INTERPLASTIC CORPORATION -- SIL95BA-40 PE RESIN (EZ CAST) 101082BRW33
=======================================================
Material Safety Data Sheet
=======================================================
MSDS Num: CLGMS
MSDS NAME: SIL95BA-40 PE RESIN (EZ CAST) 101082BRW33
Kit Part: Y
Responsible Party
Name: INTERPLASTIC CORPORATION
Address: 1225 WILLOW LAKE BLVD
City: VADNAIS HEIGHTS MN 55110-5145
Info Phone: 612-331-6850
Emergency Phone Number: 612-481-6860/800-424-9300(CHEMTREC)
Resp. Party Other MSDS No.: MSDSLETO
=======================================================
Ingredients
=======================================================
Name: UNSATURATED POLYESTER BASE RESIN
% low Wt: 62.
% high Wt: 64.
Other REC Limits: NONE RECOMMENDED
OSHA PEL: NOT ESTABLISHED
ACGIH TLV: NOT ESTABLISHED
-----------------------------
Cas: 100-42-5
RTECS #: WL3675000
Name: STYRENE
% low Wt: 36.
% high Wt: 38.
Other REC Limits: NIOSH 50 PPM, 8HR
OSHA PEL: 50 PPM
OSHA STEL: 100 PPM
ACGIH TLV: 50 PPM
ACGIH STEL: 100 PPM
EPA Rpt Qty: 1000 LBS
DOT Rpt Qty: 1000 LBS
=======================================================
Health Hazards Data
=======================================================
Carcinogenicity Inds - NTP: NO
IARC: NO
OSHA: NO
Explanation Of Carcinogenicity: STYRENE HAS BEEN IDENTIFIED AS A POSSIBLE HUMAN
CARCINOGEN BY IARC. THE IARC DETERMINATION IS BASED ON "LIMITED EVIDENCE" IN
ANIMALS & OTHER "RELEVANT DATA". IARC CONCEDEDS THERE IS INADEQUATE
EVIDENC E ON HUMANS FOR ITS FINDINGS.
Signs And Symptions Of Overexposure: FOR STYRENE: EYES: CAN CAUSE SEVERE
IRRITATION, REDNESS, TEARING, BLURRED VISION. SKIN: PROLONGED OR REPEATED
CONTACT CAN CAUSE MODERATE IRRITATION, DEFATTING, DERMATITIS. BREATHING -
EXCESSIVE INHALA TION OF VAPORS CAN CAUSE NASAL IRRITATION, DIZZINESS,
WEAKNESS, FATIGUE, NAUSEA, HEADACHE, POSSIBLE UNCONSCIOUSNESS, AND EVEN
ASPHYXIATION. SWALLOWING - CAN CAUSE GASTROINTESTINAL IRRITATION, NAUSEA,
VOMITING, DIARRHEA. ASPIRATION OF MATERIAL INTO THE LUNGS CAN CAUSE CHEMICAL
PNEUMONITIS.
Medical Cond Aggravated By Exposure: OVEREXPOSURE TO STYRENE HAS APPARENTLY
BEEN FOUND TO CAUSE THE FOLLOWING EFFECTS IN LABORATORY ANIMALS: LIVER
ABNORMALITIES, KIDNEY DAMAGE, AND LUNG DAMAGE.
First Aid: SKIN: THOROUGHLY WASH EXPOSED AREA WITH SOAP AND WATER. REMOVE
CONTAMINATED CLOTHING. LAUNDER CONTAMINATED CLOTHING BEFORE RE-USE. EYES:
FLUSH WITH LARGE AMOUNT OF WATER, LIFTING UPPER AND LOWER LIDS OCCASIONALLY.
GET MEDICAL ATTENTION. SWALLOWED: DO NOT INDUCE VOMITING. KEEP PERSON WARM,
QUIET AND GET MEDICAL ATTENTION. ASPIRATION OF MATERIAL INTO THE LUNGS DUE TO
VOMITING CAN CAUSE CHEMICAL PNEU MONITIS WHICH CAN BE FATAL. BREATHING IF
AFFECTED, REMOVE INDIVIDUAL TO FRESH AIR. IF BREATHING IS DIFFICULT,
ADMINISTER OXYGEN. IF BREATHING HAS STOPPED, GIVE ARTIFICIAL RESPIRATION.
