MATERIAL SAFETY DATA SHEET
POLYBLEND, CERAMIC TILE CAULK
HMIS
HEALTH 1
FLAMMABILITY 0
REACTIVITY 0
B
PERSONAL PROTECTION
1. Product And Company Identification
Supplier Manufacturer
CUSTOM BUILDING PRODUCTS CUSTOM BUILDING PRODUCTS
10400 Pioneer Blvd., Unit #3 10400 Pioneer Blvd., Unit #3
Santa Fe Springs, CA 90670 UNITED STATES Santa Fe Springs, CA 90670 UNITED STATES
Company Contact: GEORGE MARCINA Company Contact: GEORGE MARCINA
Telephone Number: (562) 968-2980 Ext 103 Telephone Number: (562) 968-2980 Ext 103
FAX Number: (562) 903-2697 FAX Number: (562) 903-2697
E-Ma il: georgem@cbpmail.net E-Ma il: georgem@cbpmail.net
Web Site: www.custombuildingproducts.com Web Site: www.custombuildingproducts.com
Supplier Emergency Contacts & Phone Number Manufacturer Emergency Contacts & Phone Number
GEORGE MARCINA: (562) 968-2980 GEORGE MARCINA: (562) 968-2980
Issue Date: 04/20/2006
Product Name: POLYBLEND, CERAMIC TILE CAULK
CAS Number: Not Established
Chemical Formula: Mixture
MSDS Number: 625
Product Code: 2060-72
2. Composition/Information On Ingredients
Ingredient CAS Percent Of
Name Number Total Weight
ACRYLIC COPOLYMER Not establish 10 - 20
BUTYL BENZYL PHTHALATE 85-68-7 5 - 10
MINERAL SPIRITS - STODDARD SOLVENT 8052-41-3 1 -5
Calcium Carbonate 1317-65-3 55 - 65
3. Hazards Identification
Primary Routes(s) Of Entry
Eye and Skin Contact. Inhalation. Ingestion.
Eye Hazards
May cause eye irritation.
Skin Hazards
May cause skin irritation.
Ingestion Hazards
May cause gastrointestinal irritation, nausea and vomiting.
Inhalation Hazards
May cause nose, throat, and lung irritation.
Page 1 of 5
MATERIAL SAFETY DATA SHEET
POLYBLEND, CERAMIC TILE CAULK
3. Hazards Identification - Continued
Chronic/Carcinogenicity Effects
Contails Butyl Benzyl phtalate which is listed on California Prop 65 May contain trace amounts of chemicals that
IARC classifies as possible carcinogens.
Teratogenicity (Birth Defects)
May contain trace amounts of chemicals that caused birth defects in animal studies.
Reproductive Effects
May contain trace amounts of chemicals that caused birth defects in animal studies. It did not cause harm to the
animal or fetus when applied on skin.
Mutagenicity (Genetic Effect)
May contain trace amounts of chemicals that caused birth defects in animal studies. It did not cause harm to the
animal or fetus when applied on skin.
4. First Aid Measures
Eye
Gently blot or wipe any residue remaining on the face, being careful not to get it in the victim's eyes or skin. Hold
eyelids apart and immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention
immediately.
Skin
Remove excess from the skin. Wash skin with plenty of water for at least 15 minutes. Remove contaminated
clothing and shoes. Thoroughly clean before reuse. Get medical attention immediately if irritation (redness, rash,
blistering) develops and persists.
Ingestion
If victim is fully conscious, give one or two cups of water or milk to drink. If swallowed, do not induce vomiting unless
directed to do so by medical personnel. Get medical attention immediately. If there is any discomfort from ingestion,
consult a physician.
Inhalation
If inhaled, remove to fresh air. Get medical attention immediately.
5. Fire Fighting Measures
Flash Point: NONE 掳F
Flash Point Method: NONE
Lower Explosive Limit: N/A
Upper Explosive Limit: N/A
Fire And Explosion Hazards
Material will not burn until all water has evaporated. Cartridges may burst open and splatter material if temperatures
reach 212 deg F and above.
Extinguishing Media
Foam, CO2, Dry chemical, Water fog.
Fire Fighting Instructions
Firefighters should wear self-contained breathing apparatus and full protective gear.
6. Accidental Release Measures
Clean up spill immediately. Cover with absorbent to contain. Collect and dispose. Use appropriate containers to avoid
environmental contamination. Avoid runoff to waterways and sewers. Avoid release to the environment.
Use appropriate personal protective equipment (PPE).
Page 2 of 5
MATERIAL SAFETY DATA SHEET
POLYBLEND, CERAMIC TILE CAULK
7. Handling And Storage
Handling And Storage Precautions
Store in cool, dry areas away from sunlight, heat and heat sources. Protect from freezing.
Work/Hygienic Practices
Wash thoroughly with soap and water after handling. Use good personal hygiene. Observe good housekeeping
practices.
.
8. Exposure Controls/Personal Protection
Eye/Face Protection
Safety glasses with side shields or goggles recommended.
