WHITE CALCIUM CARBONATE MSDS
1. PRODUCT IDENTIFICATION
Chemical Name: Calcium Carbonate
Chemical Formula: N/A
Molecular Weight: N/A
Trade Name: Crushed Stone
DOT Identification No: None
Product Codes: ExCAL CW 3, ExCAL CW 7, ExCAL CW 10, ExCAL CW 100, ExCAL CW 200,
ExCAL CW 300, ExCAL CW 325, ExCAL CW 1640-L, ExCAL CW 40200-L
2. PRODUCT AND COMPONENT DATA
Component(s)
Chemical Name CAS Registry No. %(Approx) Exposure Limits
Limestone* 1317-65-3 100 See section 6
*Composition varies naturally 鈥? typically contains quartz (crystalline silica).
14808-60-7 <0.1
3. PHYSICAL DATA
Appearance and odor: Angular gray, white and tan particles ranging in size from
powder to boulders. No odor.
Specific Gravity: 2.6 鈥? 2.75
Boiling point (At 1 Atm.): N/A
Vapor Density in Air (Air =1): N/A
Vapor Pressure (mmHg @20 o C): N/A
%Volatile, By Volume (@100 o F): 0%
Evaporation Rate (at 1 Atm. and 25 E C;n-butyl acetate =1): 0
Solubility in Water: 0
4.REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Avoid contact with incompatible materials (see below).
Incompatibility (materials to avoid): Contact with powerful oxidizing agents such as fluorine, boron trifluoride, chlorine trifluoride,
manganese trifluoride, and oxygen difluoride may cause fire and/or explosions. Silica dissolves readily in hydrofluoric acid
producing a corrosive gas 鈥? silicon tetrafluoride.
Hazardous Decomposition Products: Limestone ignites on contact with fluorine and is incompatible with acids, alum,
ammonium salts, and magnesium. Silica reacts violently with powerful oxidizing agents such as fluorine, boron trifluoride,
chlorine trifluoride, manganese trifluoride, and oxygen difluoride yielding possible fire and/or
explosions. Silica dissolves readily in hydrofluoric acid producing a corrosive gas 鈥? silicon tetrafluoride.
Hazardous Polymerization: Not known to polymerize
5.FIRE AND EXPLOSION HAZARD DATA
Flash Point/Range: Not Determined Flash Point Method: Not Determined
Autoignition Temperature: Not Determined Flammability Limits in Air - Lower (%): Not Determined
Flammability Limits in Air - Upper (%): Not Determined Fire Extinguishing Media: All standard firefighting media.
Special Exposure Hazards: Not applicable. Special Protective Equipment for Fire Fighters: Not applicable.
NFPA Ratings: Health 1, Flammability 0, Reactivity 0 HMIS Ratings: Flammability 0, Reactivity 0, Health 1
Unusual Fire and Explosion Hazards: Contact with powerful oxidizing agents may cause fire and/or explosions (see section 4
of this MSDS).
6.TOXICITY AND FIRST AID
Exposure Limits (When exposure to this product and other chemicals is concurrent, the exposure limit must be defined in the
workplace.) Unless specified otherwise, limits are expressed as eight-hour time-weighted averages (TWA). Limits for cristobalite
and tridymite (other forms of crystalline silica) are equal to one-half of the limits for quartz.
Abbreviations: TLV =threshold limit value of the American Conference of Governmental Industrial Hygienists (ACGIH); MSHA
PEL =permissible exposure limit of the Mine Safety and Health Administration.(MSHA); OSHA PEL =permissible exposure limit
of the Occupational Safety and Health Administration (OSHA); mg/m 3 =milligrams of substance per cubic meter of air.
Limestone (Calcium Carbonate): ACHIH TLV 庐 =10mg/m 3; OSHA PEL =15mg/m 3 (total dust); OSHA PEL= 5mg/m 3
(respirable fraction), MSHA PEL =10mg/m 3 (total dust).
Other Particulates: 2001 ACGIH TLV 庐 =10mg/m 3 (inhalable/total particulate, not otherwise specified), 2001 ACGIH TLV 庐
=3 mg/m 3 (respirable particulate, not otherwise specified); OSHA PEL =15mg/m 3 (total particulate, not otherwise regulated),
OSHA PEL =5mg/m 3 (respirable particulate, not otherwise regulated).
Total Dust: MSHA PEL =10 mg/m 3 (for nuisance particulates listed in Appendix E of the 1973 ACGIH TLV 庐 booklet).
Per ACGIH, adverse effects are not likely to occur in the workplace provided exposure levels do not exceed the appropriate
TLVs & PELs. However, because of the wide variation in individual susceptibility, lower exposure limits may be appropriate for
some individuals including persons with pre-existing medical conditions such as those
described below.
Medical Conditions Aggravated by Exposure: Inhaling respirable dust and/or crystalline silica may aggravate existing
respiratory system disease(s) and/or dysfunctions. Exposure to dust may aggravate existing skin and/or eye conditions.
