Material Safety Data Sheet
Product Catalog Number: 55115 Note: Note: All human components used in the
manufacture of this kit have been tested by FDA approved
detection methods for Hepatitis B Surface Antigen
Name (on Label): Envoy庐 500 LDL Calibrator Kit
(HBsAG), Hepatitis C (HCV), and human
Immunodeficiency Virus (HIV) antibodies and were found
to be negative or non-reactive. WARNING: Since no test
method can assure that products derived from human
blood do not contain infectious agents, calibrators,
controls, and patient samples should be handled as
though capable of transmitting infectious diseases.
Section I 鈥? NAME AND PRODUCT
Manufacturer's Name: Vital Diagnostics, Inc. Emergency Telephone Number:
1-760-602-8700
Address: 27 Wellington Road Telephone Number for Information:
Lincoln, RI 02865 1-401-642-8400; 1-800-345-2822
Date Prepared:
8/18/07
Section II - Hazard Ingredients/Identity Information
NFPA OSHA
Hazardous Components CAS # Health Fire Reactivity Conc. TLV
% (WT) PEL
Sodium azide 26628-22-8 N/A <0.1% N/A
N/A N/A N/A 20 mg/kg
Human Serum N/A N/A N/A N/A
N/A N/A N/A N/A
PEL: Permissible Exposure Limit established by the Occupational Safety and Health Administration (OSHA).
TLV: Threshold Limit Value established by the American Conference of Governmental Industrial Hygienists, 1986-87.
Section III - Physical/Chemical Characteristics
Boiling Point: N/A Specific Gravity (H2O = 1): N/A
Vapor Pressure (mm Hg.): N/A Melting Point: N/A
Vapor Density (AIR = 1): N/A Evaporation Rate:
(Butyl Acetate = 1)
Solubility in Water: Soluble in water Other Physical Data: N/A
Appearance and Odor: Pale yellow powder
Section IV - Fire and Explosion Hazard Data
Flash Point (Method Used): N/A Flammable Limits
Lower Explosive Limit: Upper Explosive Limit:
N/A
N/A
Extinguishing Media: Water, CO2, Chemical Foam
Special Fire Fighting Procedures: None.
Unusual Fire and Explosion Hazards: None.
MSDS-55115, Revision C
DCO: 07-202
Page 1 of 3
Material Safety Data Sheet
Section V - Reactivity Data
Stability: Unstable Conditions to Avoid: Excessive heat may damage
the material. Avoid contact with heavy metals or
Stable X
acids.
Incompatibility (Materials to Avoid): Acid chlorides, nitrogen oxides, and heavy metals
Hazardous Decomposition or Byproducts: NO2, NO
Hazardous Polymerization May Occur Conditions to Avoid: N/A
Will Not Occur X
Section VI - Health Hazard Data
Route(s) of Entry: Inhalation: Yes Skin: Yes Ingestion: Yes
Health Hazards (Acute and Chronic):
Chronic: N/A
Acute: N/A
Carcinogenicity: NTP: N/A IARC Monographs: OSHA Regulated: N/A
N/A
Signs and Symptoms of Exposure: N/A
Medical Conditions Generally Aggravated by Exposure: N/A
Emergency and First Aid Procedures:
Ingestion: If this product is swallowed, CALL PHYSICIAN OR POISON CONTROL CENTER FORMOST
CURRENT INFORMATION. If professional advice is not available, do not induce vomiting. Never induce
vomiting or give diluents (milk or water) to someone who is unconscious, having convulsions, or unable to
swallow. If vomiting occurs, lean patient forward or place on left side (head-down position, is possible) to
maintain an open airway and prevent aspiration.
Skin: In case of contact with skin, remove contaminated clothing and flush the area with copious
amounts of water.
Eyes: In case of contact with the eyes, remove contact lenses and flush the area with copious amounts of
water for a minimum of 15 minutes. Assure adequate flushing of the eye by separating the eyelids with
fingers. Call a physician.
Inhalation: If inhaled, remove to fresh air. If breathing becomes difficult, call a physician.
Section VII - Precautions for Safe Handling and Use
Steps to Be Taken in Case Material is Released or Spilled: Wear protective equipment. Contain spill
with absorbent material and place in container for disposal. Ventilate area and wash spill site after
pickup is complete.
Waste Disposal Method: Disposal should be made in accordance with existing disposal practices
employed at your institution. Explosive metal azides may be formed on contact with copper or lead
plumbing; take appropriate precautions. Observe all federal, state, and local laws.
Precautions to Be taken in Handling and Storing: Store tightly closed in a cool, dry place with
adequate ventilation. Long-term storage at 2-8掳C is recommended. Avoid prolonged exposure to direct
sunlight.
Other Precautions: None.
MSDS-55115, Revision C
DCO: 07-202
Page 2 of 3
Material Safety Data Sheet
Section VIII - Control Measures
Respiratory Protection (Specify Type): Wear protective mask.
Ventilation: Local Exhaust: Work in a Protective Gloves: Rubber or latex gloves.
mechanically exhausted area.
Mechanical (General): N/A Eye Protection: Wear safety glasses or goggles.
Special: N/A Other Protective Clothing or Equipment: Lab
coat or other long sleeved garment.
Other: N/A Work/Hygienic Practices: N/A
Section IX 鈥? Other Information
Miscellaneous Information: N/A
The information contained in this document is believed to be factual, however, nothing presented herein is
to be taken as a warranty or representation for which Clinical Data shall be liable.
MSDS-55115, Revision C
DCO: 07-202
Page 3 of 3
|