=====================  Product Identification  =====================

MSDS NAME:ACRYLIC EXTERIOR PAINT 523-SUNSHINE YELLOW
Status Code:A
MSDS Number: CJKZW
=== Responsible Party ===
Company:COURTAULDS COATINGS
Address:400 S 13TH STREET
City:LOUISVILLE
State:KY
ZIP:40203
Country:US
Info Phone Num:502-588-9200
Emergency Phone Num:800-854-6813
CAGE:50411
=== Contractor Identification ===
Company:COURTAULDS COATINGS INC
Address:400 S 13TH STREET
Box:City:LOUISVILLE
State:KY
ZIP:40203-1714
Country:US
Phone:502-588-9651
CAGE:50411

=============  Composition/Information on Ingredients  =============

Name:ETHYLENE GLYCOL; VP: 0.1 MMHG @ 20C
CAS:107-21-1
RTECS #:KW2975000
= Wt:2.
Other REC Limits:N/K 
OSHA PEL:50 PPM
OSHA STEL:N/K 
ACGIH TLV:50 PPM
ACGIH STEL:C127 MG/M3;C50 PPM
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALATION OF SOLVENT VAPOR MAY
    CAUSE NOSE, THROAT AND LUNG IRRITATION. DIRECT EYE CONTACT MAY
    CAUSE MODERATE TO SEVERE IRRITATION. MAY CAUSE AN ALLERGIC SKIN OR
    RESPIRATORY REACTION IN PEOPLE  WHO ARE SENSITIVE (ALLERGIC) TO
    ACRYLIC POLYMERS. REPEATED OR PROLONGED OVEREXPOSURE MAY CAUSE
    LIVER, KIDNEY AND CENTRAL NERVOUS SYSTEM DAMAGE. POSSIBLE BIRTH
    DEFECT HAZARD. CONTAINS ETHYLENE GLYCOL W HICH MAY CAUSE BIRTH
    DEFECTS BASED ON ANIMAL DATA.
Effects of Overexposure:SEE HEALTH HAZARDS.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE TO FRESH AIR. EYES: FLUSH IMMEDIATELY WITH
    LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES. TAKE TO PHYSICIAN
    FOR MEDICAL TREATMENT. SKIN: WASH AFFECTED AREA WITH LARGE AMOUNTS
    OF WA TER. REMOVE CONTAMINATED CLOTHING. INGESTION: CALL A
    PHYSICIAN IMMEDIATELY .

=====================  Fire Fighting Measures  =====================

Lower Limits:0.7%
Upper Limits:1.0%
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA AND FULL PROTECTIVE
    EQUIPMENT . REFER TO D.O.T. P 5800.3 "1984 EMERGENCY RESPONSE BOOK:
    GUIDEBOOK FOR HAZARDOUS MATERIALS' INCIDENTS" GUIDE # 26, ID #
    1263.
Unusual Fire/Explosion Hazard:KEEP CONTRS TIGHTLY CLOSED. ISOLATE FROM
    HEAT, SPARKS, ELECTRICAL EQUIP, & OPEN FLAME. CLOSED CONTRS MAY
    EXPLODE WHEN EXPOSED TO EXTREME HEAT. IN THE ABSENCE OF
    ELECTRICITY, A WATER SPRAY (FOG NOZZLE  IS PREFERRED) MAY BE USED
    TO COOL CONTRS. AVOID EXPOS TO DECOMP. FLAMMABILITY CLASSIFICATION:
    OSHA: N/A.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION (FLAMES, HOT
    SURFACES, AND ELECTRICAL, STATIC OR FRICTION SPARKS). AVOID
    BREATHING VAPORS, AND VENTILATE AREA. REMOVE WITH INERT ABSORBENT
    SUCH AS SAND, KITTY LITTER, ET C, AND USE NON-SPARKING TOOLS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:SECURE CLOSURES & KEEP CONTRS UPRIGHT
    TO PVNT LEAKAGE. STORE LGE QTYS ONLY IN BLDGS DESIGNED TO COMPLY
    W/OSHA 1910.106. DO NOT STORE ABOVE 120F. DO NOT TAKE INTERNALLY.
    DO NOT GET IN EYES/ON SKIN. AVO ID BRTHG VAPS/SPRAY MIST. DO NOT
    STORE/USE NEAR HEAT.
Other Precautions:DO NOT FLAME CUT, BRAZE/WELD W/OUT NIOSH APPRVD MECH
    FILTER RESP/APPROP & ADEQ VENT. ALL ELEC EQUIP & INSTALLATIONS
    SHOULD BE MADE & GROUNDED I/A/W NATL ELEC CODE. IF WORKMEN ARE
    EXPOSED TO SPRAY APPL ICATION/ABRASIVE BLAST CLEANING, ENGINEERING
    & ADMIN CTLS MUST BE USED TO MAINTAIN EXPOS LEVEL BELOW  OSHA (SUP
    DAT)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IN OUTDOOR/OPEN AREAS W/UNRESTRICTED
    VENTILATION, USE NIOSH APPROVED MECHANICAL FILTER RESPIRATOR TO
    REMOVE SOLID AIRBORNE PARTICLES OF OVERSPRAY DURING SPRAY
    APPLICATION. IN RESTRICTED VENTILATION AR EAS, USE NIOSH APPROVED
    MECHANICAL FILTER RESPIRATORS DESIGNED TO REMOVE PARTICULATES. IN
    CONFINED AREAS, USE NIOSH APPROVED AIR-LINE RESPS & HOODS.
Ventilation:PROVIDE GENERAL DILUTION/LOCAL EXHAUST VENTILATION KEEP
    REMOVE DECOMPOSITION PRODUCTS DURING WELDING & FLAME CUTTING ON
    SURFACES COATED W/THIS PRODUCT.
Protective Gloves:USE A HEAVY DUTY RUBBER GLOVE, SUCH AS NEOPRENE TYPE
    GLOVE AS NEEDED.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYEWASH AND DELUGE SHOWER MEETING ANSI
    DESIGN CRITERIA . AS NEEDED, USE BODY PROTECTION, SUCH AS RUBBER
    APRON, ETC.
Work Hygienic Practices:BEFORE SMOKING OR EATING, WASH HANDS
    THOROUGHLY.
Supplemental Safety and Health
OTHER PREC: REQUIRED LEVEL, OR USE NIOSH APPROVED MECHANICAL FILTER
    RESPIRATORS FOR PROTECTION.

==================  Physical/Chemical Properties  ==================

Boiling Pt:=100.C, 212.F
Vapor Pres:SEE INGREDIENT 1
Vapor Density:HVR/AIR
Spec Gravity:1.26-1.35 
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:60 - 61

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE KNOWN.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
    HEATED TO DECOMPOSITION AS IN WELDING. FUMES MAY PRODUCE CARBON
    DIOXIDE AND CARBON MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN A SAFE MANNER IN ACCORDANCE WITH
    LOCAL, STATE, AND FEDERAL REGULATIONS THAT APPLY TO INCINERATION OR
    SECURE LANDFILL.

===================  MSDS Transport Information  ===================

Transport Information:DOT FLAMMABILITY CLASSIFICATION: NOT APPLICABLE.

=====================  Regulatory Information  =====================

SARA Title III Information:ETHYLENE GLYCOL IS A CHEMICAL SUBJECT TO THE
    REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III AND OF 40 CFR
    372.
State Regulatory Information:

=======================  Other Information  =======================

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***