=====================  Product Identification  =====================

MSDS NAME:GEAR SHIELD EXTRA HEAVY, GEAR SHIELD HEAVY, GEAR SHIELD
NIIN:00-076-1574
Status Code:A
MSDS Number: CJVJT
=== Responsible Party ===
Company:FISKE BROS REFINING CO
Address:129 LOCKWOOD ST
City:NEWARK
State:NJ
ZIP:07105
Country:US
Info Phone Num:201-589-9150; 419-691-2491
Emergency Phone Num:800-255-3924
CAGE:73219
=== Contractor Identification ===
Company:FISKE BROS REFINING CO
Address:129 LOCKWOOD ST
Box:City:NEWARK
State:NJ
ZIP:07105-4720
Country:US
Phone:201-589-9150
CAGE:73219

=============  Composition/Information on Ingredients  =============

Name:LITHIUM SOAP

Name:MINERAL OIL
CAS:8020-83-5
RTECS #:HF9500000

Name:ADDITIVES

Name:ZINC COMPOUNDS
< Wt:6.

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:PROLONGED OR REPEATED SKIN CONTACT MAY
    CAUSE SKIN IRRITATION. PRODUCT CONTACTING THE EYES MAY CAUSE EYE
    IRRITATION. HUMAN HEALTH RISKS VARY FROM PERSON TO PERSON. AS A
    PRECAUTION, EXPOSURE TO LIQUIDS,  VAPORS, MISTS AND FUMES SHOULD BE
    MINIMIZED. THIS PRODUCT HAS A LOW ORDER OF ACUTE ORAL TOXICITY, BUT
    MINUTE AMOUNTS ASPIRATED INTO THE LUNGS DURING INGESTION MAY CAUSE
    MILD TO SEVERE PULMONARY INJUR Y. THRESHOLD LIMIT VALUE: 5 MG/M3
    FOR OIL MIST IN AIR. OSHA REGULATION 29 CFR 1910.1000.
Effects of Overexposure:SEE HEALTH HAZARDS.

=======================  First Aid Measures  =======================

First Aid:EYE CONTACT: FLUSH WITH CLEAR WATER FOR AT LEAST 15 MINUTES
    OR UNTIL IRRITATION SUBSIDES. IF IRRITATION PERSISTS, CONSULT A
    PHYSICIAN. SKIN CONTACT: REMOVE ANY CONTAMINATED CLOTHING AND WASH
    WITH SOAP  AND WARM WATER. IF INJECTED BY HIGH PRESSURE UNDER SKIN,
    REGARDLESS OF THE APPEARANCE OF ITS SIZE, CONTACT A PHYSICIAN
    IMMEDIATELY. DELAY MAY CAUSE LOSS OF AFFECTED PART OF THE BODY.
    INHAL: VAPOR PRE SSURE IS VERY LOW AND INHALATION AT ROOM
    TEMPERATURE IS NOT A PROBLEM. IF OVERCOME BY VAPOR FROM HOT
    PRODUCT, IMMEDIATELY REMOVE FROM EXPOSURE AND CALL A PHYSICIAN.
    INGEST: IF INGESTED, CALL A PHYSICI AN IMMEDIATELY. DO NOT INDUCE
    VOMITING.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:=204.4C, 400.F
Lower Limits:0.9%
Upper Limits:7.0%
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE OR WATER SPRAY
    (FOG).
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
    EQUIPMENT . COOL EXPOSED CONTAINERS WITH WATER.
Unusual Fire/Explosion Hazard:DO NOT STORE OR MIX WITH STRONG OXIDANTS.
    EMPTY CONTAINERS RETAIN RESIDUE. DO NOT CUT, DRILL, GRIND OR WELD
    AS THEY MAY EXPLODE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SCRAPE UP GREASE, WASH REMAINDER WITH SUITABLE
    PETROLEUM SOLVENT OR ADD ABSORBENT. KEEP PETROLEUM PRODUCTS OUT OF
    SEWERS AND WATER COURSES. ADVISE AUTHORITIES IF PRODUCT HAS ENTERED
    OR MAY ENTER SEWER S AND WATER COURSES.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP CONTAINERS CLOSED WHEN NOT IN
    USE. DO NOT HANDLE OR STORE NEAR HEAT, SPARKS, FLAME OR STRONG
    OXIDANTS.
Other Precautions:REMOVE OIL-SOAKED CLOTHING AND LAUNDER BEFORE REUSE.
    CLEANSE SKIN THOROUGHLY AFTER CONTACT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NORMALLY NOT NEEDED. USE NIOSH APPROVED
    RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:LOCAL EXHAUST: USED TO CAPTURE FUMES AND VAPORS. SPECIAL:
    N/A. OTHER: N/A.
Protective Gloves:USE OIL-RESISTANT GLOVES.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYE WASH AND DELUGE SHOWER MEETING ANSI
    DESIGN CRITERIA . USE OIL-RESISTANT APRON, IF NEEDED.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:>287.8C, 550.F
Melt/Freeze Pt:M.P/F.P Text:SEMI-SOLID
Vapor Pres:<0.01 MM HG
Vapor Density:>5 (AIR=1)
Spec Gravity:0.95-0.98 (H*2O=1)
Evaporation Rate & Reference:<0.01 (BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK GREASE WITH MINERAL ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDANTS LIKE LIQUID CHLORINE, CONCENTRATED OXYGEN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:IF INCOMPLETE COMBUSTION, CARBON
    MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:ASSURE CONFORMITY WITH APPLICABLE DISPOSAL
    REGULATIONS. DISPOSE OF ABSORBED MATERIAL AT AN APPROVED WASTE
    DISPOSAL FACILITY OR SITE.

=====================  Regulatory Information  =====================

SARA Title III Information:SARA/TITLE III, SECTION 313 STATUS - ZINC
    COMPOUNDS - <6%.
Federal Regulatory Information:USDA AUTHORIZATION: H-2. NOT A
    CONTROLLED PRODUCT UNDER (WHMIS) - CANADA.

=======================  Other Information  =======================

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***