07000
Material Safety Data Sheet
____________________________________________________
01-JAN-2003
SpecSeal庐 TYPE ES SEALANT
CHEMICAL PRODUCT/COMPANY IDENTIFICATION
Material Identification
PRODUCT NAME......................SpecSeal庐 ES Sealant
CHEMICAL FAMILY..................Mixture
Company Identification
MANUFACTURER/DISTRIBUTOR
Specified Technologies, Inc.
200 Evans Way
Somerville, NJ 08876
PHONE NUMBERS
Product Information : 1-908-526-8000
Emergency : 1-800-255-3924
COMPOSITION/INFORMATION ON INGREDIENTS
INGREDIENT NAME CAS NUMBER PERCENT
CALCIUM CARBONATE 1317-65-3 30-40
TITANIUM DIOXIDE 13463-67-7 2-6
PHTHALATE ESTERS 85-68-7 4-6
HAZARDS IDENTIFICATION
*******EMERGENCY OVERVIEW***********
* Possible skin and eye irritant. Paste. *
*************************************************
Potential Health Effects:
EYE: Contact may cause irritation.
SKIN: Contact may cause irritation.
INGESTION: Should be relatively non-toxic.
INHALATION: Irritation of the nose, throat, and lungs may result from over-exposure to vapors or mist.
CHRONIC (CANCER) INFORMATION: Phthalate esters classified by EPA as possible human carcinogen.
LONG TERM TOXIC EFFECTS: None known.
Page 1 of 3 FOD-5033
MSDS - SpecSeal庐 TYPE ES Sealant
FIRST AID MEASURES
First Aid
INHALATION: Remove to fresh air.
SKIN CONTACT: Wash thoroughly.
EYE CONTACT: Irrigate eyes with running water for at least 15 minutes. Get medical attention if irritation develops.
INGESTION: None applicable.
FIRE FIGHTING MEASURES
Flash point >93 deg. C.
EXTINGUISHING MEDIA.............................................Dry Chemical; Carbon Dioxide; Foam; Water spray for large fires.
SPECIAL FIRE FIGHTING PROCEDURES: .................As for surrounding fire.
ACCIDENTAL RELEASE MEASURES
Safeguards (Personnel)
NOTE: Review FIRE FIGHTING MEASURES and HANDLING (PERSONNEL) sections before proceeding with clean-up. Use
appropriate PERSONAL PROTECTIVE EQUIPMENT during clean-up.
HANDLING AND STORAGE
Store under ambient conditions. No special handling required. Avoid excessive heat and freezing.
EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE PROTECTION REQUIREMENTS:.....................Safety glasses/goggles.
SKIN PROTECTION REQUIREMENTS: ...................Gloves. Barrier skin cream.
RESPIRATOR REQUIREMENTS: .............................None.
VENTILATION REQUIREMENTS:.............................If needed, use local exhaust ventilation to keep airborne concentrations
below the TLV.
Exposure Guidelines
Exposure Limits
PEL(OSHA) : Particulates (Not Otherwise Classified) 15 mg/m3, 8 Hr. TWA, total dust 5 mg/m3, 8 Hr. TWA, respirable dust
TLV(ACGIH): None Established
PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL FORM .................................................... Smooth paste, slight ammonia odor
SPECIFIC GRAVITY................................................. 1.2-1.5
PERCENT VOLATILES............................................. 17-20
EVAPORATION RATE (ether = 1)............................ Slower
BOILING POINT ...................................................... 100-105 deg. C
SOLUBILITY IN WATER........................................... Dissolves wet, insoluble when cured
PH鈥︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹??........鈥?.8.0-8.5
STABILITY AND REACTIVITY
STABILITY:................................................................This is a stable material.
CONDITIONS TO AVOID...........................................Excessive heat and freezing
HAZARDOUS POLYMERIZATION:............................Will not occur.
INCOMPATIBILITIES:鈥︹?︹?︹?︹?︹?︹?︹?︹?︹??.............None special.
TOXICOLOGICAL INFORMATION
Mixture not tested but based on components:
May be irritating to skin and eyes. As a precautionary measure, preclude from those individuals with a history of respiratory
ailments.
EPA Integrated Risk Information System IRIS):
Butyl benzyl phthalate, CAS# 85-68-7, carcinogen assessment is: C (Possible human carcinogen)
Page 2 of 3 FOD-5033
MSDS - SpecSeal庐 TYPE ES Sealant
ECOLOGICAL INFORMATION
No data.
DISPOSAL CONSIDERATIONS
Waste Disposal:
Treatment, storage, transportation, and disposal must be in accordance with applicable Federal, State/Provincial, and Local
regulations.
TRANSPORTATION INFORMATION
DOT 鈥? not regulated.
REGULATORY INFORMATION
U.S. Federal Regulations
TSCA Inventory Status: Reported/Included.
Section 313 Supplier Notifications.
This product contains no toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and
Community Right-To-Know Act of 1986 and of 40 CFR 372:
OTHER INFORMATION
NPCA-HMIS Rating
Health :1
Flammability : 2
Reactivity :0
Personal Protection rating to be supplied by user depending on use conditions.
STATE RIGHT-TO-KNOW LAWS
No substances on the state hazardous substances list, for the states indicated below, are used in the manufacture of products
on this Material Safety Data Sheet, with the exceptions indicated. While we do not specifically analyze these products, or
the raw materials used in their manufacture, for substances on various state hazardous substances lists, to the best of our
knowledge the products on this Material Safety Data Sheet contain no such substances except for those specifically listed
below:
SUBSTANCES ON THE NEW JERSEY WORKPLACE HAZARDOUS SUBSTANCE LIST PRESENT AT A CONCENTRATION OF
1% OR MORE (0.1% FOR SUBSTANCES IDENTIFIED AS CARCINOGENS, MUTAGENS OR TERATOGENS): NJTSRN-ES100
(titanium dioxide, phthalate esters)
WARNING: SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER: None known.
WARNING: SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM: None known.
------------------------------------------------------------------
This information relates to the specific material designated and may not be valid for such material used in combination with any
other materials or in any process. Such information is to the best of our knowledge and belief accurate and reliable as of the data
compiled. However, no representation, warranty, or guarantee is made as to its accuracy, reliability or completeness. It is the
user鈥檚 responsibility to satisfy himself as to the suitability and completeness of such information for his own particular use. We do
not accept liability for any loss or damage that may occur form the use of this information.
Responsibility for MSDS :
Specified Technologies, Inc.
200 Evans Way
Somerville, NJ 08876
Page 3 of 3 FOD-5033
MSDS - SpecSeal庐 TYPE ES Sealant
|