===================== Product Identification =====================
MSDS NAME:SE-FLY-GO DRY (0377)
NIIN:00N009111
MSDS Number: BGXMD
=== Responsible Party ===
Company:SELIG CHEMICAL INDUSTRIES (NATIONAL SERVICE IND.)
Address:840 SLIG DRIVE, S.W.
City:ATLANTA
State:GA
ZIP:30378
Info Phone Num:404-691-9220 (8AM-5PM,EASTERN TIME)
Emergency Phone Num:LOCAL POISON CTR;CHEMTRC-8004249300
CAGE:86938
=== Contractor Identification ===
Company:SELIG CHEMICAL INDUS, DIV OF NATIONAL SERVICE INDUS
Address:840 SELIG DR SW
Box:City:ATLANTA
State:GA
ZIP:30378
Country:US
Phone:404-691-9220
CAGE:86938
============= Composition/Information on Ingredients =============
Name:PYRETHRUM (SARA III)
CAS:8003-34-7
RTECS #:UR4200000
Fraction by Wt: <1%
Other REC Limits:N/K
OSHA PEL:5 MG/M3
ACGIH TLV:5 MG/M3; 9192
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB
Name:PETROLEUM DISTILLATE
CAS:64742-47-8
Fraction by Wt: >1%
Other REC Limits:N/K
OSHA PEL:N/K
ACGIH TLV:N/K
Name:PROPELLANT:C3-34 ALKANE BLEND.
CAS:68475-59-2
Fraction by Wt: >1%
Other REC Limits:N/K
OSHA PEL:N/K
ACGIH TLV:N/K
===================== Hazards Identification =====================
LD50 LC50 Mixture:N/K
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SEE SIGNS AND SYMPTOMS OVEREXPOSURE .
Explanation of Carcinogenicity:NONE
Effects of Overexposure:EYES:CAN BE IRRITATING UPON CONTACT.SKIN*CAN
CAUSE IRRITATION UPON PROLONGED CONTACT.INGESTION:CAN CAUSE NAUSEA
AND VOMITING.INHALATION:CAN CAUSE DIZZINESS,NAUSEA AND HEADACHE
UPON PROLONGED EXPOSURE.
Medical Cond Aggravated by Exposure:N/K
======================= First Aid Measures =======================
Eyes:FLUSH IMMEDIATE WITH PLENTY OF WATER FOR AT LEAST 15
MINUTES.CONSULT PHYSICIAN.SKIN:WASH WITH SOAP AND
WATER.INGESTION:GIVE PLENTY OF WATER.DO NOT INDUCE VOMITING.SEEK
MEDICAL ATTENTION IMMEDIATE LY.INHALATION:MOVE TO FRESH AIR.GIVE
OXYGEN IF NEEDED.SEE DOCTOR.
===================== Fire Fighting Measures =====================
Flash Point:SPRAY
Lower Limits:1.0
Upper Limits:6.0
Extinguishing Media:FOAM,CARBON DIOXIDE,DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .WATER SPRAY ON CANS PREVENT BURSTING.
Unusual Fire/Explosion Hazard:WH EN AEROSOLS ARE EXPOSED TO
TEMPERATURES ABOVE 120F.49C CANS MAY BURST,HAZARDOUS DECOMPOSITION
PRODUCTS:CARBON MONOXIDE MAY RESULT FROM INCOMPLETE COMBUSTION.
================== Accidental Release Measures ==================
Spill Release Procedures:LARGE SPILLS ARE UNLIKELY DUE TO AEROSOL
PACKAGING IF SPILLED.ABSORBED W/ ABSORBENT (I.E. SELIG'S AP
ABSORBENT).PICK UP & DEPOSIT IN SUITABLE WASTE RECEPTACLE OR FLUSH
TO DRAIN W/ PLENTY OF H*2O.CLEAN THOROUGHLY W/ SUITABLE
DETERGENT.RINSETHOROUGHLY
Neutralizing Agent:.N/K
====================== Handling and Storage ======================
Handling and Storage Precautions:KEEP OUT OF REACH OF CHILDREN.AVOID
CONTACT WITH SKIN AND EYES.DO NOT USE,STORE,POUR OR SPILL NEAR HEAT
SOURCE OR OPEN FLAME.
Other Precautions:HARMFUL IF FOLLOW.AVOID PROLONGED EXPOSURE TO
VAPORS.CONTAINER MAY BURST IF HEATED ABOVE 120F.49C.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:LOCAL AND GENERAL VENTILATION NECESSARY TO KEEP AIR
CONCENTRATION BELOW TLV .
Protective Gloves:NONE.BUT AVOID SKIN CONTACT.
Eye Protection:CHEMICAL WORKERS GOGGLES
Other Protective Equipment:NONE
Work Hygienic Practices:N/K
Supplemental Safety and Health
VP:0.2 MMHG AT 68F.20C.MANUFACTURER RECOMMENDED LIMIT FOR MIXTURE:500
PPM (EST.)
================== Physical/Chemical Properties ==================
Boiling Pt:B.P. Text:350F (INIT)
Melt/Freeze Pt:M.P/F.P Text:N/K
Decomp Temp:Decomp Text:N/K
Vapor Pres:SEE SUPP
Vapor Density:6.0 AIR=1
Spec Gravity:0.816 (WATER=1)
Evaporation Rate & Reference:0.01 (BUTYL ACETATE=-)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR,YELLOW LIQUID,PLEASANTLY SCENTED.
Percent Volatiles by Volume:100
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
NONE
Stability Condition to Avoid:NONE
Hazardous Decomposition Products:INCOMPLETE COMBUSTION YIELD CARBON
MONOXIDE.
Conditions to Avoid Polymerization:WILL NOT OCCUR.
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH
FEDERAL,STATE AND LOCAL REGULATIONS .REPLACE CAP AND DISCARD IN
TRASH.DO NOT PUNCTURE OR INCINERATE.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|