Search   
MSDS 
:
 Phthalic Anhydride
CAS 
:
 85-44-9
SYNONYMS 
:
 None
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 85-44-9 |Phthalic anhydride | 100.0 | 201-607-5 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Corrosive.

Potential Health Effects
Eye:
Contact with eyes may cause severe irritation, and possible eye
burns.
Skin:
May cause skin sensitization, an allergic reaction, which becomes
evident upon re-exposure to this material. May cause severe
irritation and possible burns.
Ingestion:
Causes gastrointestinal tract burns.
Inhalation:
May cause severe irritation of the respiratory tract with sore
throat, coughing, shortness of breath and delayed lung edema. Causes
chemical burns to the respiratory tract.
Chronic:
Chronic inhalation and ingestion may cause effects similar to those
of acute inhalation and ingestion.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Destroy contaminated shoes.
Ingestion:
Get medical aid immediately. Do NOT induce vomiting. If conscious
and alert, rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Sweep up, then place into a suitable container for disposal.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation. Do
not get in eyes, on skin, or on clothing. Do not ingest or inhale.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate general or local exhaust ventilation to keep airborne
concentrations below the permissible exposure limits.
Exposure Limits
CAS# 85-44-9:
United Kingdom, WEL - TWA: 4 mg/m3 TWA
United Kingdom, WEL - STEL: 12 mg/m3 STEL
United States OSHA: 2 ppm TWA; 12 mg/m3 TWA
Belgium - TWA: 1 ppm VLE; 6.2 mg/m3 VLE
France - VLE: 6 mg/m3 VLE
Germany: 1 mg/m3 TWA (inhalable fraction)
Japan: 0.33 ppm Ceiling; 0.2 mg/m3 Ceiling
Malaysia: 1 ppm TWA; 6.1 mg/m3 TWA
Netherlands: 2 mg/m3 STEL
Netherlands: 1 mg/m3 MAC
Russia: 1 mg/m3 TWA
Spain: 1 ppm VLA-ED; 6 mg/m3 VLA-ED

Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves and clothing to
prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Color: white
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 284 deg C
Freezing/Melting Point: 131 deg C
Autoignition Temperature: Not applicable.
Flash Point: 151 deg C ( 303.80 deg F)
Explosion Limits, lower: 1.2
Explosion Limits, upper: 9.2
Decomposition Temperature:
Solubility in water: Very crystalline flakes
Specific Gravity/Density: Not available.
Molecular Formula: C6H4(CO)2O
Molecular Weight: 148.0262

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials.
Incompatibilities with Other Materials:
Strong acids - strong bases - strong oxidizing agents - strong
reducing agents - moisture.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 85-44-9: TI3150000
LD50/LC50:
CAS# 85-44-9: Draize test, rabbit, eye: 50 mg/24H Moderate; Draize
test, rabbit, skin: 500 mg/24H Mild; Inhalation, rat: LC50 = >210
mg/m3/1H; Oral, mouse: LD50 = 1500 mg/kg; Oral, rat: LD50 = 1530
mg/kg; Skin, rabbit: LD50 = >10 gm/kg.
Carcinogenicity:
Phthalic anhydride -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: PHTHALIC ANHYDRIDE
Hazard Class: 8
UN Number: 2214
Packing Group: III
IMO
Shipping Name: PHTHALIC ANHYDRIDE
Hazard Class: 8
UN Number: 2214
Packing Group: III
RID/ADR
Shipping Name: PHTHALIC ANHYDRIDE
Hazard Class: 8
UN Number: 2214
Packing group: III
USA RQ: CAS# 85-44-9: 5000 lb final RQ; 2270 kg final RQ

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
WGK (Water Danger/Protection)
CAS# 85-44-9: 0
Canada
CAS# 85-44-9 is listed on Canada's DSL List.
CAS# 85-44-9 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 85-44-9 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 12/12/1997 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Phenylhydrazium Chloride 59-38-1
Magnesium nitrate 10377-60-3
Phenyl Mercury Acetate 62-38-4
Phenyl Mercury Chloride 100-56-1
Magnesium Sulfate, Hydrated 10034-99-8
Phenylmethylsulfonyl Fluoride 329-98-6
Phenylthiourea 103-85-5
Malachite Green (Oxalate) Certified 2437-29-8
Iso-Phorone 78-59-1
Maltose 69-79-4
Isopropyl Myristate, 96% (GC) 110-27-0
Phosgene solution in toluene 75-44-5
DL-Mandelic acid 90-64-2
Phosphorus Red Amorphous 7723-14-0
Manganese metal 7439-96-5
Phosphorus, White Sticks 7723-14-0
Polyvinyl Pyrrolidone 9003-39-8
o-Tolylhydrazine hydrochloride, 98% 635-26-7
5-Hydroxyindole, 97% 1953-54-4
Manganese (II) Acetate Tetrahydrate 6156-78-1
Phosphorus Pentasulfide 1314-80-3
Phosphorus Tribromide 7789-60-8
Phosphorus Trichloride 7719-12-2
N,N-Diethyl-m-toluamide, 95% 134-62-3
Phthalic Acid 88-99-3
Magnesium Chloride Solution 7732-18-5
Chloromethyl Methyl Sulfide, 95% 2373-51-5
Manganese(II) sulfate, tetrahydrate 7785-87-7
Manganese(II) sulfate, dried powder 7785-87-7
D- (+)- Mannose 3458-28-4
Marble Chips 471-34-1
Phthalic Anhydride 85-44-9
Phthalimide 85-41-6
Picrolonic Acid 550-74-3
Picric Acid, Moistened with 40.0% Water 88-89-1
Pinacol 76-09-5
Piperazine Hydrate 142-63-2
Piperazine-N,N bis(2-ethane sulfonic acid) 5625-37-6
Platinum Metal 7440-06-4
Platinum (IV) Dioxide 1314-15-4
Osmium (VIII) Oxide Solutions 1% and 2% w/v 7732-18-5
Orthophosphoric acid 100% 7664-38-2
Oil Red O 14288-70-1
Nonidet P40 9036-19-5
N-Nonane 111-84-2
Nitroso-R-Salt 525-05-3
4-Nitrophenyl Disodium Orthophosphate 4263-52-9
Melamine 108-78-1
4-(4-Nitrophenylazo)resorcinol 74-39-5
4-Nitrotoluene 99-99-0

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net