AMERICAN INTERNATIONAL INDUSTRIES
2220 GASPAR AVENUE
LOS ANGELES, CA 90040
CHEM-TEL: (800) 255-3924
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: EzFlow High Definition - Clear Powder DATE: 11/17/2005
FORMULA: 30-2048 REV. NEW
Section 1. Material Identification and Information
Hazardous Ingredients:
Component TOXICOLOGICAL DATA
CAS # %
Acrylates Copolymer 25685-29-4 60-100% ACGIH TLV/TWA:
10mg/m 3
OSHA PEL/TWA:
3
15mg/m
Benzoyl Peroxide 94-36-0 0-1% ACGIH TLV/TWA:
3
5mg/m
OSHA PEL/TWA:
3
5mg/m
Section 2. Physical / Chemical Characteristics
Boiling Point: N/A Specific Gravity: N/A
(@ 25oC)
Vapor Pressure: Not Determined
(mm Hg and Temperature) Melting Point: N/A
Vapor Density: Not Determined Evaporation Rate: N/A
(Air = 1) (BuAc = 1)
Solubility in Water: Insoluble Water Reactive: N/A
Appearance: Fine, white powder
Odor: Faint odor in bulk
Section 3. Fire and Explosion Hazard Data
304oC, 580oF
Flash Point and Method Used:
Auto-Ignition Temperature: N/A
Flammability Limits in Air % by Volume: LEL: N/A
UEL: N/A
Extinguisher Media: Water, carbon dioxide, or dry chemical
Special Fire Fighting Procedures: Avoid extinguishing methods which may generate dust clouds. Water
stream can disperse bust into air, producing a fire hazard and possible
explosion hazard if exposed to ignition source. Fire-fighters should wear
self-contained breathing apparatus.
Unusual Fire and Explosion Hazards: Polymer dust is combustible. The explosive limits of the polymer
particles suspended in air are approximately those of coal dust.
Explosion Hazard: Firefighters should wear self-contained breathing apparatus.
Sensitive to Hazard: No.
Sensitive to Static Discharge: No.
Page 1 of 6
AMERICAN INTERNATIONAL INDUSTRIES
2220 GASPAR AVENUE
LOS ANGELES, CA 90040
CHEM-TEL: (800) 255-3924
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: EzFlow High Definition - Clear Powder DATE: 11/17/2005
FORMULA: 30-2048 REV. NEW
Section 4. Reactivity Hazard Data
Unstable
Stability: Stable
Conditions to Avoid: Heating above 240oC, 464oF
Incompatibility (Materials to Avoid):
Strong oxidizing agents.
Hazardous Decomposition:
Methacrylate Monomer and Oxides of Carbon when burned.
Hazardous Polymerization:
Will Not Occur
May Occur
Section 5. Health Hazard Data
Primary Routes of Entry:
Inhalation Ingestion
Skin Absorption Eyes
Carcinogen Listed In:
NTP OSHA
IARC Monograph Not Listed
Health Hazards:
Acute: Eye Contact: Higher concentration can irritate eyes. May cause eye irritation or
damage.
Skin Contact: Repeated or prolonged exposure may cause allergic skin rashes.
Inhalation: Possible temporary discomfort due to inhalation of dust concentration
above the permissible exposure limit. Dust may cause irritation of the
nose, throat, and lungs.
Ingestion: Higher concentration can irritate respiratory system.
Sub-Chronic Effects:
For Polymer: OSHA classifies this material as Particulates, Not Otherwise Classified. Eyes,
skin and Respiratory tract may be irritated by gross overexposure to Particulates, Not Otherwise
Classified, no matter how they are generated. Avoid inhalation of dust. Keep dust out of eyes
to prevent possible irritation.
For decomposition product: Methyl Methacrylate Monomer; Liquid or high vapor concentration
can irritate eyes, respiratory system and cause skin rashes. Prolonged exposure can lead to
headaches, nausea, staggering gait, confusion, drowsiness and unconsciousness. Repeated
and prolonged over exposure may cause permanent brain and nervous system damage, allergic
skin rashes, eye corrosion and permanent injury, as well as changes in liver and kidney function
or damage.
