Search    ENTER KEYWORD
MSDS Material Safety Data Sheet
CAS

N/A

File Name: 148094_mercon_dexron_iii_atf.asp
148094                                         http://www.mats.ford.com/mats/cgi-bin/aft...anguage=US&tox=148094&type=hak&context=NA




MATERIAL SAFETY DATA SHEET
Ford Internal Reference Number(Tox No. : 148094)

Print Date : 08/27/01
Language: English

Part Type and Number Part name
--------------------------------------- --------------------------------------
Motorcraft - U.S. XT-2-QDX MERCON(R) ALSO MEETS DEXRON(R) III
AUTOMATIC TRANSMISSION FLUID (QUART
(0.946L))
Motorcraft - U.S. XT-2-DDX MERCON(R) ALSO MEETS DEXRON(R) III
AUTOMATIC TRANSMISSION FLUID (55
GALLON DRUM)
Motorcraft - U.S. XT-2-BDX MERCON(R) ALSO MEETS DEXRON(R) III
AUTOMATIC TRANSMISSION FLUID (BULK)
Motorcraft - U.S. XT-2-RDX MERCON(R) ALSO MEETS DEXRON(R)
AUTOMATIC TRANSMISSION FLUID
(RAILCAR BULK)
Motorcraft - U.S. XT-2-QDX1 MOTORCRAFT MERCON AUTOMATIC
TRANSMISSION FLUID (1 US QUART -
SAUDI ARABIA)
XT-2-QDX1 FOR USE IN SAUDI ARABIA ONLY (ENGLISH/ARABIC LANGU AGE LABEL)
Motorcraft - U.S. XT-2-DDX1 MERCON(R) ALSO MEETS DEXRON(R) III
AUTOMATIC TRANSMISSION FLUID (55
GALLON DRUM)
For Saudi Arabia only (English/Arabic label)

This material has not been identified against a material Specification.

====================== CHEMICAL AND PHYSICAL PROPERTIES =======================

Appearance : Physical State LIQUID
Form -
Color RED
Specific Gravity (Relative Density) 0.87
Boiling Point Not Applicable
Flash Point +188 C (+370 F) (CLEVELAND OPEN CUP)
pH full strength -
pH diluted -
Odor MILD PETRO HYDROCARB
Odor Threshold -
Viscosity -
Vapor Density >1 (AIR = 1)
Vapor Pressure Not Applicable
Evaporation Rate -
Freezing Point -
Explosion Properties : UEL -
LEL -
Auto-ignition Temperature -
Solubility INSOLUBLE in Water
Partition Coefficient -

================== HAZARDOUS AND OTHER DISCLOSED INGREDIENTS ==================



1 of 5 8/27/01 5:14 PM
148094 http://www.mats.ford.com/mats/cgi-bin/aft...anguage=US&tox=148094&type=hak&context=NA




Percent Exposure Limits - TWA
Range ACGIH/OSHA(where est.) CAS number Chemical Name
------------ ---------------------- ------------ --------------------------
55-75 5/5 64742-54-7 PETROLEUM DISTILLATES
Ford= 1.0 mg/m3 HYDROTREATED HEAVY
PARAFFINIC
10-30 5/5 64742-55-8 PETROLEUM DISTILLATES,
Ford= 1.0 mg/m3 HYDROTREATED LIGHT
PARAFFINIC

Exposure Limit Abbreviations
--------------------------------------
TWA=Time Weighted Average C=Ceiling
S=Short Term Exposure Sk=Skin
Sol=Soluble Compounds Fu=Fumes
Insol=Insoluble Compounds Du=Dust I=IARC Resp=Respirable

=========================== REGULATORY INFORMATION ============================

The supplier has classified this product under the Canadian Controlled
Products Regulations as:
Not a controlled product
California Proposition 65:
WARNING: This product contains a chemical known to the State of California
to cause cancer.
California Proposition 65:
WARNING: This product contains a chemical known to the State of California
to cause birth defects or other reproductive harm.

================================= SIGNAL WORD =================================




CAUTION




========================== HEALTH HAZARD INFORMATION ==========================

=(A)=============================== HAZARDS ===================================

Exposure to oil mist/fume/vapor may cause respiratory tract irritation.
This product may cause irritation to the eyes, respiratory system, and skin.
Ingestion can cause gastrointestinal irritation, nausea,vomiting and diarrhea.

