Ablebond 2025 Page 1 of 3
August 27,2000
MATERIAL SAFETY DATA SHEET
===================================================================================================
TRADE NAME: Ablebond 2025
IDENTITY: Ablebond 2025
CHEMICAL FAMILY: Modified Diester Resin
__________________________________________________________________________________________________
SECTION I - MANUFACTURER'S INFORMATION FOR INFORMATION: 310 - 764 - 4600
Ablestik Laboratories RECORD NUMBER:
20021 Susana Road PREPARED BY: Carolina Fabiero
Rancho Dominguez CA 90221 DATE PREPARED: 02/20/2001
TELEPHONE: 310-764-4600 PRIOR REVISION: 8/27/2000
LAST REVISION DATE: 10/25/02; section III;
12/03/02; section IX
24 HOUR EMERGENCY # CHEMTREC: 1-800-424-9300
___________________________________________________________________________________________________
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
EPOXY RESIN
CAS NO: * ACGIH TLV: Not Determ. PERCENTAGES:
OSHA PEL: Not Determ. OTHER LIMITS: Not Determ. 1.0 to 10.0
DIESTER
CAS NO: * ACGIH TLV: Not Determ. PERCENTAGES:
OSHA PEL: Not Determ. OTHER LIMITS: Not Determ. 20.0 to 35.0
FUNCTIONALIZED ESTERS
CAS NO: * ACGIH TLV: Not Determ. PERCENTAGES:
OSHA PEL: Not Determ. OTHER LIMITS: Not Determ. 5.0 to 15.0
POLYMERIC RESIN
CAS NO: * ACGIH TLV: Not Determ. PERCENTAGES:
OSHA PEL: Not Determ. OTHER LIMITS: Not Determ. 1.0 to 5.0
FUSED SILICA
CAS NO: 60676860 ACGIH TLV: 0.1mg/m3 PERCENTAGES:
OSHA PEL: Listed below OTHER LIMITS: Not Determ. 45.0 to 60.0
SPECIAL INSTRUCTIONS: OSHA 鈥? PEL: TWA..... 5 mg/m3(Respirable Fraction)
OSHA 鈥? PEL: TWA......15mg/m3(Total Dust)
This product contains wetted silica If the cured adhesive is to be sanded or
ground, wet sanding is recommended to eliminate airborne dust. Respiratory
protection is also recommended.
* Information Withheld For Trade Secret
__________________________________________________________________________________________________
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS SPECIFIC GRAVITY: 1.4 (H20 = 1)
BOILING POINT: NOT AVAILABLE VOC CONTENT: NOT AVAILABLE
VAPOR PRESSURE: NOT AVAILABLE EVAPORATION RATE: NOT AVAILABLE
VAPOR DENSITY (AIR=1): NOT APPLICABLE MELTING POINT: NOT APPLICABLE
SOLUBILITY IN WATER: Insoluble
APPEARANCE AND ODOR: Yellow Paste
__________________________________________________________________________________________________
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: NOT AVAILABLE FLAMMABLE LIMITS (LEL): NOT AVAILABLE
FLASH POINT METHOD: (UEL): NOT AVAILABLE
Not Applicable
EXTINGUISHING MEDIA: Carbon dioxide, foam and dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: Wear self-contained breathing apparatus and
appropriate personal protective equipment to avoid contact.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Decomposition and combustion products may be
toxic.
Ablebond 2025 Page 2 of 3
August 27,2000
_________________________________________________________________________________________________
SECTION V - REACTIVITY DATA
STABILITY: STABLE? Y
CONDITIONS TO AVOID: Heat prior to cure.
INCOMPATIBILITY (MATERIALS TO AVOID): Strong oxidizing agents, acids, and bases.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: Carbon monoxide, carbon dioxide, oxides of
nitrogen and unidentified organics.
HAZARDOUS POLYMERIZATION: MAY OCCUR? N
CONDITIONS TO AVOID: Excessive heat. Violent chemical reaction may occur if large
volumes of adhesive are cured. Product should be used with caution during curing and
ovens should be vented to the outside.
___________________________________________________________________________________________________
SECTION VI - HEALTH HAZARD DATA
ROUTES OF ENTRY: EYE? N INHALATION? Y SKIN? Y INGESTION? N
INHALATION: Irritating and/or toxic vapors may be released at elevated temperatures.
Avoid breathing of vapors or mists.
SKIN: Repeated or prolonged contact with skin could be severely irritating and may
cause skin damage. May cause skin sensitization, a partial or whole-body dermatitic
rash experience after exposure, however minimal.
EYES: Severely irritating. If not removed promptly, will injure eye tissue, which
May result in permanent damage.
ABSORPTION (SKIN): Harmful if absorbed through skin.
