE COATINGS CORP OF VIRGINIA SEAGUARD DIV
Address:4030 SEAGUARD AVE
City:PORTSMOUTH
State:VA
ZIP:23705
Country:US
Info Phone Num:804-488-4411
Emergency Phone Num:804-488-4411
CAGE:60163
=== Contractor Identification ===
Company:SHERWIN-WILLIAMS, SEAGUARD
Address:3560 ELM AVE.
Box:City:PORTSMOUTH
State:VA
ZIP:23704
Country:US
Phone:757-397-2223
CAGE:60163
============= Composition/Information on Ingredients =============
Name:ZINC OXIDE
CAS:1314-13-2
RTECS #:ZH4810000
Fraction by Wt: 26% %
Other REC Limits:NONE RECOMMENDED
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10MG/M3 TDUST; 9394
Name:STODDARD SOLVENT
CAS:8052-41-3
RTECS #:WJ8925000
Fraction by Wt: 35% %
Other REC Limits:NONE RECOMMENDED
OSHA PEL:500 PPM
ACGIH TLV:100 PPM; 9394
Name:NON-HAZARDOUS INGREDIENTS
Fraction by Wt: BALANCE
Other REC Limits:NONE RECOMMENDED
===================== Hazards Identification =====================
LD50 LC50 Mixture:NOT GIVEN FOR PRODUCT AS A WHOLE
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION MAY CAUSE IRRITATION TO
RESPIRATORY TRACT, HEADACHE, DIZZINESS AND NAUSEA. SKIN CONTACT MAY
CAUSE IRRITATION. EYE CONTACT MAY CAUSE IRRITATION.
Explanation of Carcinogenicity:THIS COMPOUND CONTAINS NO INGREDIENTS AT
CONCENTRATIONS OF 0.1% OR GREATER THAT ARE CARCINOGENS OR SUSPECT
CARCINOGENS.
Effects of Overexposure:EYE IRRITATION, SKIN IRRITATION, RESPIRATORY
TRACT IRRITATION, HEADACHE, DIZZINESS, NAUSEA.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT.
======================= First Aid Measures =======================
Eyes: FLUSH WITH WATER FOR 15 MINUTES WHILE HOLDING EYELIDS
OPEN. GET MEDICAL ATTENTION. SKIN: REMOVE CONTAMINATED CLOTHING.
WASH WITH SOAP AND WATER. IF IRRITATION PERSISTS, GET MEDICAL
ATTENTION. IN HALATION: REMOVE TO FRESH AIR. RESTORE BREATHING. GET
MEDICAL ATTENTION. INGESTION: DO NOT INDUCE VOMITING. GET MEDICAL
ATTENTION.
===================== Fire Fighting Measures =====================
Flash Point Method:TCC
Flash Point:100F,38C
Lower Limits:1.1 %
Upper Limits:8.0 %
Extinguishing Media:WATER FOG, DRY CHEMICAL, FOAM
Fire Fighting Procedures:FIRE FIGHTERS SHOULD USE NIOSH APPROVED SCBA &
FULL PROTECTIVE EQUIPMENT WHEN FIGHTING CHEMICAL FIRE. USE WATER
SPRAY TO COOL NEARBY CONTAINERS EXPOSED TO FIRE.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, SPARKS AND OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT.
================== Accidental Release Measures ==================
Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES AND ANYTHING WHICH COULD CAUSE
FIRE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE IN A COOL, DRY PLACE WITH
ADEQUATE VENTILATION. KEEP AWAY FROM OPEN FLAMES AND HIGH
TEMPERATURES.
Other Precautions:AVOID SKIN CONTACT. LAUNDER CONTAMINATED CLOTHING
BEFORE REUSE.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:IF VENTILATION DOES NOT MAINTAIN INHALATION
EXOSURES BELOW PEL (TLV), USE NIOSH/MSHA APPROVED RESPIRATOR AS PER
CURRENT 29 CFR 1910.134, INSTRUCTIONS/WARNINGS AND NIOSH RESPIRATOR
SELECTION.
Ventilation:LOCAL EXHAUST AND MECHANICAL (GENERAL) VENTILATION TO
MAINTAIN EXPOSURE LEVELS.
Protective Gloves:RECOMMENDE FOR PROLONGED CONTACT
Eye Protection:SAFETY GLASSES OR GOGGLES
Other Protective Equipment:PROTECTIVE CLOTHING AS REQUIRED TO AVOID
SKIN CONTACT. AN EMERGENCY EYE WASH STATION AND SHOWER SHOULD BE
AVAILABLE.
