Personalformulator.com
97 S. Red Willow Rd.
Evanston, WY 82930
US 1-800-426-2457 Ext. 1003
Material Safety Data Sheet
Cocamidopropyl Betaine
Last Revised: 8/05/05
Eye Contact: Mild to moderate irritation may result.
1. Product Identification
Skin Contact: Contact with skin could produce mild irritation.
Product Name: Cocamidopropyl Betaine Ingestion: Ingestion may cause irritation to the membranes of the
INCI Name: Cocamidopropyl Betaine mouth, throat, and gastrointestinal tract. Nausea, vomiting, cramps and
Chem. N.: No data diarrhea may occur.
Ingredient(s) & CAS Number(s): No data Exposure Guidelines: No data
Ingredient(s) & EINECS Number(s): No data
8. First Aid Measures
2. Physical and Chemical Properties
Eyes: Immediately flush eyes with large quantities of water for 15
Melting Point: No data minutes. Hold eyelids apart to ensure complete flushing. Do not attempt to
Boiling Point: 212掳F neutralize with chemical agents. Obtain medical attention.
Evaporation Rate: Not determined Skin: Remove contaminated clothing and flush skin with water. Wash
Specific Gravity: (H2O=1): 1.04 with soap and water until material has been removed. Obtain medical
Solubility in Water: 100 attention if irritation persists.
pH Value: No data Inhalation: Remove to fresh air. If symptoms of respiratory discomfort
Appearance & Odor: Pale yellow liquid, mild odor persist, obtain medical attention.
Ingestion: Obtain medical attention.
3. Stability and Reactivity Physician鈥檚 Note: No data
Chemical Stability: Stable
9. Fire Fighting Measures
Incompatibility: None currently known
Hazardous Decomposition: May produce hazardous fumes or
Flash Point: N/A water solution
hazardous decomposition materials.
Auto-ignition Temp: No data
Hazardous Polymerization: Will not occur
Extinguishing Media: Water, dry chemical, carbon dioxide, foam
Fire Fighting Procedures: As with most chemical fires, it is advised
4. Handling and Storage that firemen be supplied with self-contained breathing devices equipped with
full face piece.
Do not get in eyes, on skin, or on clothing. Wash thoroughly after
Fire and Explosion Hazards: None
handling. Soiled clothing should be removed and laundered before reuse.
Store below 120掳F. Keep container closed.
10. Toxicological Information
5. Accidental Release Measures Acute Oral LD50: No data
Dermal and Eye Irritation Test: No data
Wear suitable protective equipment. Carcinogenicity: No data
Small spills: absorb liquid with absorbent material. Mutagenicity: No data
Large spills: Stop spill at source. Dike area of the spill to prevent
spreading. Pump liquids into waste containers. Remaining liquids can be
11. Disposal Considerations
absorbed.
Incinerate or landfill where permitted under appropriate federal, state and
6. Exposure Controls & Personal Protection local regulations.
Respiratory Protection: Self-contained breathing apparatus in high
concentrations. Normally not required.
Eye Protection: Monogoggles
Protective Clothing: Synthetic apron, and butyl or neoprene gloves
Engineering Controls: General (mechanical) room ventilation is
expected to be satisfactory.
Other Protective Measures: Eye wash station
7. Hazards Identification
General: No data
Inhalation: No health effects are known to occur from inhalation of this
product. Inhalation of mists or sprays may result in non-specific irritation of
the upper respiratory tract.
Important Notice: The information presented herein is based on experimental data submitted by the manufacturers
of the raw materials and is considered scientifically correct; however, no warrant or representation, express or implied, is
made as to the accuracy or suitability of this information for application to the purchaser鈥檚 intended purpose or for
consequences of its use and we assume no responsibility for any loss, damage or expense, direct or consequential, arising
out of its use. Use these materials only as directed. If you have any questions regarding the proper interpretation of this
sheet or the meanings of any terms used, we strongly urge you to speak with your physician. For further information
concerning product safety and proper use, call the number listed on the front of the MSDS.
|