=(B)================ TARGET ORGANS AND MEDICAL CONDITIONS =====================

Overexposure to some hazardous ingredients in this product has been found
to affect certain body organs and systems in experimental animals and/or
humans. These include:
Skin, Eyes, and Respiratory System

=(C)===================== ACUTE TOXICITY INFORMATION ==========================

Based on the composition of the product identified by the supplier,
selected portions of the acute toxicity information from RTECS are
as follows:

140-88-5 ETHYL ACRYLATE
Inhalation, adult rat, LC50 = 2180 ppm (4 Hours)
Oral, adult rat, LD50 = 800 mg/kg


2 of 5 8/27/01 5:14 PM
148094 http://www.mats.ford.com/mats/cgi-bin/aft...anguage=US&tox=148094&type=hak&context=NA



Skin, adult rabbit, LD50 = 1834 mg/kg
1330-20-7 XYLENE (ALL ISOMERS)
Inhalation, adult rat, LC50 = 5000 ppm (4 Hours)
Oral, adult rat, LD50 = 4300 mg/kg
62-53-3 ANILINE
Inhalation, mouse, LC50 = 175 ppm (7 Hours)
Oral, adult rat, LD50 = 250 mg/kg
Skin, adult rat, LD50 = 1400 mg/kg
100-41-4 ETHYLBENZENE
Oral, adult rat, LD50 = 3500 mg/kg
Skin, adult rabbit, LD50 = 17800 mg/kg
71-43-2 BENZENE
Inhalation, adult rat, LC50 = 10000 ppm (7 Hours)
Oral, adult rat, LD50 = 3306 mg/kg
Skin, mouse, LD50 = 48 mg/kg
108-88-3 TOLUENE
Inhalation, mouse, LC50 = 5320 ppm (8 Hours)
Oral, adult rat, LD50 = 5000 mg/kg
Skin, adult rabbit, LD50 = 12124 mg/kg
95-53-4 O-TOLUIDINE
Oral, adult rat, LD50 = 670 mg/kg
Skin, adult rabbit, LD50 = 3250 mg/kg

======================= FIRE AND EXPLOSION INFORMATION ========================

Empty containers may retain product residue including Flammable or
Explosive vapors. Do not cut, drill, grind, or weld near full,
partially full, or empty product containers.
EXTINGUISHER INFORMATION: Dry chemical, foam, carbon dioxide, water fog.
Use water to cool fire-exposed containers and to protect personnel.
Wear self-contained breathing apparatus.
Water or foam may cause frothing if the product is heated above
93 degrees C (200 degrees F).
Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or
low molecular weight hydrocarbons.

=============================== REACTIVITY DATA ===============================

This is a stable material.
This product may react with oxidizing agents.
Hazardous polymerization will not occur.

============================= PREVENTIVE MEASURES =============================

=(A)====================== SAFE HANDLING AND STORAGE ==========================

Do not breathe gas/fumes/vapor/spray.
Avoid getting this material into contact with your eyes.
Keep the container tightly closed and in a cool, well-ventilated place.
Avoid prolonged or repeated skin contact with this material.
Use this product with adequate ventilation.
Keep this product from heat, sparks, or open flame.

=(B)========================= PROTECTIVE MEASURES =============================

Use impervious gloves.
Use general ventilation and use local exhaust, where possible, in confined or
enclosed spaces.
Use of protective coveralls and long sleeves is recommended.
The use of neoprene gloves is recommended.
The use of butyl rubber gloves is recommended.
Respiratory protection; not normally required for ambient air
concentrations not exceeding the Occupational Exposure Limit.
Wear safety glasses with side shields.



3 of 5 8/27/01 5:14 PM
148094 http://www.mats.ford.com/mats/cgi-bin/aft...anguage=US&tox=148094&type=hak&context=NA




=(C)===================== SPILLS, LEAKS AND DISPOSAL ==========================

Wear appropriate protective equipment and clothing during clean-up.
Do not allow this material to drain into sewers/water supplies.
Thoroughly wash the area after a spill or leak clean-up.
Eliminate all sources of ignition or flammables that may come into contact
with a spill of this material.
Stop the flow of material, if this is without risk.
Ventilate the contaminated area.
Remove soiled clothing and launder before reuse.
Avoid excessive skin contact with the spilled material.
Dike the spilled material, where this is possible.
Dispose of waste material according to Local, State, Federal, and
Provincial Environmental Regulation.
Small Spills: (1) Wipe or mop up; (2) take up with sand or other
non-combustible absorbant material.

