Emergency Phone:
333 Hollenbeck St.
INFOTRAC: 1-800-535-5053
Rochester NY 14621
OUTSIDE US: 1-352-323-3500
Information: 585-336-2200
MATERIAL SAFETY DATA SHEET
REVISION DATE: 03/04/2004 REVISION NUMBER: 6
DATE PRINTED: 03/04/2004 PREPARED BY: EH&S DEPARTMENT
1. CHEMICAL PRODUCT
ENVIRO CARE, Floor Finish Remover
PRODUCT NAME:
MSDS FORM NUMBER: 7103
NFPA/HMIS HAZARD CODES(minimal=0; slight=1; moderate=2; serious=3; severe=4)
Health: 1/1 Fire: 0/0
Reactivity: 0/0 Special/Protective Equipment: None/B
2. HAZARDS IDENTIFICATION
EFFECTS FROM ACUTE EXPOSURE:
INGESTION: May be harmful if swallowed. May cause irritation.
SKIN CONTACT: Mild Skin Irritation: signs/symptoms can include redness, swelling, and itching.
INHALATION: Inhalation of spray mist may be irritating.
EYE CONTACT: May cause severe eye irritation. May Cause Eye Burns.
CHRONIC EFFECTS: None known.
EFFECTS/CARCINOGENICITY: None listed under OSHA, IARC, or NTP.
ROUTES OF ENTRY: Routes of entry for solids and liquids include eye and skin contact, ingestion and inhalation.
3. COMPOSITION/INFORMATION ON INGREDIENTS
PRODUCT COMPOSITION % ACGIH TLV OSHA PELs
CAS #
2-aminoethanol lactate <5 NA NA
68815-69-0
Alkyl Amine <5 NA NA
68478-95-5
2-AMINOETHANOL <5 3 ppm 3 ppm
141-43-5 6 mg/m鲁
4. FIRST AID MEASURES
INGESTION: If swallowed, do NOT induce vomiting. Give victim two glasses of water, Call a physician immediately.
Never give anything by mouth to an unconscious person.
SKIN: Wash with soap and water. Remove contaminated clothing and launder before reuse. Get medical attention if
irritation persists.
INHALATION: If inhaled, remove from area to fresh air. Get medical attention if respiratory irritation develops or if breathing
becomes difficult.
EYES: Immediately flush eyes with large amounts of water for at least 15 minutes. Get immediate medical attention.
NOTES TO PHYSICIAN: None.
Page 1 of 4
ENVIRO CARE, Floor Finish Remover
____________________________________________________________________________________
5. FIRE AND EXPLOSION HAZARD DATA
FLASH POINT (F): None (C): NA METHOD: TCC
FLAMMABLE LIMITS IN AIR - LOWER (%): None
FLAMMABLE LIMITS IN AIR - UPPER (%): None
SENSITIVITY TO MECHANICAL IMPACT(Y/N): NO
SENSITIVITY TO STATIC DISCHARGE: Sensitivity to static discharge is not expected.
EXTINGUISHING MEDIA: As for surrounding fire. Product will not burn. Dry chemical. Foam.
Water.
FIRE FIGHTING PROCEDURES: Fire-fighters should wear self-contained breathing apparatus and full
protective clothing when fighting chemical fires. Cool exposed containers
with water spray.
6. ACCIDENTAL RELEASE MEASURES
SPILL PROCEDURES:
SMALL SPILLS: Flush with water.
LARGE SPILLS: Dike to contain, reclaim all possible. Flush remainder with water.
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN Avoid contact with skin and eyes. Use only with adequate ventilation.
IN HANDLING AND STORAGE:
OTHER PRECAUTIONS: Keep out of reach of children.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
PROTECTIVE EQUIPMENT:
EXPOSURE CONTROLS: Use in a well ventilated area.
RESPIRATORY PROTECTION: None normally required.
PROTECTIVE GLOVES: Rubber gloves.
EYE PROTECTION: Safety Glasses.
OTHER PERSONAL PROTECTION Appropriate protective clothing as needed to prevent skin contact.
EQUIPMENT:
VENTILATION: Not normally required.
9. PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE AND ODOR: Red. Liquid. Mild odor.
BOILING POINT (F): 212 F (C) NA
VAPOR PRESSURE: 15.7 mm Hg @ 22.2 C
VAPOR DENSITY (AIR=1): 0.625
SOLUBILITY IN WATER: Soluble
SPECIFIC GRAVITY: 1.00
VOC Content (%): 4.85 (EPA Method 24)
VOV Content (%): NE
EVAPORATION RATE: (BuAc=1): 1.26
PH: 9.85
Page 2 of 4
ENVIRO CARE, Floor Finish Remover
____________________________________________________________________________________
10. STABILITY AND REACTIVITY
STABILITY DATA: STABLE
POLYMERIZATION: Will Not Occur.
HAZARDOUS DECOMPOSITION: None
INCOMPATIBILITY (MATERIALS TO None
AVOID):
CONDITIONS/HAZARDS TO AVOID: None.
11. TOXICOLOGICAL INFORMATION
ACUTE TOXICITY: NE
EFFECTS OF CHRONIC EXPOSURE: NE
OTHER TOXIC EFFECTS: NE
12. ECOLOGICAL INFORMATION
ECOTOXICOLOGICAL INFORMATION: No data at this time
CHEMICAL FATE INFORMATION: No data at this time.
13. DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHODS: Dispose in accordance with Federal, State and Local regulations.
14. TRANSPORT INFORMATION
Please refer to the Bill of Lading/Receiving documents for up to date shipping information.
15. REGULATORY INFORMATION
TSCA: EINECS: Canada DSL: CA PROP 65:
PRODUCT COMPOSITION %
CAS #
2-aminoethanol lactate <5 Listed Not Listed Not Listed Not Listed
68815-69-0
Alkyl Amine <5 Listed Not Listed Not Listed Not Listed
68478-95-5
2-AMINOETHANOL <5 Listed Listed Listed Not Listed
141-43-5
SARA 302: SARA 313:
PRODUCT COMPOSITION % CERCLA:
CAS #
2-aminoethanol lactate <5 Not Listed Not Listed Not Listed
68815-69-0
Alkyl Amine <5 Not Listed Not Listed Not Listed
68478-95-5
2-AMINOETHANOL <5 Not Listed Not Listed Not Listed
141-43-5
Canada WHMIS:
PRODUCT COMPOSITION %
CAS #
Page 3 of 4
ENVIRO CARE, Floor Finish Remover
____________________________________________________________________________________
2-AMINOETHANOL <5 B3; E
141-43-5
The following components of this material are included in the Massachusetts Substance List and are present at or above reportable
levels.
MARTK:
PRODUCT COMPOSITION %
CAS #
2-AMINOETHANOL <5 Listed
141-43-5
The following components of this material are included in the New Jersey Substance List and are present at or above reportable
levels.
NJRTK:
PRODUCT COMPOSITION %
CAS #
2-AMINOETHANOL <5 Listed
141-43-5
The following components of this material are included in the Pennsylvania Substance List and are present at or above reportable
levels.
PARTK:
PRODUCT COMPOSITION %
CAS #
2-AMINOETHANOL <5 Listed
141-43-5
16. OTHER INFORMATION
Health and safety information presented on this form is generally applicable at recommended dilutions, varying only in degree. This
information was complied from current, reliable sources and is believed to be correct. As data, and/or regulations change, and
conditions of use and handling are beyond our control, no warranty, express or implied, is made as to completeness or continuing
accuracy of this information.
*** END OF MSDS ***
Page 4 of 4
|