KEEP PERSON WARM , QUIET, & GET MEDICAL ATTENTION.
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: SMAL SPILL: ABSORB LIQUID ON PAPER, VERMICULITE,
FLOOR ABSORBENT, OTHER ABSORBENT MATERIAL & TRANSFER TO HOOD. "SEE OTHER
INFO"
Waste Disposal Methods: SMALL-ALLOW VOLATILE PORTION TO EVAPORATE IN HOOD.
ALLOW SUFFICIENT TIME FOR VAPORS TO COMPLETELY CLEAR HOOD DUCT WORK. DISPOSE
OF REMAINING MATERIAL IN ACCORD WITH APPLICABLE REGULATIONS. LARGE-DESTR OY
BY LIQUID INCINERATION WITH APPLICABLE REGULATIONS. CONTAMINATED ABSORBENT
SHOULD BE DISPOSED OF IN ACCORD WITH LOCAL, STATE & FEDERAL REGULATIONS.
Handling And Storage Precautions: STORE ABOVE 38 DEG C (100 DEG F). CONTAINERS
OF THIS MATERIAL MAY BE HAZARDOUS WHEN EMPTIED, SINCE EMPTIED CONTAINERS
RETAIN PRODUCT RESIDUES (VAPORS, LIQUID, AND/OR SOLID), ALL HAZARD
PRECAUTIONS GIV EN IN THIS DATA SHEET MUST BE OBSERVED.
Other Precautions: RATING: (H=2, F=3, R=1).
=======================================================
Fire and Explosion Hazard Information
=======================================================
Flash Point: =31.1C, 88.F
Lower Limits: 1.1
Upper Limits: 6.1
Extinguishing Media: REGULAR FOAM OR CARBON DIOXIDE OR DRY CHEMICAL.
Fire Fighting Procedures: WATER OR FOAM MAY CAUSE FROTHING WHICH CAN BE VIOLENT
AND POSSIBLY ENDANGER THE LIFE OF THE FIREFIGHTER, ESPECIALLY IF SPRAYED INTO
CONTAINERS OF HOT, BURNING LIQUID. WEAR SELF-CONTAINED BREATHING APP ARATUS
WITH A FULL FACEPIECE OPERATED IN PRESSURE DEMAND OR OTHER POSITIVE PRESSURE
MODE WHEN FIGHTING FIRES.
Unusual Fire/Explosion Hazard: VAPOR IS HEAVIER THAN AIR AND MAY TRAVEL ALONG
THE GROUND OR MAY BE MOVED BY VENTILATION AND IGNITED BY PILOTLIGHTS, OTHER
FLAMES, SPARKS, HEATERS, SMOKING, ELECTRIC MOTORS, STATIC DISCHARGE, OR OTHER
IGNITION SOURCES AT LOCATIONS DISTANT FROM MATERIAL HANDLING POINT.
=======================================================
Control Measures
=======================================================
Respiratory Protection: IF TLV OF THE PRODUCT OR ANY COMPONENT IS EXCEEDED, A
NIOSH/MSHA JOINTLY APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN ABSENCE OF
PROPER ENVIRONMENTAL CONTROL. OSHA REGULATIONS ALSO PERMIT OTHER NIOS H/MSHA
RESPIRATORS UNDER SPECIFIED CONDITIONS. ENGINEERING OR ADMINISTRATIVE
CONTROLS SHOULD BE IMPLEMENTED TO REDUCE EXPOSURE.
Ventilation: PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL EXHAUST)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves: WEAR CHEMICAL RESISTANT GLOVES; SUCH AS NEOPRENE, RUBBER,
LATEX, ETC.
Eye Protection: SAFETY GLASSES/CHEMICAL SPLASH GOGGLES.
