**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 88-09-5 |2-Ethylbutyric acid | 99 | 201-796-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 21 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Harmful in contact with skin. Irritating to eyes, respiratory system
and skin.
Potential Health Effects
Eye:
Causes severe eye irritation.
Skin:
Causes mild skin irritation. Harmful if absorbed through the skin.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
May cause narcotic effects in high concentration. Causes irritation
of mucous membrane.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Use water spray to keep fire-exposed containers
cool. Water may be ineffective. Material is lighter than water and a
fire may be spread by the use of water. Combustible liquid. Vapors
may be heavier than air. They can spread along the ground and
collect in low or confined areas. Containers may explode when
heated.
Extinguishing Media:
Use water spray to cool fire-exposed containers. In case of fire,
use carbon dioxide, dry chemical powder or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Empty containers retain product residue, (liquid and/or vapor), and
can be dangerous. Keep container tightly closed. Keep away from
heat, sparks and flame. Do not get on skin or in eyes. Avoid
ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Corrosives
area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 88-09-5:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: Colorless Liquid
Odor: Rancid Odor
pH: Not available.
Vapor Pressure: 0.08 mm Hg @ 20 C
Viscosity: 3.3 MPA 20.00 deg C
Boiling Point: 99.0 - 101.0 deg C @ 18.00mm
Freezing/Melting Point: -14 deg C
Autoignition Temperature: 463 deg C ( 865.40 deg F)
Flash Point: 87 deg C ( 188.60 deg F)
Explosion Limits, lower: 1.40 vol %
Explosion Limits, upper: .00 vol %
Decomposition Temperature:
Solubility in water: Slightly soluble.
Specific Gravity/Density: .9240g/cm3
Molecular Formula: C6H12O2
Molecular Weight: 116.16
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat.
Incompatibilities with Other Materials:
Bases, strong oxidizing agents, strong reducing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 88-09-5: ET1400000
LD50/LC50:
CAS# 88-09-5: Oral, rat: LD50 = 2200 mg/kg; Skin, rabbit: LD50 = 520
uL/kg.
Carcinogenicity:
2-Ethylbutyric acid -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: TOXIC LIQUID, ORGANIC, N.O.S.*
Hazard Class: 6.1
UN Number: 2810
Packing Group: III
IMO
Shipping Name: TOXIC LIQUID, ORGANIC, N.O.S.
Hazard Class: 6.1
UN Number: 2810
Packing Group: III
RID/ADR
Shipping Name: TOXIC LIQUID, ORGANIC, N.O.S.
Hazard Class: 6.1
UN Number: 2810
Packing group: III
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 21 Harmful in contact with skin.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 23 Do not inhale gas/fumes/vapour/spray.
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 88-09-5: 1
Canada
CAS# 88-09-5 is listed on Canada's DSL List.
CAS# 88-09-5 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 88-09-5 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 11/10/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Methyl 2-Thiofuroate, 97%
| 13679-61-3 |
|
(+)-Chloromethyl menthyl ether, 95%, 97% e.e.
| 96662-07-6 |
|
2,5-Difluorobenzonitrile, 99%
| 64248-64-2 |
|
2-Methylbenzothiazole, 96% (gc)
| 120-75-2 |
|
4-Methylmorpholine N-oxide monohydrate, 97% (titr.)
| 7529-22-8 |
|
Sulfonazo iii,tetrasodium salt, p.a.
| 68504-35-8 |
|
3,4-Dimethylbenzoic Acid, 98%
| 619-04-5 |
|
5-Methyltryptamine hydrochloride, 98%
| 55795-89-6 |
|
2,5-Dimethylbenzyl alcohol, 98%
| 53957-33-8 |
|
1,3-Diphenylacetone, 99%
| 102-04-5 |
|
N-Phenyl-o-phenylenediamine, 97%
| 534-85-0 |
|
Phosphorous Acid, Crystalline
| 10294-56-1 |
|
N,N-Dimethylformamide dicyclohexyl acetal, 99%
| 2016-05-9 |
|
3-Bromo-4-methoxybenzaldehyde, 98%
| 34841-06-0 |
|
2-Amino-6-Methylbenzoic Acid, 98%
| 4389-50-8 |
|
2,2,5,5-Tetramethyl-4-Phenyl-3-Imidazoline -1-Oxyl, Free Radical
| 39753-69-0 |
|
2,7-Dimethoxynaphthalene, 98%
| 3469-26-9 |
|
Fast yellow GC salt
| 14263-92-4 |
|
2-Ethylbutyric acid, 99%
| 88-09-5 |
|
(s)-(-)-sec-Phenethyl alcohol, 99%
| 1445-91-6 |
|
DOUBLE-TIPPED NEEDLE, 18 GAUGE STAINLESS, STEEL, 2 FEET
| |
|
Chlorazol Black E, certfied
| 1937-37-7 |
|
4-Fluorophenylacetonitrile, 95%
| 459-22-3 |
|
1-Hexadecylpyridinium bromide
| 140-72-7 |
|
Bromoacetonitrile, 97%
| 590-17-0 |
|
Octane
| 111-65-9 |
|
4-Methylsulphonylaniline Hydrochloride , 95+%
| 5470-49-5 |
|
Dichloroacetic Acid, 99+%
| 79-43-6 |
|
1-Octanol
| 111-87-5 |
|
Cyclohexane-D12, 99.5 Atom % D
| 1735-17-7 |
|
4-Isopropoxybenzoic acid, 98%
| 13205-46-4 |
|
n-Undecylamine, 98%
| 7307-55-3 |
|
(1R,2S)-1-Amino-2-indanol, 98%, (99% e.e.)
| 136030-00-7 |
|
Copper(II)-Ethylenediamine Complex for Viscosity Determination of
| 14552-35-3 |
|
Tris-(Triphenylphosphine)-Rhodium(I)Chloride, 99.99%
| 14694-95-2 |
|
Tetrabutylammonium iodide, 98%
| 311-28-4 |
|
2,2-Dimethyl-3-Pentanol, 97%
| 3970-62-5 |
|
2-Aminophenol (pract), 97% (titr.)
| 95-55-6 |
|
Orcinol Monohydrate
| 6153-39-5 |
|
Olive oil
| 8001-25-0 |
|
Nickel (II) Bromide Hydrate, 98%
| 7789-49-3 |
|
1-(2,4-Dimethylphenyl)Piperazine
| 1013-76-9 |
|
Osmic Acid Anhydride
| 20816-12-0 |
|
Ethyl undecanoate, 97%
| 627-90-7 |
|
8-Hydroxy-1,1,7,7-tetramethyljulolidine-9- carboxaldehyde
| 115662-09-4 |
|
Ethyl isonicotinate, 99+%
| 1570-45-2 |
|
8-Hydroxy-5-Quinesulfonic Acid, Mono- Hydrate, 94% (UV-VIS)
| 84-88-8 |
|
Oxalic acid dihydrate
| 144-62-7 |
|
4-(1H)-Pyridone (Pract), 97% (UV-VIS)
| 108-96-3 |
|
Vanadyl(IV)-sulfate hydrate, 17-23% Vanadium
| 12439-96-2 |
|
|