Search   
MSDS 
:
 1-Bromo-2-iodobenzene, 99%, stabilized with copper
CAS 
:
 583-55-1
SYNONYMS 
:
 None.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 583-55-1 |1-Bromo-2-iodobenzene, stabilized with| 99.0+ | 209-508-9 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Light sensitive.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
Antidote:
None reported.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Avoid contact with eyes, skin, and clothing. Keep
container tightly closed. Avoid ingestion and inhalation. Use with
adequate ventilation. Store protected from light. Wash clothing
before reuse.
Storage:
Keep container closed when not in use. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances. Store protected from light.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 583-55-1:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use. Wear a NIOSH/MSHA
or European Standard EN 149 approved full-facepiece
airline respirator in the positive pressure mode with
emergency escape provisions.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 120.0 - 121.0 deg C @ 15.00mm
Freezing/Melting Point: 9.00 - 10.00 deg C
Autoignition Temperature: Not available.
Flash Point: > 110 deg C (> 230.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 2.2030g/cm3
Molecular Formula: C6H4BrI
Molecular Weight: 282.90

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, light, excess heat, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide, hydrogen bromide, hydrogen iodide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 583-55-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
1-Bromo-2-iodobenzene, stabilized with copper -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Other
No information available.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 583-55-1: No information available.
Canada
CAS# 583-55-1 is listed on Canada's NDSL List.
CAS# 583-55-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 583-55-1 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 5/18/1999 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Hexadecyltrimethylammonium hydroxide (25% in methanol) 67-56-1
d-(-)-alpha-Phenylglycine, 98% 875-74-1
1,2-Ethanedithiol, 99+% (GC) 540-63-6
Guaiazulene, 99% 489-84-9
Triethylsilane, 99% 617-86-7
5-Chloro-2-Methylindole, 95% 1075-35-0
Uridine 5'-diphosphate, trisodium salt hydrate 19817-91-5
Coumarin 337, Laser Grade, 99% (UV-Vis) 55804-68-7
5,7-Dimethyl-4-Hydroxypyrido(2,3-D)-Pyrimidine, 98% 0-00-1
beta-Naphthoflavone, 99+% 6051-87-2
1,4-Thioxane-1,1-Dioxide, 99+% 107-61-9
o-Toluic acid, 98+% 118-90-1
1-Bromo-2-iodobenzene, 99%, stabilized with copper 583-55-1
2-Methylheptane, 99% 592-27-8
Pyrrolidone Hydrotribromide, 97% 52215-12-0
Benzyl Methyl Ether, 99% 538-86-3
Pyrazinamide, 99% 98-96-4
3,6-exo-oxo-1,2,3,6-tetrahydrophthalic anhydride 5426-09-5
4-Chlorobenzoyl chloride 122-01-0
Bis-(2-Chloroethyl)-Amine Hydrochloride, 98% 821-48-7
1-Chloro-2-methylpropane, 98% 513-36-0
D(+)-Malic acid, 98% 636-61-3
N-Hydroxyphthalimide, 99% (Titr., Dry Subst., Remainder 10-15% 524-38-9
Ethylamine hydrochloride, 99% 557-66-4
1,2,4-Trifluorobenzene, 97+% 367-23-7
4-Pentyloxyaniline, 99% 39905-50-5
p-Methoxycinnamic acid, 99% (titr.) 830-09-1
3-(Methylthio)-1-Propanol, 98% 505-10-2
Pararosaniline Base 25620-78-4
4-Amino-1,8-naphthalimide, 98% 1742-95-6
P-Toluic Hydrazide, 98% 3619-22-5
Methylhydroquinone, 99% 95-71-6
1,4-Diaminobutane, 99% 110-60-1
Acid Red 88 1658-56-6
Azodicarbonamide, 97% 123-77-3
4-Phenoxyaniline, 97% 139-59-3
(R)-(+)-sec-Phenethyl alcohol, 99% 1517-69-7
(S)-(-)-N-Benzyl-Alpha-Methylbenzylamine, 98% 17480-69-2
4-Pentylbenzoyl Chloride, 99% 49763-65-7
L-(+)-Norvaline, 99% 6600-40-4
Cortexolone, 99% 152-58-9
1-Nonene, 99% 124-11-8
2-Amino-5-Ethyl-1,3,4-Thiadiazole, 98+% 14068-53-2
2,3,7-Trimethylindole 27505-78-8
5-[(4,6-Dichlorotriazin-2-yl)amino] fluorescein hydrochloride, 99% 21799-87-1
3-(2-Isothiocyanatoethyl-carbamoyl)-PROXYL, free radical 100929-92-8
1-Dodecanol, 98% 112-53-8
(3-Mercaptopropyl)trimethoxysilane tech. 85% 67-56-1
Sparkleen 2 497-19-8
N-(2-Hydroxyethyl)Piperazine, 98% 103-76-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net