Search   
MSDS 
:
 Pyrrolidine
CAS 
:
 123-75-1
SYNONYMS 
:
 Tetrahydropyrrole; tetramethylenimine
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 123-75-1 |Pyrrolidine | 100.0 | 204-648-7 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XN F
Risk Phrases: 11 20/21/22

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Highly flammable. Harmful by inhalation, in contact with skin and if
swallowed.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
Harmful if swallowed. May cause irritation of the digestive tract.
Inhalation:
May cause respiratory tract irritation. Vapors may cause dizziness
or suffocation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of soap and water for at
least 15 minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure to fresh air immediately. If not breathing,
give artificial respiration. If breathing is difficult, give oxygen.
Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
Containers can build up pressure if exposed to heat and/or fire. As
in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. Use water
spray to keep fire-exposed containers cool. Vapors may be heavier
than air. They can spread along the ground and collect in low or
confined areas. May be ignited by heat, sparks, and flame. Containers
may explode when heated.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Use foam, dry chemical, or carbon dioxide. Do NOT get
water inside containers. For large fires, use water spray, fog or
alcohol-resistant foam. Cool containers with flooding quantities of
water until well after fire is out.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition. A
vapor suppressing foam may be used to reduce vapors. Water spray may
reduce vapor but may not prevent ignition in closed spaces.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Ground and bond containers when transferring material. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Avoid contact with heat, sparks and flame. Avoid
ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate general or local explosion-proof ventilation to keep
airborne levels to acceptable levels.
Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29CFR
1910.134 or European Standard EN 149. Always use a
NIOSH or European Standard EN 149 approved respirator
when necessary.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Appearance: colourless
Odor: amine-like
pH: Not available.
Vapor Pressure: 128 mm Hg @39C
Viscosity: Not available.
Boiling Point: 88.5-89.0
Freezing/Melting Point: -63 deg C
Autoignition Temperature: Not applicable.
Flash Point: 3 deg C ( 37.40 deg F)
Explosion Limits, lower: 2.9
Explosion Limits, upper: 13.0
Decomposition Temperature:
Solubility in water: Miscible with water.
Specific Gravity/Density: 0.86
Molecular Formula: (CH2)4NH
Molecular Weight: 71.0697

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
High temperatures, incompatible materials, ignition sources.
Incompatibilities with Other Materials:
Benzaldehyde and propionic acid, oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 123-75-1: UX9650000
LD50/LC50:
CAS# 123-75-1: Inhalation, mouse: LC50 = 1300 mg/m3/2H; Oral, mouse:
LD50 = 450 mg/kg; Oral, rat: LD50 = 300 mg/kg.
Carcinogenicity:
Pyrrolidine -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Other
No information available.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: PYRROLIDINE
Hazard Class: 3
UN Number: 1922
Packing Group: II
IMO
Shipping Name: PYRROLIDINE
Hazard Class: 3
UN Number: 1922
Packing Group: II
RID/ADR
Shipping Name: PYRROLIDINE
Dangerous Goods Code: 3(22B)
UN Number: 1922

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN F
Risk Phrases:
R 11 Highly flammable.
R 20/21/22 Harmful by inhalation, in contact with
skin and if swallowed.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 33 Take precautionary measures against static
discharges.
WGK (Water Danger/Protection)
CAS# 123-75-1: 2
United Kingdom Occupational Exposure Limits

Canada
CAS# 123-75-1 is listed on Canada's DSL List.
CAS# 123-75-1 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
CAS# 123-75-1: OEL-RUSSIA:STEL 0.1 mg/m3;Skin
US FEDERAL
TSCA
CAS# 123-75-1 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 12/12/1997 Revision #1 Date: 8/02/2000

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Propane-1,3-diol 504-63-2
Pyrrolidine 123-75-1
Phigel 2 79-06-1
Phigel 1 79-06-1
Phigel 3 79-06-1
9(10H)-Acridone (Pract), 96% 578-95-0
Silver Cyanide 506-64-9
Sodium Hydride, 80% Dispersion in Mineral Oil 7646-69-7
Silver Perchlorate 7783-93-9
Sebacoyl Chloride 111-19-3
Selenious acid 7783-00-8
Selenium Dioxide 7446-08-4
Selenium 7782-49-2
Palladium 5% on Charcoal 7440-05-3
Phenyllithium, 2M solution in cyclohexane- ether, 70 to 30 60-29-7
Odorless Preservative 0-00-0
Page Blue 83 6104-59-2
Pancreatin (From mammalian pancreas) 8049-47-6
Papain from Papaya Juice 9001-73-4
Phosphomolybdic acid, reagent acs (crystals) 12026-57-2
N,n'-bis(methoxymethyl)diaza-15-crown-5 98%
Paraffin Liquid Light and Heavy 92062-35-6
Paraffin Soft Yellow/White 64771-71-7
Paraffin wax 8002-74-2
Paraldehyde 123-63-7
Pectin 9000-69-5
Rhodamine 19 perchlorate, laser grade 62669-66-3
Pentafluorobenzyl Bromide 1765-40-8
0-(2,3,4,5,6-Pentafluorobenzyl) Hydroxylamine Hydrochloride 57981-02-9
n-Pentane and Pentane Mixed Isomers 109-66-0
0.1M 1-Pentane Sulfonic Acid Sodium Salt 7732-18-5
Pentan-2-Ol 6032-29-7
Peptone 73049-73-7
Perchloric acid 50-70% 7601-90-3
Peroxyphthalic acid magnesium salt, hexahydrate
Petroleum Ether 30-100C 78-78-4
Phenacyl Bromide 70-11-1
Phenanthrene 85-01-8
Phenazone 60-80-0
Phenosafranine 81-93-6
Cyclohexyl isothiocyanate, 98% 1122-82-3
N-Phenylanthranilic Acid
DL-Phenylalanine 150-30-1
o-Phenylenediamine 95-54-5
m-Phenylenediamine 108-45-2
Magnesium Chloride, Hexahydrate 7791-18-6
p-Phenylenediamine 106-50-3
2-Phenylethanol 60-12-8
2-Phenylethylamine 64-04-0
Phenylhydrazine 100-63-0

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net