For Benzoyl Peroxide: repeated or prolonged contact may cause skin sensitization.
Emergency First Aid Procedures:
Eye Contact: Flush with water for 15 minutes, including under eyelids. Get medical
help if discomfort persists.
Skin Contact: Wash with soap and water. Get medical help if discomfort persists.
Inhalation: Remove to fresh air. Get medical help if discomfort persists. 2 of 6
Page
AMERICAN INTERNATIONAL INDUSTRIES
2220 GASPAR AVENUE
LOS ANGELES, CA 90040
CHEM-TEL: (800) 255-3924
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: EzFlow High Definition - Clear Powder DATE: 11/17/2005
FORMULA: 30-2048 REV. NEW
Ingestion: Rinse mouth out with water. Call doctor if amount was large.
Section 6. Control and Protective Measures
General:
Dust collectors are recommended for handling powder in bulk.
Respiratory Protections (Specific Type):
Avoid breathing dust and mist. Use dust mask.
Protective Gloves:
Minimize contamination by following good industrial practice. Wearing nitrile, neoprene, pvc,
latex or other impermeable gloves is recommended.
Eye Protection:
Use safety glasses and have eye flushing equipment immediately available.
Ventilation to be Used:
Use good local exhaust at processing equipment, including buffers, sanders, grinders and
polishers. High temperature processing equipment should be well ventilated. Use explosion-
proof equipment. Provide ventilation if necessary to control exposure levels below airborne
exposure limits.
Other Protective Clothing and Equipment:
No special body protection is required under typical circumstances of use and handling. If
necessary, refer to appropriate standards of Canada, the EC members states, or US OSHA.
Provide eyewash, safety shower and impervious clothing are recommended. High temperature
processing equipment should be well be ventilated.
Hygienic Work Practices:
Good Manufacturing Practices.
Section 7. Precautions for Safe Handling and Use / Leak Procedures
Steps to be Taken if Material is Spilled or Released:
Before cleaning any spill or leak, individuals involved in spill clean-up must wear appropriate
Personal Protective Equipment. Wear appropriate personal protective equipment (e.g.,
goggles, gloves). Sweep up to avoid slipping hazard. Keep airborne particulates at a minimum
when cleaning up spills. Dispose of properly in accordance with local, state, and federal
regulations. Wash all affected areas with plenty of warm water and soap. Remove any
contaminated clothing and wash thoroughly before reuse.
Waste Disposal Methods:
Dispose in a landfill or incinerate according to Federal, State, and Local regulations.
Disposal of Empty Containers:
Reuse of empty drums or containers is not recommended. Employees should be advised of the
potential hazards, due to residual material, associated with empty containers. It is our policy to
discourage the reuse of empty containers and to dispose of all empty containers properly, in
accordance with Federal, State, and Local regulations. Page 3 of 6
AMERICAN INTERNATIONAL INDUSTRIES
2220 GASPAR AVENUE
LOS ANGELES, CA 90040
CHEM-TEL: (800) 255-3924
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: EzFlow High Definition - Clear Powder DATE: 11/17/2005
FORMULA: 30-2048 REV. NEW
Precautions for Handling:
Use in well ventilated areas. Avoid contact with skin, eyes, and clothing. Avoid breathing dust.
Use good personal hygiene and housekeeping.
Precautions for Storage:
Store containers in a cool, dry location, away from direct sunlight, other light sources, or sources
of intense heat. Material should be stored in secondary containers as appropriate. Keep
container closed to prevent water absorption and contamination.
Explosion Hazard:
Polymer dust is combustible, explosive limits of the polymer particles suspended in air are
approximately those of coal dust.
Industrial Hygiene Practices:
Avoid prolonged contact with the product. Use in a well-ventilated location (e.g., local exhaust
ventilation, fans.). After use, wash hands and exposed skin with soap and water. Do not eat,
drink, or smoke while handling product.