Skin Protection
Chemical-resistant gloves.
Respiratory Protection
General room ventilation is normally adequate. .In case of inadequate ventilation, use NIOSH-approved respirator.
Other/General Protection
General ventilation is usually sufficient. Fan or other device maybe needed if used in small and enclosed areas.
Ingredient(s) - Exposure Limits
MINERAL SPIRITS - STODDARD SOLVENT
ACGIH TLV-TWA 100 ppm
OSHA PEL-TWA 500 ppm
OSHA VPEL - TWA 100 ppm
Calcium Carbonate
OSHA - PEL - TWA - 15mg/m3
NIOSH - REL 10 mg/m3
ACGIH- TLV - 10 mg/m3
OSHA - PEL - TWA - 5 mg/m3
Adequate clothing to prevent skin contact.
9. Physical And Chemical Properties
Appearance
Colored paste
Odor
Mild odor.
Chemical Type: Mixture
Physical State: Liquid
Boiling Point: 212 掳F
Specific Gravity: 1.6 - 1.7
Percent Volatiles: 15
Percent VOCs: less than 5%
Vapor Density: HEAVIER THAN AIR
Solubility: Dilutable in water
Evaporation Rate: Slower than ether
10. Stability And Reactivity
Sta bility: Stable
Hazardous Polymerization: Will not occur
Page 3 of 5
MATERIAL SAFETY DATA SHEET
POLYBLEND, CERAMIC TILE CAULK
10. Stability And Reactivity - Continued
Incompatible Materials
Avoid contact with acids and strong oxidizers.
Hazardous Decomposition Products
Thermal decomposition in air may result in carbon monoxide and / or carbon dioxide.
Conditions To Avoid (Polymerization)
Hazardous polymerization will not occur. Heat may cause pressure build-up in closed containers
11. Toxicological Information
Chronic/Carcinogenicity
Contains Butyl benzyl phtalate which is listed on Californila Prop. 65.
Teratogenicity (Birth Defects)
May contain trace amounts of chemicals that caused birth defects in animal studies. It did not cause harm to the
animal or fetus when applied on skin.
Reproductive Effects
May contain trace amounts of chemicals that caused birth defects in animal studies. It did not cause harm to the
animal or fetus when applied on skin.
Mutagenicity (Genetic Effects)
May contain trace amounts of chemicals that caused birth defects in animal studies. It did not cause harm to the
animal or fetus when applied on skin.
Ingredient(s) - Toxicological Data
ACRYLIC COPOLYMER
Oral LD - 50 = >5,000 mg/kg - rat
dermal LD - 50 = > 5,000 mg/kg rabbit
BUTYL BENZYL PHTHALATE
Oral - LD 50 = 20,400 mg / kg - rat
Dermal - LD = >10,000 mg /kg - rabbit
12. Ecological Information
No Data Available...
13. Disposal Considerations
Dispose in accordance with applicable federal, state and local government regulations and industry standards.
RCRA Information
Not considered RCRA waste
14. Transport Information
DOT Shipping Label
Not Regulated
15. Regulatory Information
SARA Section 313 Notification
This product contains ingredients regulated under Section 313 of the Emergency Planning and Community
Right-To-Know Act of 1986 or 40 CFR 372.
Ingredient(s) - State Regulations
BUTYL BENZYL PHTHALATE
New Jersey - Workplace Hazard
New Jersey - Environmental Hazard
Page 4 of 5
MATERIAL SAFETY DATA SHEET
POLYBLEND, CERAMIC TILE CAULK
15. Regulatory Information - Continued
Ingredient(s) - State Regulations - Continued
Pennsylvania - Workplace Hazard
Pennsylvania - Environmental Hazard
California - Proposition 65
New York City - Hazardous Substance
MINERAL SPIRITS - STODDARD SOLVENT
New Jersey - Workplace Hazard
Pennsylvania - Workplace Hazard
California - Proposition 65
Massachusetts - Hazardous Substance
New York City - Hazardous Substance
Calcium Carbonate
Pennsylvania - Workplace Hazard
16. Other Information
HMIS Rating
He a lth: 1
Fire : 0
Re a ctivity: 0
Personal Protection: B
Revision/Preparer Information
MSDS Preparer: GEORGE MARCINA
MSDS Preparer Phone Number: (562) 968-2980 ext 103
This MSDS Supersedes A Previous MSDS Dated: 04/17/2006
Disclaimer
THE INFORMATION PRESENTED HERE IS BELIEVED TO BE ACCURATE BUT IS NOT WARRANTED TO BE,
WHETHER ORIGINATING WITH THE COMPANY OR NOT. RECIPIENTS ARE ADVISED TO CONFIRM IN
ADVANCE OF NEED, THAT THE INFORMATION IS CURRENT, APPLICABLE, AND SUITABLE TO THEIR
CIRCUMSTANCES.
CUSTOM BUILDING PRODUCTS
Printed Using MSDS Generator鈩? 2000
Page 5 of 5
|