Other Protective Equipment: EYE WASH STATION, SAFETY SHOWER, WORK CLOTHING AND
APRON AS REQUIRED.
Work Hygienic Practices: OBSERVE GOOD INDUSTRIAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. WASH THOROUGHLY BEFORE EATING, DRINKING AND SMOKING.
Supplemental Safety and Health: ITEM IS PART OF A TWO PART KIT. CONTRACTOR'S
PART NUMBER/TRADE NAME: VTK-001/VOLTAGE KIT: (1) PE RESIN & (2) CATALYST
(2 PARTS). SEE MSDS SERIAL #. PRODUCT NAME: SIL95BA-40 PE RESIN (EZ CAST)
101082B RW33. GENERAL OR GENERIC ID: UNSATURATE POLYESTER RESIN.
=======================================================
Physical/Chemical Properties
=======================================================
HCC: F3
NRC/State LIC No: NOT RELEVANT
Boiling Point: =145.2C, 293.4F
B.P. Text: @760.00 MM HG
Vapor Pres: 4.3 MM HG @ 68F
Vapor Density: 3.6(AIR=1)
Spec Gravity: 1.0 - 1.2
Viscosity: UNKNOWN
Evaporation Rate & Reference: SLOWER THAN ETHER
Solubility in Water: UNKNOWN
Appearance and Odor: UNSATURATED POLYESTER RESIN (LIQUID)
Percent Volatiles by Volume: 36- 38 WT
Corrosion Rate: UNKNOWN
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES
Stability Condition To Avoid: EXPOSURE TO EXCESSIVE HEAT OR OPEN FLAME; STORE
IN OPEN CONTAINERS; PROLONGED STORAGE (6 MONTHS). CONTAMINATION WITH
OXIDIZING AGENTS.
Materials To Avoid: AVOID CONTACT WITH: STRONG ALKALIES, STRONG MINERAL ACIDS
AND OXIDIZING AGENTS.
Hazardous Decomposition Products: CARBON MONOXIDE, CARBON DIOXIDE, LOW
MOLECULAR WEIGHT HYDROCARBONS, ORGANIC ACIDS, VARIOUS HYDROCARBONS.
Hazardous Polymerization Indicator: YES
Conditions To Avoid Polymerization: CAN OCCUR.
=======================================================
Toxicological Information
=======================================================
Toxicological Information: STYRENE IS NOT EXPECTED TO CAUSE CANCER IN HUMANS AT
CONCENTRATIONS BELOW THE RECOMMENDED XPOSURE STANDARD OR WHEN APPROPIATE
INDUSTRIAL HYGIENE PROCEDURES ARE FOLLOWED. MOREOVER, STUDIES IN HUMANS EX
POSED FOR LONG PERIODS OF TIME TO STYRENE HAVE NOT DEMOSTRATED ANY
CARCINOGENIC EFFECTS. AT THE CONCLUSION OF A MAJOR NOTICE & COMMENT
RULEMAKING REVISING ITS AIR CONTAMINATION REGULATIONS, OSHA CONC LUDED THAT
THE "CURRENT EVIDENCE ON STYRENE'S CARCINOGENICITY DOES NOT SUPPORT IST
CLASSIFICATION IN THE FIANL RULE AS A CARCINOGEN". THE NTP DOES NOT INCLUDE
STYRENE ON ITS LIST OF CHEMICALS EXPECTED TO BE CARCINOGENIC.
=======================================================
Ecological Information
=======================================================
=======================================================
MSDS Transport Information
=======================================================
Transport Information: UN/NA NUMBER: UN1866. HAZARD CLASSIFICATION: FLAMMABLE
LIQUID.
=======================================================
Regulatory Information
=======================================================
Sara Title III Information: THIS PRODUCT CONTAINS TOXIC CHEMICALS SUBJECT TO
THE REPORTING REQUIREMENTS OF SECTION 313 OF THE EMERGENCY PLANNING AND
COMMUNITY RIGHT-TO-KNOWN ACT OF 1986 AND OF 40 CFR 372.
