Search   
MSDS 
:
 Isophthaloyl dichloride, 98%
CAS 
:
 99-63-8
SYNONYMS 
:
 Isophthaloyl chloride; 1,3-Benzenedicarbonyl chloride.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 99-63-8 |Isophthaloyl dichloride | 98 | 202-774-7 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 21 34

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Harmful in contact with skin. Causes burns.Moisture
sensitive.Corrosive.

Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns. May cause severe irritation and possible burns.
May be harmful if absorbed through the skin.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes
gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract. Inhalation of dust
may cause respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Get medical aid immediately. Do NOT allow victim to rub eyes or keep
eyes closed. Extensive irrigation with water is required (at least 30
minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If breathing is difficult, give oxygen. Do NOT use
mouth-to-mouth resuscitation. If breathing has ceased apply
artificial respiration using oxygen and a suitable mechanical device
such as a bag and a mask.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
Do NOT use water directly on fire. Use foam, dry chemical, or carbon
dioxide. Do NOT get water inside containers.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Avoid runoff into storm sewers and ditches which lead to waterways.
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Avoid generating dusty conditions. Provide ventilation. Do
not get water inside containers.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Minimize dust generation and accumulation. Keep container tightly
closed. Do not get on skin or in eyes. Do not ingest or inhale. Use
with adequate ventilation. Do not allow contact with water. Discard
contaminated shoes. Keep from contact with moist air and steam.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Corrosives
area. Store protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 99-63-8:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Crystals
Color: white
Odor: None reported.
pH: Not available.
Vapor Pressure: 0.03 mmHg @ 25
Viscosity: Not available.
Boiling Point: 276 deg C @ 760 mm Hg
Freezing/Melting Point: 43 - 44 deg C
Autoignition Temperature: Not available.
Flash Point: 180 deg C ( 356.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Reacts.
Specific Gravity/Density: 1.389 @ 47C
Molecular Formula: C8H4Cl2O2
Molecular Weight: 203.02

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Dust generation, moisture, excess heat.
Incompatibilities with Other Materials:
Alcohols, strong oxidizing agents, strong bases, water.
Hazardous Decomposition Products:
Hydrogen chloride, phosgene, carbon monoxide, irritating and toxic
fumes and gases, carbon dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 99-63-8: NT2625000
LD50/LC50:
CAS# 99-63-8: Draize test, rabbit, eye: 40 mg Mild; Oral, mouse:
LD50 = 2221 mg/kg; Oral, rabbit: LD50 = 1175 mg/kg; Oral, rat: LD50 =
2200 mg/kg; Skin, rabbit: LD50 = 1410 mg/kg.
Carcinogenicity:
Isophthaloyl dichloride -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: CORROSIVE SOLID, N.O.S.*
Hazard Class: 8
UN Number: 1759
Packing Group: II
IMO
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing group: II

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 21 Harmful in contact with skin.
R 34 Causes burns.
Safety Phrases:
S 7/8 Keep container tightly closed and dry.
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 99-63-8: 2
Canada
CAS# 99-63-8 is listed on Canada's DSL List.
CAS# 99-63-8 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 99-63-8 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 2/23/1999 Revision #3 Date: 7/15/2004

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
N-Propyl Acetate, 99+% 109-60-4
Rhodizonic acid dipotassium salt, 95% (uv-vis) 13021-40-4
delta-Valerolactone, 99% 542-28-9
Octaethylporphine 2683-82-1
(2r,4r)-(-)-pentanediol, 99% 42075-32-1
3'-Chloropropiophenone, 98% 34841-35-5
16-Doxyl-Stearic Acid, Free Radical 53034-38-1
(Trifluoromethoxy)benzene, 99+% 456-55-3
N-Butyramide 99% 541-35-5
O-Acetylmandelic acid chloride, 95% 1638-63-7
2-Ethylhexyl cyanoacetate, 98+% 13361-34-7
Pyruvic aldehyde dimethyl acetal, 98% 6342-56-9
1,1'-Diethyl-2,2'-Cyanine Iodide, 99% (UV-Vis) 977-96-8
Isophthaloyl dichloride, 98% 99-63-8
Dibutyltin diacetate, pract. 1067-33-0
Methyl cinnamate, 98% 103-26-4
L-Cystine Dimethyl Ester Dihydrochloride 32854-09-4
Corn Oil, U.S.P./N.F. 8001-30-7
3-Iodobenzylamine hydrochloride, 97% 3718-88-5
4-Phenoxyphenol, 99% 831-82-3
1,10-Phenanthroline monohydrochloride monohydrate, 97% 3829-86-5
Ethyl 3-N-Ethyl-Aminoacrylate 55330-56-8
Phenetole, 99% 103-73-1
Nickel atomic absorption standard solution, 1 mg/ml Ni in 2% HNO3 7440-02-0
Ethyl Glycolate, 95% (GC) 623-50-7
Magnesium Fluoride, 98+% 7783-40-6
Homovanillic Acid, 98% 306-08-1
(R,R)-(-)-1,2-Dicyclohexyl-1,2-Ethanediol, 99% 120850-92-2
Methyl nicotinate, 99% 93-60-7
D-(+)-Talose, 99% 2595-98-4
1,3-Phenylenediacetic acid, 97% 19806-17-8
Ethyl 4-bromocrotonate, tech., 75% 37746-78-4
(s)-(-)-alpha-(1-Naphtyl)ethylamine, 99+%, 10420-89-0
Homophthalic acid, 99% 89-51-0
p-Xylene-alpha,alpha,alpha,alpha',alpha',alpha'-d6, 99+ atom % D 106-42-3
Coumestrol, 99% (UV-Vis) 479-13-0
2-Amino-5-nitropyridine, 99% 4214-76-0
2-Amino-5-Chlorobenzoxazole, 97% 61-80-3
alpha-Naphtholphthalein, indicator 596-01-0
3-Picoline, 99.5+% 108-99-6
Chromium(vi) oxide pyridine complex 20492-50-6
N-Butylcarbamate, 97% 592-35-8
6-Bromo-7-Nitroquinoxaline, 95% 113269-09-3
n-2-Acetylguanine, 99+% 19962-37-9
1,2:5,6-Di-O-Isopropylidene-Alpha-D-Allofuranose, 98% 2595-05-3
N-Cyanoimido Dimethyl Carbonate, 95% (on Dry Substance) 0-00-1
l-(-)-Glyceraldehyde 90 wt% aqueous solution 497-09-6
5-Aminoisophthalic Acid, 98+%(Titr.; Dry Substance) 99-31-0
Flufenamic Acid, 97% 530-78-9
Lipase AY30, according to amano's specification 9001-62-1

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net