===================== Product Identification =====================
MSDS NAME:TRU-TEST SUPREME WOODSMAN SANDING SEALER, 0
NIIN:00N019406
MSDS Number: BLGPP
=== Responsible Party ===
Company:GENERAL PAINT & CHEMICAL
Address:201 JANDUS RD
City:CARY
State:IL
ZIP:60013
Country:US
Info Phone Num:708-639-5383
Emergency Phone Num:800-226-5635
CAGE:GENEA
=== Contractor Identification ===
Company:GENERAL PAINT & CHEMICAL
Address:201 JANDUS ROAD
City:CARY
State:IL
ZIP:60013
Phone:(312) 639-5383
CAGE:GENEA
============= Composition/Information on Ingredients =============
Name:HYDROTREATED LIGHT PETROLEUM DISTILLATE; (MINERAL SPIRITS).
VP:2.0 @ 68F. (LIMITS AS STODDARD SOLVENT).
CAS:64742-47-8
Fraction by Wt: 30-35%
OSHA PEL:100 PPM
ACGIH TLV:100 PPM
Name:VM&P NAPHTHA (LIGROINE)
CAS:8032-32-4
RTECS #:OI6180000
Fraction by Wt: 30-35%
OSHA PEL:300 PPM/400 STEL
ACGIH TLV:300 PPM; 9192
Name:ZINC STEARATE
CAS:557-05-1
RTECS #:ZH5200000
Fraction by Wt: 1-5%
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9293
===================== Hazards Identification =====================
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SEVERE EYE IRRITATION, DRYING OF SKIN,
EXCESSIVE INHALATION CAUSES HEADACHE, DIZZINESS AND NAUSEA.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE KNOWN TO MANUFACTURER.
======================= First Aid Measures =======================
First Aid:EYE:WASH WITH FRESH WATER FOR AT LEAST 15 MINUTES. SKIN:WASH
WITH WARM WATER AND SOAP. INHAL:REMOVE TO FRESH AIR. APPLY
ARTIFICIAL RESPIRATION IF NECESSARY. GET MD. INGEST:DO NOT INDUCE
VOMITING. KEEP PERSON WARM & QUIET. GET MD.
===================== Fire Fighting Measures =====================
Flash Point:55.0F,12.8C
Lower Limits:0.9%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL PROT
EQUIPMENT . TREAT AS VOLATILE LIQUID FIRE. WATER SPRAY MAY BE
INEFTIVE. IF WATER SPRAY USED, FOG NOZ ARE PREF.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. ISOLATE FROM HEAT. ISOLATE FROM HEAT,
SPARKS AND FLAME.
================== Accidental Release Measures ==================
Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. CONTAIN SPILL,
ABSORB LIQUID WITH CLAY, SAND OR FLOOR ABSORBENT. PREVENT RUN-OFF
TO SEWERS, STREAMS OR OTHER BODIES OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:KEEP AWAY FROM HEAT, SPARKS AND OPEN
FLAMES. FOR STORAGE CONDITIONS SEE OSHA 1910.106.
Other Precautions:DO NOT TAKE INTERNALLY. AVOID PROLONGED CONTACT WITH
SKIN. CONTAINERS SHOULD BE GROUNDED WHEN POURING. AVOID FREE FALL
OF MORE THAN 2-3 INCHES WHEN POURING. INGRED 3 SUBJECT TO REQ OF
SARA TITLE III, SEC 313.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR IF
TLV LIMITS ARE EXCEEDED. APPROVED MECHANICAL FILTER TO REMOVE SOLID
AIRBORNE PARTICLES OF OVERSPRAY DURING APPLICATION.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:IMPERVIOUS CLOTHING & BOOTS ARE SUGGESTED TO
PREVENT PROLONGED OR REPEATED SKIN CONTACT.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING, OR USING
BATHROOM. DO NOT REUSE CONTAMINATED CLOTHING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
================== Physical/Chemical Properties ==================
HCC:F3
Boiling Pt:B.P. Text:244F,118C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Evaporation Rate & Reference:FASTER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:7.0
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT AND OPEN FIRE.
Hazardous Decomposition Products:CO, CO2 FROM BURNING.