=======================================================
Other Information
=======================================================
Other Information: LARGE SPILL: ELIMINATE ALL IGNITION SOURCES (FLARES, FLAMES,
INCLUDE PILOT LIGHTS, ELECTRICAL SPARKS). PERSONS NOT WEARING PROTECTIVE
EQUIPMENT SHOULD BE EXCLUDED FROM AREA OF SPILL UNTIL CLEAN-UP COM PLETED.
STOP SPILL AT SOURCE, DIKE AREA OF SPILL TO PREVENT SPREADING, PUMP LIQUID TO
SALVAGE TANK. REMAINING LIQUID MAY BE TAKEN UP ON SAND, CLAY, EARTH, FLOOR
ABSORBENT OR OTHER ABSORBENT MATERIAL & SHOVELED INTO CONTAINERS.
=======================================================
Transportation Information
=======================================================
Trans ID NO: 157800
MSDS NAME: SIL95BA-40 PE RESIN (EZ CAST) 101082BRW33
MSDS Prepared Date: 04/30/1996
Review Date: 07/08/2001
Multiple KIT Number: 0
Kit Part IND: Y
Review IND: Y
Unit Of Issue: CY
Type Of Container: CYLINDER
=======================================================
Detail DOT Information
=======================================================
DOT PSN QS
DOT Proper Shipping Name: RESIN SOLUTION
DOT PSN Modifier: FLAMMABLE
Hazard Class: 3
UN ID Num: UN1866
DOT Packaging Group: III
Label: FLAMMABLE LIQUID
Special Provision: B1,B52,T7,T30
Packaging Exception: 150
Non Bulk Pack: 173
Bulk Pack: 242
Max Qty Pass: 60 L
Max Qty Cargo: 220 L
Vessel Stow Req: A
=======================================================
Detail IMO Information
=======================================================
IMO PSN Code: NBJ
IMO Proper Shipping Name: RESIN,SOLUTION
IMO PSN Modifier: FLAMMABLE o
IMDG Page Number: 3379
UN Number: 1866
UN Hazard Class: 3.3
IMO Packaging Group: III
Subsidiary Risk Label: -
EMS Number: 3-05
MED First Aid Guide NUM: 310
=======================================================
Detail IATA Information
=======================================================
IATA PSN Code: VSA
IATA UN ID Num: 1866
IATA Proper Shipping Name: RESIN SOLUTION
IATA PSN Modifier: ,FLAMMABLE
IATA UN Class: 3
IATA Label: FLAMMABLE LIQUID
UN Packing Group: III
Packing Note Passenger: 309
Max Quant Pass: 60L
Max Quant Cargo: 220L
Packaging Note Cargo: 310
=======================================================
Detail AFI Information
=======================================================
AFI PSN Code: VSA
AFI Proper Shipping Name: RESIN SOLUTION
AFI PSN Modifier: ,FLAMMABLE
AFI Hazard Class: 3
AFI UN ID NUM: UN1866
AFI Packing Group: III
Special Provisions: P5
Back Pack Reference: A7.3
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: SIL95BA-40 PE RESIN (EZ CAST) 101082BRW33
Assigned IND: Y
Company: INTERPLASTIC CORPORATION
Street: 1225 WILLOW LAKE BLVD
City: VADNAIS HEIGHTS MN
Zipcode: 55110-5145
Health Emergency Phone: 612-481-6860/800-424-9300(CHEMTREC)
Label Required IND: Y
Date Of Label Review: 07/08/2001
Status Code: A
Origination Code: F
Eye Protection IND: YES
Skin Protection IND: YES
Signal Word: DANGER
Respiratory Protection IND: YES
Health Hazard: Moderate
Contact Hazard: Moderate
Fire Hazard: Severe
Reactivity Hazard: Slight
Hazard And Precautions: SMAL SPILL: ABSORB LIQUID ON PAPER, VERMICULITE, FLOOR
ABSORBENT, OTHER ABSORBENT MATERIAL & TRANSFER TO HOOD.
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.
*** END OF RECORD *** |
|
|