=====================  Product Identification  =====================

MSDS NAME:MIL-C-22750E #36440 EPOXY F-09P328
NIIN:01-316-3042
Status Code:A
MSDS Number: CLFGB
=== Responsible Party ===
Company:SHERWIN-WILLIAMS, SEAGUARD
Address:3560 ELM AVE.
City:PORTSMOUTH
State:VA
ZIP:23704
Country:US
Info Phone Num:757-397-2223
Emergency Phone Num:(800)424-9300
Preparer's Name:HENRY SIMMONS
Chemtrec Ind/Phone:(800)424-9300
CAGE:60163
=== Contractor Identification ===
Company:SHERWIN-WILLIAMS, SEAGUARD
Address:3560 ELM AVE.
Box:City:PORTSMOUTH
State:VA
ZIP:23704
Country:US
Phone:757-397-2223
CAGE:60163

=============  Composition/Information on Ingredients  =============

Name:TITANIUM DIOXIDE
CAS:13463-67-7
RTECS #:XR2275000
= Wt:35.
OSHA PEL:15 MG/M3
ACGIH TLV:10 MG/M3

Name:SILICON DIOXIDE
= Wt:15.

Name:AROMATIC HYDROCARBON 150
= Wt:5.

Name:METHYL ETHYL KETONE
CAS:78-93-3
RTECS #:EL6475000
= Wt:20.
OSHA PEL:590 MG/M3;200 PPM
ACGIH TLV:590 MG/M3;200 PPM
ACGIH STEL:885 MG/M3;300 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Name:EPOXY RESIN
= Wt:35.

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Effects of Overexposure:INHALATION; IRRITATION TO RESPIRATORY TRACT,
    HEADACHE, DIZZINESS AND NAUSEA. SKIN CONTACT: PRIMARY IRRITATION.
    EYE CONTACT: PRIMARY IRRITATION.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
    SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
    PRODUCT.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE TO FRESH AIR, RESTORE BREATHING. CONSULT A
    PHYSICIAN. SKIN CONTACT. FLUSH WITH WATER. EYE CONTACT: FLUSH
    IMMEDIATELY WITH LARGE AMOUNTS OF WATER. CONSULT A PHYSICIAN.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:=-3.7C, 25.F
Lower Limits:0.9%
Upper Limits:7.0%
Extinguishing Media:FOAM, WATER FOG, DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO COOL CLOSED CONTAINERS TO
    PREVENT PRESSURE BUILD-UP AND POSSIBLE AUTOIGNITION OR EXPLOSION
    WHEN EXPOSED TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
    FROM HEAT, SPARKS, AND OPEN FLAME. CLOSED CONTAINER MAY EXPLODE
    WHEN EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
    VENTILATION. AVOID SPARKS, FLAMES, AND ANYTHING WHICH COULD CAUSE
    FIRE.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN A COOL DRY AREA WITH
    VENTILATION SUITABLE FOR STORING MATERIAL SHOWN IN SECTION II.
Other Precautions:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
    DESIGNED AREAS ONLY.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NIOSH/OSHA APPROVE RESPIRATOR TYPES SUITABLE FOR
    MATERIALS IN SECTION II RECOMMENDED/ APPROVED CHEMICAL/MECHANICAL
    FILTERS RECOMMENDED WHEN VENTILATION IS RESTRICTED. APPROVED
    AIRLINE TYPE RESPIRATOR  OR HOODS RECOMMENDED IN CONFINED AREAS.
Ventilation:SUFFICIENT VENTILATION, IN VOLUME AND PATTERN, SHOULD BE
    PROVIDED TO KEEP AIR CONTAMINATION BELOW CURRENT APPLICABLE OSHA
    PERMISSIBLE LIMIT.
Protective Gloves:RECOMMENDED FOR PROLONGED OR REPEATED CONTACT.
Eye Protection:CHEMICAL GOGGLES WITH SIDE SHIELDS OR FACE SHIELD
    RECOMMENDED.
Other Protective Equipment:USE PROTECTIVE CREAMS WHERE SKIN CONTACT IS
    LIKELY. REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
    DESIGNATED AREAS ONLY.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:=79.4C, 175.F
B.P. Text:175-410F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:GRAY LIQUID AND KETONE SOLVENT ODOR
Percent Volatiles by Volume:20.7%

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:AS WITH ANY OTHER ORGANIC MATERIAL,
    COMBUSTION WILL PRODUCE CARBON DIOXIDE AND PROBABLY CARBON
    MONOXIDE.
Hazardous Decomposition Products:OXIDIZING MATERIAL CAN CAUSE A
    VIGOROUS REACTION.

====================  Disposal Considerations  ====================

Waste Disposal Methods:SOAK LIQUIDS WITH SAWDUST OR RAGS AND REMOVED.
    FLUSH WITH WATER IF POSSIBLE. AVOID SKIN CONTACT. DISPOSAL SHOULD
    BE MADE IN ACCORDANCE WITH LOCAL, STATE, FEDERAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***