Primary Route(s)of Exposure:
X Inhalation _Skin _Ingestion
15425 North Freeway 鈼? Suite 370 鈼? Houston 鈼? Texas 鈼? 77090 鈼? P: 281-872-4539 鈼? F: 281-872-8241 鈼? www.excalibar.com
ACUTE TOXICITY
Eye Contact: Direct contact with dust may cause irritation by mechanical abrasion.
Skin Contact: Direct contact may cause irritation by mechanical abrasion.
Skin Absorption: Not expected to be a significant exposure route.
Ingestion: Expected to be practically non-toxic. Ingestion of large amounts may cause gastrointestinal irritation and blockage.
Inhalation: Dusts may irritate the nose, throat, and respiratory tract by mechanical abrasion. Coughing, sneezing, and
shortness of breath may occur following exposures in excess of appropriate exposure limits.
FIRST AID
Eyes: Immediately flush eye(s)with plenty of clean water for at least 15 minutes, while holding the eyelids) open. Occasionally
lift the eyelids)to ensure thorough rinsing. Beyond flushing, do not attempt to remove material from the eye(s). Contact a
physician if irritation persists or later develops.
Skin: Wash with soap and water. Contact a physician if irritation persists or later develops.
Ingestion: If person is conscious, give large quantity of water and induce vomiting; however, never attempt to make an
unconscious person drink or vomit. Get immediate medical attention.
Inhalation: Move to fresh air. Dust in throat and nasal passages should clear spontaneously. Contact a physician if irritation
persists or later develops.
Chronic Toxicity
Limestone is not listed as a carcinogen by the International Agency for Research on Cancer (IARC), the National Toxicology
Program (NTP), or the Occupational Safety and Health Administration (OSHA).
7.PERSONAL PROTECTION AND CONTROLS
Respiratory Protection
If particulate levels exceed or are likely to exceed the exposure limits in Section 6 of this MSDS, an appropriate NIOSH-
approved respirator must be worn. Respirator must comply with applicable MSHA or OSHA standards, which include provisions
for a user-training program, respirator fit testing, and other requirements.
Ventilation: Local exhaust or general ventilation adequate to maintain exposures below appropriate exposure limits.
Skin Protection
See "Hygiene" section below.
Eye Protection
Safety glasses with side shields should be worn as minimum protection. Dust goggles should be worn when excessively
(visible)dusty conditions are present or are anticipated.
Hygiene
Wash dust-exposed skin with soap and water before eating, drinking, smoking, and using toilet facilities. Wash work clothes
after each use.
Other Control Measures
Respirable dust and quartz levels should be monitored regularly. Dust and quartz levels in excess of appropriate exposure limits
should be reduced by all feasible engineering controls, including (but not limited to)wet suppression, ventilation, process
enclosure, and enclosed employee work stations.
8. STORAGE AND HANDLING PRECAUTIONS
Respirable crystalline silica-containing dust may be generated during processing, handling, and storage. The personal
protection and controls identified in Section 7 of the MSDS should be used as appropriate.
Do not store near food and beverages or smoking material.
9. SPILL, LEAK AND DISPOSAL PRACTICES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
The personal protection and controls identified in Section 7 of the MSDS should be used as appropriate.
Spilled material, where dust can be generated, may overexpose cleanup personnel to respirable crystalline silica-containing
dust. Wetting of spilled material and/or use of respiratory protective equipment may be necessary. Do not dry sweep-spilled
material. Prevent spilled materials from inadvertently entering streams, drains, or sewers.
WASTE DISPOSAL METHOD
Pick up and reuse clean materials. Dispose of waste materials only in accordance with applicable federal, state, and local laws
and regulations.
10. TRANSPORTATION
DOT Hazard Classification: None
Placard Required: None
Label Required: Label as required by the OSHA Hazard Communication Standard [29 CFR 1910.1200 (f) and applicable state
and local laws and regulations.
For Further Information Contact:
Excalibar Minerals Inc.
Risk Manager
15425 North Freeway, Suite 370
Houston, TX 77090
281-872-3732
Date of Revision: 02/2006
For Emergency Information Call: 281-872-3732 (24 hours)
NOTICE: Excalibar Minerals Inc. believes the information contained herein is accurate; however, Excalibar Minerals Inc.
makes no guarantees with respect to such accuracy and assumes no liability in connection with the use of the information
contained herein by any party. The provision of the information contained herein is not intended to be and should not be
construed as legal advice or as ensuring compliance with any federal, state or local laws and regulations. Any party using this
product should review all such laws, rules or regulations prior to use.
NO WARRANTY IS MADE, EXPRESS OR IMPLIED, OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR
OTHERWISE.
15425 North Freeway 鈼? Suite 370 鈼? Houston 鈼? Texas 鈼? 77090 鈼? P: 281-872-4539 鈼? F: 281-872-8241 鈼? www.excalibar.com
|