Material Safety Data Sheet HMIS庐
May be used to comply with OSHA's HEALTH 2 REACTIVITY 0
Hazard Communication Standard,
29 CFR 1910.1200. Standard must be PERSONAL PROTECTION
FLAMMABILITY 2 B
consulted for specific requirements.
Note: Blank spaces are not permitted. If any item is not applicable, or no
Identity (As Used on Label and List) information is available, the space must be marked to indicate that.
90101, 90130 SCRUBS庐 Graffiti & Spray Paint Remover
SECTION I
Manufacturer's Name Emergency Telephone Number
ITW Dymon 1-800-535-5053
Address (Number, Street, City, State, and ZIP Code) Telephone Number for Information
805 E. 56 Highway 1-913-397-9889
Date Prepared
Olathe, KS 66061 July 16, 2001
Signature of Preparer (Optional)
Regulatory Dept.
SECTION II - Hazardous Ingredients/Identity Information
Hazardous Components (Specific Other Limits
Chemical Identity, Common Name(s)) CAS No. OSHA PEL ACGIH-TLV Recommended % (Opt.)
*Butoxyethanol (skin designation) 111-76-2 50 ppm 25 ppm 10 - 30 %
Amyl acetate 628-63-7 100 ppm 100 ppm 7 - 13 %
Methoxyisopropanol 107-98-2 100 ppm 100 ppm STEL 150 ppm 15 -40 %
* This product contains Butoxyethanol (a glycol ether compound) which is listed and may require reporting under SARA
Title III Sec. 313 if used over the threshold reporting quantity. This information must be included in all MSDSs that are
copied and distributed for this material.
TSCA: All ingredients are on the TSCA inventory or are not required to be listed on the TSCA inventory.
Any substance listed as hazardous by the States of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or
Texas is described above if known present in regulated concentrations.
SECTION III Physical/Chemical Characteristics
Boiling Point Approx. Specific Gravity (H2O = 1)
212o F @70o F
Concentrate - Initial 0.974
Vapor Pressure (mm-Hg @ 70o F) Melting Point
No Data No Data
Vapor Density (AIR = 1) Greater than Evaporation Rate (Butyl Acetate = 1)
one (1) No Data
Solubility in Water pH
7.0 卤 0.5
Partial
Appearance and Odor -
Clear colorless liquid with a banana and/or floral scent on a towel.
SECTION IV - Fire and Explosion Hazard Data
Flash Point (Method Used) Flammable Limits LEL UEL
No Data No Data No Data
136掳 F (TCC): liquid phase
Extinguishing Media -
Use carbon dioxide, dry chemical, foam or fog. Large spills may cause a floating fire to form as if an oil fire.
Special Fire Fighting Procedures - Keep containers cool and vapors down with water spray. Prevent runoff from entering sewers and public
waterways. Wear SCBA in chemical fires.
Unusual Fire and Explosion Hazards -
Combustible liquid on a plastic towel.
90101, 90130 July 16, 2001
SECTION V - Reactivity Data
Stability Unstable Conditions to Avoid - Heat, sparks, open flames
Stable X
Incompatibility (Materials to Avoid) - Strong alkalies, acids and oxidizers and heat.
Hazardous Decomposition or Byproducts - Carbon dioxide, carbon monoxide, smoke and soot and various organic oxidation by-products.
Hazardous May Occur Conditions to Avoid - None known
Polymerization Will Not Occur X
SECTION VI - Health Hazard Data
Route(s) of Entry Eyes? Inhalation? Skin? Ingestion?
Yes Yes Yes Yes
Health Hazards (Acute and Chronic ) - Warning. Combustible liquid. Causes eye and skin irritation. May be harmful or fatal if swallowed
(aspiration hazard). Harmful if absorbed through intact skin. May be harmful if inhaled. Repeated or prolonged occupational overexposure can
cause dermatitis, severe skin irritation or Painter's syndrome. Overexposure to vapors may induce central nervous system effects. Follow good
chemical hygiene practices to avoid these hazards.
Carcinogenicity: NTP? IARC Monographs? OSHA Regulated?
