Search   
MSDS 
:
 Triphenylmethane
CAS 
:
 519-73-3
SYNONYMS 
:
 None known.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 519-73-3 |Triphenylmethane | ca 100 | 208-275-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Dusts may
be combustible when exposed to heat, flame, or oxidizing agents.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Very fine particles can cause a fire or explosion. Eliminate all
ignition sources. Clean up spills immediately, observing precautions
in the Protective Equipment section. Sweep up, then place into a
suitable container for disposal. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Keep container tightly closed. Keep away from heat, sparks
and flame. Avoid ingestion and inhalation.
Storage:
Keep away from heat, sparks, and flame. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 519-73-3:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Powder
Color: faint yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 358 - 359 deg C @ 754.00mm Hg
Freezing/Melting Point: 90 - 94 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: insoluble
Specific Gravity/Density: 1.0140g/cm3
Molecular Formula: C19H16
Molecular Weight: 244.34

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, dust generation, excess
heat, strong oxidants.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 519-73-3 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Triphenylmethane -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 519-73-3: No information available.
Canada
CAS# 519-73-3 is listed on Canada's DSL List.
CAS# 519-73-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 519-73-3 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 12/12/1997 Revision #5 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Buffer Solution pH 4.0 Color Coded Red 877-24-7
Zinc Iodide 10139-47-6
Buffer Solution pH 5.0 877-24-7
Zinc Dibenzyldithiocarbamate 14726-36-4
Zinc Carbonate Basic 5970-47-8
Trimethylchlorosilane 75-77-4
Manganous Cyclohexanebutyrate 35542-88-2
N-(2-Acetamido)-iminodiacetic acid (ADA) 26239-55-4
Acrylomix 5 79-06-1
Manganese chloride 1.0M solution 7732-18-5
Tri-N-Octylamine 1116-76-3
Almond Oil
Antimony atomic absorption standard solution, 1mg/ml Sb in 20% HCl 7647-01-0
Allyl Thiourea 109-57-9
Dimethyl methoxymalonate, 99% 5018-30-4
Trans-1,2-Cyclohexanedicarboxylic Acid 95%, Remainder Cis 2305-32-0
Triphenylamine 603-34-9
N-Trimethylsilylimidazole 18156-74-6
Aluminium lithium hydride 16853-85-3
Sulfuryl chloride fluoride, distilled, 99% 13637-84-8
2,4,6-Trinitrobenzene Sulfonic Acid 2508-19-2
Xylitol 87-99-0
Aluminium Oxide 1344-28-1
Aluminium Tri-Isopropoxide 555-31-7
Triphenyl Phosphite 101-02-0
Aluminum sulfate (n-hydrated) 10043-01-3
4-Aminobenzoic Acid 150-13-0
3-Aminomethylalizarin-NN-Diacetic Acid 3952-78-1
2-Amino-2-methylpropan-1-ol 124-68-5
Trimethylamine Solution 75-50-3
4-Cyano-2,2,5,5-Tetramethyl-3-Imidazoline- 3-Oxide-1-Oxyl, 98%, Free 64918-63-4
Triphenylphosphate 115-86-6
DL-2-Bromopropionic acid, 99+% 598-72-1
Triphenylmethane 519-73-3
1-Amino-2-Naphthol-4-Sulfonic Acid 116-63-2
2,6-Diisopropylnaphthalene, 99% 24157-81-1
DL-Tryptophan 54-12-6
2-Aminophenol 95-55-6
Urease Active Meal 0-01-1
Ceresin Wax 8001-75-0
Methyl Chloroacetate, 99+% 96-34-4
Benzyldimethylhexadecylammonium chloride, hydrate, 97-101% 122-18-9
3-Hydroxybutyric Acid, Tech. 300-85-6
4-Aminophenol 123-30-8
Tetraheptylammonium Chloride, 99% (Titr.) 10247-90-2
Lanette Wax
3-Aminophthalhydrazide 521-31-3
Dodeca-tungstosilicic Acid 12027-38-2
Ammonia Anhydrous Liquified 7664-41-7
Dodeca-Tungstophophoric Acid 12067-99-1

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net