MSDS No.: 255
Revision No.: 005
Revision Date: 11/7/00
庐 Page: 1 of 2
MATERIAL SAFETY DATA SHEET
Product name: HIT HY 150
Methacrylate resin and hardener. Part A is in the large tube; Part B is in the small one.
Description:
Hilti, Inc. P.O. Box 21148, Tulsa, OK 74121
Supplier:
1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries)
Emergency # (Chem-Trec.):
INGREDIENTS AND EXPOSURE LIMITS
Ingredients: CAS Number: TLV: PEL: STEL:
NJ TSRN: 19136100-5001 NE NE NE
Part A: Resin
Methacrylate ester NJ TSRN: 19136100-5005 NE NE NE
Hydroxypropyl methacrylate 27813-02-1 NE NE NE
3
0.1 mg/m3 (R)
Quartz sand 14808-60-7 0.05 mg/m (R) NE
3
Bonding agent NJ TSRN: 19136100-5003 10 mg/m (N) NE NE
3
Synthetic amorphous silica 67762-90-7 2 mg/m NE NE
0.05 mg/m3 (R) 0.1 mg/m3 (R)
14808-60-7 NE
Part B: Quartz sand
Water 07732-18-5 NE NE NE
3
5 mg/m3
Dibenzoyl peroxide 00094-36-0 5 mg/m NE
3
Amorphous silica 07631-86-9 10 mg/m (N) 20 mppcf NE
Dipropylene glycol 25265-71-8 NE NE NE
Polyethylene 09002-88-4 NE NE NE
Abbreviations: NJ TSRN indicates New Jersey Trade Secret Registry Number. (R) indicates 鈥渁s respirable dust鈥?. (N) indicates 鈥渁s
nuisance dust鈥?. PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. STEL = Short Term Exposure
Limit (15 minute time-weighted average). NE = None Established. mppcf = million particles per cubic foot.
PHYSICAL DATA
Gray paste Ester-like odor
Appearance: Odor:
Not determined Not applicable
Vapor Density: (air = 1) Vapor Pressure:
Approx. 212潞 F 0 g/l
Boiling Point: VOC Content:
Not applicable Part A is insoluble
Evaporation Rate: Solubility in Water:
1.7 6-7
Specific Gravity: pH:
FIRE AND EXPLOSION HAZARD DATA
Not applicable
Flash Point: Flammable Limits:
> 200掳 F
CO2, Dry Chemical, Foam, Water
Extinguishing Media:
Soak cartons to help prevent the spread of fire. Use a self-contained breathing apparatus when
Special Fire Fighting
fighting fires involving chemicals.
Procedures:
None known. Thermal decomposition products can be formed.
Unusual Fire and Explosion
Hazards:
REACTIVITY DATA
Dibenzoyl peroxide decomposes (non-violently) at 150潞 F. Ignition does not occur due to the
Stability:
water content (> 5%).
Will not occur.
Hazardous Polymerization:
Strong acids and oxidizing agents. Do not store in direct sunlight.
Incompatibility:
Thermal decomposition can yield CO, CO2 and NOx.
Decomposition Products:
Avoid temperature extremes which could shorten the shelf-life of this product; i.e. below freezing
Conditions to Avoid:
and above 100潞 F. (See handling and storage requirements).
HEALTH HAZARD DATA
Eye and skin irritation. Possible sensitizer.
Known Hazards:
Signs and Symptoms of Eyes: can cause irritation. Skin: Prolonged and repeated contact can cause irritation. An
Exposure: allergic skin reaction (e.g. rash, itching, reddening) can occur with some individuals. Inhalation:
Possible irritation. Ingestion: Not a likely route of exposure. Considered to have a low acute
oral toxicity.
Contact. Inhalation.
Routes of Exposure:
IARC classifies crystalline silica (quartz sand) as a Gp I carcinogen based upon evidence among
Carcinogenicity:
HILTI 庐 is a registered trademark of Hilti Corp.
workers in industries where there has been long-term and chronic exposure (via inhalation) to
silica dust; e.g. mining, quarry, stone crushing, refractory brick and pottery workers. This product
does not pose a dust hazard; therefore, this classification is not relevant.
Eye, skin, and respiratory conditions.
Medical Conditions
Aggravated by Exposure:
EMERGENCY AND FIRST AID PROCEDURES
Flush with plenty of water. Call a physician if symptoms occur.
Eyes:
Wash with soap and water.
Skin:
Move victim to fresh air. Call a physician if symptoms persist.
Inhalation:
Seek medical attention. Do not induce vomiting unless directed by a physician. Never give
Ingestion:
anything by mouth to an unconscious person.
Referral to a physician is recommended if there is any question about the seriousness of the
Other:
injury/exposure.
CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT
General (natural or mechanically induced fresh air movements).
Ventilation:
Not required, however, safety glasses should be worn in most industrial settings.
Eye Protection:
Cloth gloves are suitable; impermeable (neoprene or rubber) gloves recommended.
Skin Protection:
None normally required. Where ventilation is inadequate to control vapors, use a NIOSH-
Respiratory Protection:
approved respirator with organic vapor cartridges. Never enter a confined space without an
appropriate air supplied respirator. If dusts are generated during demolition or removal, wear an
appropriate dust mask or respirator.
PRECAUTIONS FOR SAFE HANDLING AND USE
Store in a cool, dry area preferably between 40潞 and 77潞 F. Do not store in direct sunlight. Keep
Handling and Storing
away from open flames, heat sources and sparks. Avoid prolonged or repeated contact. Use
Precautions:
with adequate ventilation. Always wash thoroughly after handling chemical products. For
industrial use only. Keep out of reach of children.
Take up with an absorbent material and place in a container for proper disposal.
Spill Procedures:
REGULATORY INFORMATION
This MSDS has been prepared in accordance with the federal OSHA Hazard Communication
Hazard Communication:
Standard. 29 CFR 1910.1200.
Health 1, Flammability 1, Reactivity 1, PPE B
HMIS Codes:
Not regulated.
DOT Shipping Name:
Not regulated.
IATA / ICAO Shipping Name:
Chemical components listed on TSCA inventory.
TSCA Inventory Status:
This product contains 5 - 10% Benzoyl peroxide (CAS #94-36-0) which is subject to reporting
SARA Title III, Section 313:
under Section 313 of SARA Title III (40 CFR Part 372).
Not regulated by EPA as a hazardous waste
EPA Waste Code(s):
Consult with regulatory agencies or your corporate personnel for disposal methods that comply
Waste Disposal Methods:
with local, state, and federal safety, health and environmental regulations.
CONTACTS
1 800 879 8000 1 800 879 8000
Customer Service: Technical Service:
1 800 879 6000 Jerry Metcalf (x6704)
Health / Safety:
1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries)
Emergency # (Chem-Trec):
The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or
warranty of any kind expressed or implied is made with respect to the information provided.
MSDS 255, Page 2 of 2
|