None known No No No
WARNING: This product may contain trace chemicals known to the State of California to cause cancer.
Signs and Symptoms of Exposure - Redness, tearing and burning in eyes. Redness drying and cracking skin. Swallowing, overexposure to
vapors or skin absorption may cause drowsiness, dizziness, fatigue, loss of coordination. Inhalation of excessive amounts of vapors may irritate
nose, throat and upper respiratory tract. Follow good chemical hygiene practices to avoid these hazards.
Medical Conditions Generally Aggravated by Exposure -
Pre-existing skin, lung, kidney, liver and blood conditions could be aggravated by overexposure and misuse.
Emergency and First Aid Procedures: Eyes - Flush with plenty of water for at least 15 minutes lifting eyelids to insure complete removal. See
a physician immediately. Ingestion - Call a physician or poison control center immediately. Aspiration hazard. Inhalation - Get to fresh air. If
breathing has stopped, qualified personnel should administer artificial respiration. Skin - Flush with plenty of water for at least 15 minutes. If
irritation arises and persists, call a physician.
SECTION VII - Precautions for Safe Handling and Use
Steps to be Taken in Case Material is Released or Spilled -
Caution, slip hazard. Allow material to dry before foot traffic is allowed on wetted area. For large spills, isolate and ventilate area. Eliminate all
ignition sources. Wear protective gear as necessary. Dike to prevent spread if free liquid is created. Pick up with a vacuum or an absorbent
material or allow to air dry. Put in a suitable container for proper disposal.
Waste Disposal Method -
Consult local, state, and federal regulations. Triple rinse empty container then offer for recycling, reuse, or reconditioning.
Precautions to be Taken in Handling and Storing -
Do not use around ignition sources such as heat, sparks, flame, static electricity, welding arcs, etc. Do not get in eyes, on skin or clothing. Wash
thoroughly after handling. Do not swallow. Do not smoke while using. Avoid inhaling vapors. Use with adequate ventilation. Store in a cool
dry location away from heat, sparks, open flame, etc.
Other Precautions - Follow label directions carefully. Keep out of reach of children. Keep container tightly sealed when not in use. Do not
contaminate water, food or feed by use or storage. Do not deliberately concentrate and inhale vapors.
SECTION VIII - Control Measures
Respiratory Protection (Specify Type) - Not usually necessary. Use with adequate ventilation. Use NIOSH/MSHA approved respirator if PELs
or TLVs are exceeded.
Ventilation Local Exhaust Not usually needed Special None
Mechanical (General) Yes Other None
Protective Gloves - Eye Protection -
Yes, impervious Yes, goggles or approved safety glasses (ANSI Z87)
Other Protective Clothing or Equipment -
Not usually necessary. Avoid direct contact. Wear apron, boots, face shield, etc. if needed.
Work/Hygienic Practices -
Normal. Wash hands after use and before eating, drinking, smoking, using restrooms, etc.
WARNING! The use of this product is beyond the control of the manufacturer; therefore, no guarantee, expressed or implied, is made as to the effects of such or the results to be obtained if not used in accordance with directions or established safe
practice. The user must assume all responsibility, including injury or damage, resulting from its misuse as such, or in combination with other materials.
The manufacturer warrants only that this product meets the manufacturer's specifications for such product. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, AS TO DESCRIPTION , QUALITY, MERCHANTABILITY,
FITNESS FOR ANY PARTICULAR PURPOSE, PRODUCTIVENESS, OR ANY OTHER MATTER, OF THIS PRODUCT. THE MANUFACTURER SHALL BE IN NO WAY RESPONSIBLE FOR THE PROPER USE OF THIS PRODUCT. The sole and exclusive remedy
against the manufacturer for breach of warranty shall be reimbursement of the purchase price of the product in the event that a defective condition of the product shall be found to exist. NO OTHER REMEDY (INCLUDING BUT NOT LIMITED TO INCIDENTAL
OR CONSEQUENTIAL DAMAGES FOR INJURY TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL LOSS) SHALL BE AVAILABLE.
|