Section 8. Toxicological Properties
Toxicity Data: This product has NOT been tested on animals to obtain toxicology data. There are toxicology
data for the components of the product, which are found in scientific literature. These data have
not been presented in this document.
Mutagenicity Data: This product is not reported to produce mutagenic effects in humans.
Reproductive Toxicity Data:
For Polymer: Embryotoxicity: This product is not reported to produce embryotoxic effects in humans.
Teratogenicity: This product is not reported to cause teratogenic effects in humans.
Reproductive Toxicity: This product is not reported to cause reproductive effects in humans.
Section 9. Ecological Information
Aquatic Toxicity:
For Polymer: There is no specific data available for this product; however, very large releases of this product
may be harmful or fatal to overexposed aquatic life.
Environmental Fate:
There is no specific data available for this product.
Section 10. Transportation
DOT/UN Shipping Name: Non-Regulated Material
Section 11. Regulatory Information
Clean Air Act: HAP/ODS:
Page 4 of 6
AMERICAN INTERNATIONAL INDUSTRIES
2220 GASPAR AVENUE
LOS ANGELES, CA 90040
CHEM-TEL: (800) 255-3924
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: EzFlow High Definition - Clear Powder DATE: 11/17/2005
FORMULA: 30-2048 REV. NEW
This product contains the following hazardous air pollutants (HAP's) or ozone depleting
substances (ODS's) as defined by the U.S. Clean Air Act:
* NONE
Clean Water Act: Priority Pollutant:
This product contains the following chemicals listed under the U.S. Clean Water Act Priority
Pollutant List:
* NONE
FDA: Food Packaging Status:
This product has not been cleared by the FDA for use in food packaging and/or other
applications as an indirect food additive.
Occupational Safety and Health Act:
This product is not considered a hazardous chemical under the OSHA Hazard Communication
Standard.
RCRA:
This product contains no chemicals considered to be hazardous waste under RCRA (40 CFR
261).
SARA Title III: Section 302 (TPQ)
This product contains no chemicals regulated under Sec. 302 as extremely hazardous
substances.
SARA Title III: Section 302 (RQ)
This product contains no chemicals regulated under Sec. 304 as extremely hazardous
chemicals for emergency release notification ("CERCLA" List).
SARA Title III: Section 311-312:
This product does not contain hazardous substances under the OSHA Hazard Communication
Standard, and is not regulated under Section 311-312 (40 CFR 370).
SARA Title III: Section 313:
This product contains the following chemicals outlined in SARA Title III: Section 313: Benzoyl
Peroxide CAS #94-36-0.
TSCA Section 8(b) Inventory:
This product contains chemicals listed on the TSCA inventory or otherwise complies with TSCA
premanufacture notification requirements.
TSCA Significant New Use Rule:
None of the chemicals listed have a SNUR under TSCA.
State Regulations:
CA Right-to-Know Law: Benzoyl Peroxide CAS #94-36-0
MA Right-to-Know Law: Benzoyl Peroxide CAS #94-36-0
NJ Right-to-Know Law: Benzoyl Peroxide CAS #94-36-0
PA Right-to-Know Law: Benzoyl Peroxide CAS #94-36-0
FL Right-to-Know Law: Benzoyl Peroxide CAS #94-36-0
MN Right-to-Know Law: Benzoyl Peroxide CAS #94-36-0
Section 12. Other Information
Page 5 of 6
AMERICAN INTERNATIONAL INDUSTRIES
2220 GASPAR AVENUE
LOS ANGELES, CA 90040
CHEM-TEL: (800) 255-3924
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: EzFlow High Definition - Clear Powder DATE: 11/17/2005
FORMULA: 30-2048 REV. NEW
Hazardous Material Identification System (HMIS) Rating:
Health = 1/Flammability = 1/Reactivity = 1
Personal Protective Equipment: Gloves and Safety Glasses or Chemical Splash Goggles.
National Fire Protection Association (NFPA) Hazard Identification Rating:
Health = 1/Flammability = 1/Reactivity = 1
Page 6 of 6
|