==================== Disposal Considerations ====================
Waste Disposal Methods:CONTAMINATED ABSORBENT MAY BE DEPOSITED IN A
LANDFILL IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|
| ALL PAGES On Chemical Property IN THIS GROUP
| | NAME | CAS |
BEXANE PT B, 4032
| 111-40-0
112-24-3
112-57-2 |
|
CUT-THRU, 1740
| 5989-27-5
107-41-5 |
|
WHITE GELCOAT, GV42000
| 100-42-5
13463-67-7
14807-96-6
112945-52-5
80-62-6
105-45-3 |
|
BIOGUARD BALANCE PAK 200
| 497-19-8 |
|
BIOGUARD SPA PH INCREASER
| 497-19-8 |
|
BIOGUARD SPA PH DECREASER
| 7681-38-1 |
|
BIOGUARD LO'N SLO
| 7681-38-1 |
|
BIOGUARD SPA POLISH
| 57-55-6
102-71-6 |
|
DURA SLIDE LUBRICANT AEROSOL
| 106-97-8
79-01-6
71-55-6 |
|
NAVOSOL 300
| 64742-95-6 |
|
AMMONIUM SULFATE
| 7783-20-2 |
|
VARATHANE PROFESSIONAL CLEAR FINISH, (SUPP
| 8052-41-3
64742-95-6
75-09-2
75-28-5
74-98-6 |
|
VARATHANE PROFESSIONAL CLEAR FINISH, (SUPP
| 75-28-5
74-98-6
8052-41-3
64742-95-6
75-09-2 |
|
VARATHANE PROFESSIONAL CLEAR FINISH, (SUPP
| 8052-41-3
64742-95-6
75-09-2
75-28-5
74-98-6 |
|
VARATHANE PROFESSIONAL CLEAR FINISH,GLOSS,(
| 8052-41-3 |
|
VARATHANE PROFESSIONAL CLEAR FINISH GLOSS,(
| 8052-41-3 |
|
VARATHANE PROFESSIONAL CLEAR FINISH GLOSS,(
| 8052-41-3 |
|
FLEXGEL, 103919387
| 64741-88-4 |
|
NATURAL OIL FINISH SUPER BUILD, SB 66
| 8052-41-3 |
|
LIQUID PLASTIC EXT SUPER BUILD, SB 92
| 8052-41-3
71-36-3
64742-81-0 |
|
SYNKO TUFF PATCH SMOOTH AND TEXTURED, 380
| 85-68-7 |
|
MANCHEM APG
| 125904-15-6
57-55-6
7647-01-0 |
|
WATER-BORNE TRAFFIC PAINT-WHITE
| 1317-65-3
64-17-5
67-56-1
57-55-6
13463-67-7
14464-46-1 |
|
SUM KOOL
| |
|
NATROSOL
| 5989-27-5
26027-38-3 |
|
13600 CUPRIC OXIDE
| 7440-50-8 |
|
LUBRICATING AGENT 2970
| |
|
GV-55313 BURNT SIENNA POLYPASTE
| |
|
DAP WELDWOOD ORIGINAL CONTACT CEMENT
| 71-55-6
64742-89-8
108-88-3 |
|
PK-7535 RED CHEM-O-SOL
| 1309-64-4 |
|
R3580 YELLOW CHEM-O-SOL
| 117-81-7 |
|
RED-Z
| 7778-54-3
9003-04-7 |
|
TRU-TEST SUPREME WOODSMAN SANDING SEALER, 0
| 64742-47-8
8032-32-4
557-05-1 |
|
KWIK KLEEN
| 7647-01-0 |
|
KEROSENE (TAC)
| 8008-20-6 |
|
GLO-COAT, 10110-58-59
| 111-90-0
8002-74-2
7732-18-5 |
|
PIGMENTED OIL WALLBOARD SEALER, TT-S-179B
| 8052-41-3 |
|
SLM-ST SILVERMASTER STABILIZER, 60-18609-00
| |
|
ED-305L
| |
|
PROFORMER
| 1330-20-7
14464-46-1
71-55-6 |
|
TURBO T OIL 100, 65607
| 64742-54-7
64742-70-7
64742-57-0 |
|
GALVAPREP 5
| 13598-37-3
13138-45-9
7697-37-2 |
|
T-64P TONER FOR COPIER BD-7610
| 9003-07-4
1333-86-4
24937-78-8 |
|
ION-420/LC
| |
|
POLYESTER RESIN R88-27 SURFACING RESIN (SUP
| 100-42-5 |
|
EPOXY RESIN
| 25068-38-6 |
|
OROSENE 999 BRIGHTENER
| 14931-83-0
34831-03-0 |
|
ARDROX 6440
| |
|
COPPER OXIDE
| 7440-50-8 |
|
ACRYLIC SEALER 561, ASL 010
| 64741-41-9
1330-20-7 |
|
|