============================= FIRST AID TREATMENT =============================

In case of contact with eyes, rinse immediately with plenty of water and seek
medical advice.
If the material is swallowed, get immediate medical attention or advice --
Do not induce vomiting.
For skin contact, wash immediately with soap and water.
If irritation persists, get medical attention.
If inhalation of gas/fume/vapor/dust/mist from the material is excessive (air
concentration is greater than the TLV or health effects are noticed),
immediatly remove the affected person(s) to fresh air.

============================= NOTES TO PHYSICIANS =============================

If the affected person is not breathing, apply artificial respiration.
If the affected person's breathing is difficult, give oxygen.
This material, if aspirated into the lungs, may cause chemical pneumonitis;
treat the affected person appropriately.

=============================== SPECIAL REMARKS ===============================

In some laboratory animal studies ZINC DIALKYL DITHIOPHOSPHATE compounds are
suspect of mutagenic effects.
HEATING: This product contains Zinc Dialkyldithiophosphata (ZDDP) and should
not be heated above 70 degrees C (160 degrees F). Higher temperatures can
result in thermal decomposition of the ZDDP and release highly toxic
hydrogen sulfide and, possibly, odourous alkyl mercaptans. Hydrogen sulfide
smells like rotten eggs in low concentrations but quickly fatigues the sense
of smell. It may cause respiratory irritation and failure without any
warning odor being sensed. Alkyl mercaptans can be smelled at extremely low
concentrations and vapours may travel for a long distance.
Animal testing data indicate that the reproductive effect (Testicular Atropy)
from exposure to ZINC DIALKYL DITHIOPHOSPHATE is a non-specific chemical
effect and is caused by stressing the animals due to severe skin irritation
and weight loss.

===================== ENVIRONMENTAL INFORMATION: ECOLOGY ======================

Material contains a chemical which is a Ford Motor Company Material of
Concern. Use and release of this material should be minimized to the
greatest extent possible.
Material contains a chemical which is a Hazardous Air Pollutant (HAP),
regulated by the United States Clean Air Act.

========================== 14. Transport Information ==========================




4 of 5 8/27/01 5:14 PM
148094 http://www.mats.ford.com/mats/cgi-bin/aft...anguage=US&tox=148094&type=hak&context=NA



U.S. Department of Transportation (DOT) 49 - CFR 172.101
This product is not regulated as a dangerous good.

Canadian Transportation of Dangerous Goods (T.D.G.) -TDGR Schedule II
This product is not regulated as a dangerous good.

Secretary of Communication and Transportation (SCT)- NOM-002-SCT2/1994 (Mexico)
This product has not been reviewed for this regulation.

International and Domestic Air Transportation - ICAO & IATA Section 4.2
This product has not been reviewed for this regulation.

International Water Transportation - IMDG Code
This product has not been reviewed for this regulation.

=========================== PREPARATION INFORMATION ===========================

Health and safety information has been evaluated by:

Occupational & Environmental Health Sciences Department
Ford Motor Company
Central Laboratory Building - Rm S-120
15000 Century Drive
Dearborn, Michigan 48120

For 24 hour emergency information dial 1-800-959-3673.

This is the last page of this MSDS.

Date of Preparation: 06/12/97




5 of 5 8/27/01 5:14 PM

Search    ENTER KEYWORD
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP
NAMECAS
0037_zep_65.asp 5989-27-5 112-34-5 75-28-5 106-97-8
0629_zep_klear.asp 67-56-1
148094_mercon_dexron_iii_atf.asp N/A
157746_motorcraft_mercon_v_atf.asp 72623-86-0 72623-84-8
163073_sae_5w-20_premium_synthetic_blend_motor_oil.asp N/A
164586_super_duty_motor_oil_-_all_grades.asp N/A
20000_thru_20036_colorplace_spray_enamel.asp N/A
30009014_blue_coral_tar_&_adhesive_remover.asp N/A
60130_battery_kleener.asp 07732-18-5 67-63-0 00106-97-8 144-55-8 00074-98-6
65475_mac_tools_pnematic_tool_oil.asp 68037-01-4
765-1151_balkamp_anti-seize_compound_&_lubricant.asp 64742-52-5 7440-50-8 64741-44-2 7429-90-5 64742-53-6 7782-42-5 7620-77-1 112926-00-8
8030_armor_all_protectant.asp 7732-18-5

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com | Ads link:HBCCHEM.INC