INGESTION: Irritating to mouth, throat and stomach. May cause gastric tract
disorders and/or damage.
HEALTH HAZARDS(ACUTE): See Route(s) of Entry, above.
HEALTH HAZARDS (CHRONIC): Prolonged or repeated contact can cause skin irritation
and/or sensitization.This product contains one ingredient which is positive in one
or more mutagenic assays. Target organs: eyes, skin.
CONSIDERED CARCINOGENIC BY: NTP: N IARC? N OSHA? N IARC? N
Product is not considered to be carcinogenic by NTP, ACGIH, IARC, and OSHA.
SIGNS AND SYMPTOMS OF EXPOSURE: Prolonged or repeated contact can cause skin
Irritation and/or sensitization.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Allergy, eczema or skin
conditions.
EMERGENCY AND FIRST AID PROCEDURES:
EYE CONTACT: Immediately flush eyes with large amounts of water for at least 15
Minutes lifting upper & lower lids. Get prompt medical attention.
SKIN CONTACT: Flush exposed areas thoroughly with soap and water until all chemical
Is removed. Remove contaminated clothing and launder before reuse. If irritation
persists, seek medical attention immediately.
INHALED: Remove to fresh air immediately. Seek medical attention if breathing is
difficult.
INGESTION: Treat symtomatically and supportively. Get medical attention. DO NOT
attempt to give anything by mouth to an unconscious person.
__________________________________________________________________________________________________
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Wipe up with solvent
saturated material and collect in an appropriate container for disposal. Wear
appropriate personal protective equipment.
WASTE DISPOSAL METHOD: Dispose in approved chemical disposal area or in a manner
which complies with all local, state and federal regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store frozen at -40 degree C at
All times prior to use. If the cured adhesive is to be sanded, wet sanding is
Recommended to minimize the airborne dust.
OTHER PRECAUTIONS: Avoid contact with skin, eyes and clothing. Good housekeeping
is required. Avoid inhalation of vapors.
Ablebond 2025 Page 3 of 3
August 27,2000
_______________________________________________________________________________________________
SECTION VIII - CONTROL MEASURES
RESPIRATORY PROTECTION (SPECIFY TYPE): Use NIOSH approved organic vapor respirator
if needed. If the cured adhesive is to be dry sanded or ground, use NIOSH approved
mask for toxic dust.
VENTILATION LOCAL EXHAUST: Use adequate ventilation. Local exhaust is recommended
when appropriate to control employee's exposure.
PROTECTIVE GLOVES: Rubber
EYE PROTECTION: Safety Goggles
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Protective equipment to cover exposed
areas.
HYGIENIC PRACTICES: Vent curing oven to outdoors.
__________________________________________________________________________________________________
SECTION IX - REGULATORY INFORMATION
U.N. HAZARD CLASS: Not Applicable
D.O.T. ID NO: Not Applicable
SARA/TITLE III - TOXIC CHEMICALS LIST:
This product does not contain any chemical subject to the reporting requirements of
Section 313 of Title III of Superfund Amendments and Reauthorization Act of 1986 and
40 CFR Part 372:
TSCA INVENTORY STATUS:
This product is exempted from TSCA inventory lists.
CALIFORNIA PROPOSITION 65:
W A R N I N G: This product contains the following chemicals known to the state
of California to cause cancer:
Trace amounts of Acrylonitrile, Benzene and Methylene chlride
W A R N I N G: This product contains the following chemical known to the state of
California to cause birth defects or other reproductive harm:
Trace amount of Toluene and Benzene
WHMIS classification: Class D, Division 2, Subdivision B
DISCLAIMER: THE INFORMATION GIVEN AND THE RECOMMENDATIONS MADE HEREIN APPLY TO OUR PRODUCT(S)
ALONE AND NOT IN COMBINATION WITH ANY OTHER PRODUCT(S). SUCH INFORMATION AND
RECOMMENDATIONS ARE BASED ON OUR RESEARCH AND ON DATA FROM OTHER RELIABLE SOURCES AND
ARE BELIEVED TO BE ACCURATE BUT NO GUARANTEE OF THEIR ACCURACY IS MADE. IN EVERY CASE
WE URGE AND RECOMMEND THAT PURCHASERS BEFORE USING ANY PRODUCT MAKE THEIR OWN TESTS TO
VERIFY THIS DATA UNDER THEIR OWN OPERATING CONDITIONS AND TO DETERMINE TO THEIR OWN
SATISFACTION WHETHER THE PRODUCT IS SUITABLE FOR THEIR PARTICULAR PURPOSES. THE
PRODUCT(S) DISCUSSED HEREIN ARE SOLD WITHOUT ANY WARRANTY AS TO MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED.
|