Work Hygienic Practices:WASH WITH SOAP AND WATER AFTER HANDLING PRODUCT
AND BEFORE EATING DRINKING OR SMOKING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
================== Physical/Chemical Properties ==================
HCC:F4
Boiling Pt:B.P. Text:302F,150C
Melt/Freeze Pt:M.P/F.P Text:NOT GIVEN
Vapor Pres:NOT GIVEN
Vapor Density:> 1
Spec Gravity:> 1
Evaporation Rate & Reference:< 1 (ETHER = 1)
Solubility in Water:INSOLUBLE
Appearance and Odor:TAN LIQUID, PETROLEUM DISTILLATE ODOR
Percent Volatiles by Volume:74 %
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HEAT, OPEN FLAME, SPARKS
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE
==================== Disposal Considerations ====================
Waste Disposal Methods:PREVENT WASTE FROM CONTAMINATING SURROUNDING
ENVIRONMENT. DISCARD ANY PRODUCT, RESIDUE, DISPOSAL CONTAINER OR
LINER IN ACCORDANCE WITH ALL FEDERAL, STATE AND LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|
| ALL PAGES On Chemical Property IN THIS GROUP
| | NAME | CAS |
|
SOLTROL 100, AP1000
| 68551-16-6 |
|
9994 FLOOR SEALER
| |
|
RUSTLICK EDM-30, 72052
| 64742-47-8 |
|
81160, 26BR, FORM-A-GASKET (R) SEALANT, HIGH (SUPDAT)
| 63148-62-9
112945-52-5
4253-34-3
1309-37-1 |
|
O M FINISHING STAINS, 401
| 64741-41-9
1330-20-7
64742-95-6 |
|
ASTEC 100
| 66402-68-4
13701-59-2
84-74-2
12001-26-2 |
|
ASTEC B-16-71
| 13701-59-2
111-76-2
7779-90-0 |
|
ALPENCO LENS CLEANER & ANTI-FOGGING LIQUID
| 67-63-0
9004-87-9
1340-02-9
7732-18-5 |
|
FE-7004-A RESIWELD
| 2426-08-6
112945-52-5 |
|
FE-7004-B RESIWELD
| |
|
GARD ANTIRUST SAE 10, 30 & 15W-40 I/A/W MIL-L-21260D
| 64742-54-7 |
|
GARD ANTIRUST SAE 10, 30 & 15W-40 I/A/W MIL-L-21260D
| 64742-54-7 |
|
CAPRINUS(R) U OIL 40
| 64742-52-5
64742-18-3
64742-54-7
63449-39-8 |
|
GARDFLEET SAE 10, 30 AND 40 I/A/W MIL-L-2104F
| 64742-54-7 |
|
MIL-L-46152D GRADE 10W-30
| 7440-66-6 |
|
GARDFLEET SAE 10, 30 AND 40 I/A/W MIL-L-2104F
| 64742-54-7 |
|
I-C-OE 30, MIL-L-2104F OE 30, QUAL # MC-3705
| 64741-88-4 |
|
GARDFLEET SAE 10, 30 AND 40 I/A/W MIL-L-2104F
| 64742-54-7 |
|
I-C-OE 30, MIL-L-2104F OE 30, QUAL # MC-3705
| 64741-88-4 |
|
GARDFLEET SAE 10, 30 AND 40 I/A/W MIL-L-2104F
| 64742-54-7 |
|
1% 2% ETC HYDROGEN IN AIR
| 1333-74-0
7727-37-9
7782-44-7 |
|
T555-2
| |
|
RAW LINSEED OIL
| 8001-26-1 |
|
MURIATIC ACID, 20 DEG BAUME
| 7647-01-0 |
|
ANDEROL 401D SYNTHETIC INSTRUMENT OIL
| |
|
30008 PQ RP 160/MIL-L-6085B QA
| |
|
GUNCARE
| 64742-47-8
71-55-6 |
|
DOT 3 NOTOR VEHICLE BRAKE FLUID
| |
|
SODIUM CHROMATE
| 7775-11-3 |
|
KEROSINE
| |
|
CARBON DIOXIDE, GAS
| 124-38-9 |
|
PHENYLEPRINE HCL 1% NASAL SOLUTION
| |
|
AIRCO 60 ALUMINUM
| 7647-14-5
7789-24-4
7447-41-8
10361-37-2
7646-85-7 |
|
XYLENE (MIXED ISOMERS)
| 1330-20-7
68920-06-9 |
|
CU-P BRAZING ALLOY SILVALLOY O
| 7440-50-8
7723-14-0 |
|
CU-P BRAZING ALLOY SILVALLOY O
| 7440-50-8
7723-14-0 |
|
MMM-A-260C, TY.II,GR.B,CL1
| 110-54-3
9003-55-8
9006-04-6 |
|
DRY CLEANING SOLVENT
| 8030-30-6
75-09-2
127-18-4 |
|
SEMI GLOSS ENAMEL
| 8032-32-4 |
|
MIL-C-450C TYPE II
| |
|
F-102 BASMILE15145B
| 1314-13-2
8052-41-3 |
|
WHITE #17875
| |
|
NO DUST SWEEPING COMPOUND
| |
|
CARBON DIOXIDE (GAS) / DRY ICE (SOLID)
| 124-38-9 |
|
RED DECK ENAMEL ALKYD
| 14807-96-6
1314-13-2
14808-60-7
1309-37-1
51274-00-1
13463-67-7
64742-47-8
64741-92-0
64742-47-8 |
|
RED DECK ENAMEL ALKYD
| 14807-96-6
1314-13-2
14808-60-7
1309-37-1
51274-00-1
13463-67-7
64742-47-8
64741-92-0
64742-47-8 |
|
SEMI GLOSS ENAMEL
| 8032-32-4 |
|
SEMI GLOSS ENAMEL
| 8032-32-4 |
|
P407, P707, A357, A557
| 9000-70-8
7785-23-1
10108-64-2 |
|
P407, P707, A357, A557
| 9000-70-8
7785-23-1
10108-64-2 |
|
|