=====================  Product Identification  =====================

MSDS NAME:CARBON DIOXIDE
NIIN:00-935-1669
MSDS Number: BFXLS
=== Responsible Party ===
Company:ANSUL FIRE PROTECTION, WORMALD U.S.INC.
Address:ONE STANTON STREET
City:MARINETTE
State:WI
ZIP:54143-2542
Country:US
Info Phone Num:715-735-7411
Emergency Phone Num:715-735-7411
Chemtrec Ind/Phone:(800)424-9300
CAGE:03670
=== Contractor Identification ===
Company:ANSUL INC
Address:ONE STANTON STREET
Box:City:MARINETTE
State:WI
ZIP:54143-2542
Country:US
Phone:715-735-7411
CAGE:03670
Company:FRC INTL INC
Address:6150 MERGER DR
Box:City:HOLLAND
State:OH
ZIP:43528
Country:US
Phone:419-867-8990
CAGE:0ETK4

=============  Composition/Information on Ingredients  =============

Name:CARBON DIOXIDE
CAS:124-38-9
RTECS #:FF6400000
= Wt:100.
Other REC Limits:NONE SPECIFIED
OSHA PEL:5000 PPM
ACGIH TLV:5000PPM/30000STEL;93

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:ORAL LD50 (RAT) IS UNKNOWN.
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE-EYE/SKIN:MAY CAUSE CHILLING
    SENSATIONS,FROSTBITE/FREEZE BURNS.INHALATION:HEAVIER THAN AIR.CAN
    CAUSE SUFFOCATION.HIGH CONCENTRATIONS CAN CAUSE GIDDINESS,SHORTNESS
    OF BREATH,MUSCULAR TREMORS & WEA KNESS,ACROCYANOSIS.ALSO
    UNCONSCIOUSNESSOR EVEN DEATH.INGESTION IS NOT LIKELY
    (GAS).CHRONIC:NONE KNOWN.
Effects of Overexposure:MAY CAUSE CHILLING SENSATIONS,FROSTBITE/FREEZE
    BURNS IN EYES AND SKIN.INHALATION CAN CAUSE SUFFOCATION.HIGH
    CONCENTRATIONS CAN CAUSE GIDDINESS,DIZZINESS,IMPAIRED
    COORDINATION,HEADACHE,DROWSINESS,SHORT NESS OF BREATH,MUSCULAR
    TREMORS & WEAKNESS.
Medical Cond Aggravated by Exposure:RESPIRATORY PROBLEMS

=======================  First Aid Measures  =======================

First Aid:GET MEDICAL ATTENTION.INHALATION:REMOVE TO FRESH AIR
    QUICKLY.GIVE CPR/OXYGEN IF NEEDED.EYES:IMMEDIATELY FLUSH WITH WATER
    FOR 15 MINUTES.KEEP EYELIDS OPEN.SKIN:WASH WITH SOAP & WATER FOR 15
    MINUTES.ING ESTION:NOT RELEVANT.

=====================  Fire Fighting Measures  =====================

Flash Point:NONE
Extinguishing Media:THIS IS AN EXTINGUISHING AGENT. USE MEDIA
    APPROPRIATE FOR SURROUNDING FIRE.
Fire Fighting Procedures:THIS IS AN EXTINGUISHING AGENT. WEAR
    SELF-CONTAINED BREATHING APPARATUS IF NEEDED.
Unusual Fire/Explosion Hazard:THOUGH GAS CYLINDERS ARE EQUIPPED WITH
    PRESSURE AND TEMPERATURE RELIEF DEVICES,THEY SHOULD BE REMOVED FROM
    HIGH TEMPERATURES OR FIRE TO AVOID RISK OF RUPTURE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:EVACUATE ALL PERSONNEL FROM AREA. USE
    APPROPRIATE PROTECTIVE EQUIPMENT. VENTILATE TO OUTSIDE ATMOSPHERE.
    COOL OR REMOVE HOT, METAL SURFACES OR SOURCES OF NON-EXTINGUISHED
    FLAMES.
Neutralizing Agent:NOT APPLICABLE.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORAGE-STORE IN A COOL,DRY,VENTILATED
    PLACE AWAY FROM HEAT ABOVE 120F.
Other Precautions:STORE AS A COMPRESSED GAS IN DOT APPROVED VESSELS. IF
    CYLINDER OR CARTRIDGE IS NOT ATTACHED TO A SYSTEM, IT MUST BE
    CAPPED. AVOID PROLONGED OR REPEATED BREATHING OF VAPOR. AVOID
    CONTACT WITH EYES OR S KIN. USE WITH ADEQUATE VENTILATION.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NOT NORMALLY NECESSARY. POSITIVE PRESSURE AIR
    LINE WITH FULL FACE PIECE AND ESCAPE AIR SUPPLY OR SELF CONTAINED
    BREATHING APPARATUS SHOULD BE AVAILABLE FOR EMERGENCY USE OR IF TLV
    IS EXCEEDED.
Ventilation:SUFFICIENT TO PREVENT ACCUMULATION ABOVE TLV. LOCAL EXHAUST
    SHOULD BE LOCATED NEAR THE FLOOR.
Protective Gloves:INSULATED AND COLD RESISTANT
Eye Protection:SAFETY GOGGLES WITH OPTIONAL FACE SHIELD
Other Protective Equipment:EYE WASH STATION AND SAFETY SHOWER.
    INDUSTRIAL-TYPE WORK CLOTHING AND APRON AS REQUIRED.
Work Hygienic Practices:OBSERVE GOOD PERSONAL HYGIENE PRACTICES AND
    RECOMMENDED PROCEDURES. WASH THOROUGHLY AFTER  HANDLING.
Supplemental Safety and Health
PART NUMBER: 30660.

==================  Physical/Chemical Properties  ==================

HCC:G3
Boiling Pt:B.P. Text:SUBLIMES
Vapor Pres:42925.7 @ 68F/20C
Vapor Density:1.5
Spec Gravity:1.98
Solubility in Water:88 ML CO2/100 ML
Appearance and Odor:COLORLESS GAS WITH NO ODOR
Percent Volatiles by Volume:100

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
SODIUM PEROXIDE+AL/MG,REACTIVE METALS (ALKALI
    METALS,MG,AL,TITANIUM/ZIRCONIUM),THEIR HYDRIDES,AND DIETHYL
    MAGNESIUM
Stability Condition to Avoid:EXCESSIVE HEAT AND FLAMES. AS USED IN
    ANSUL EXTINGUISHERS,CARTRIDGE/CYLINDERS,CO2 IS A GAS UNDER PRESSURE
    UP TO 860 PSI.
Hazardous Decomposition Products:NONE

====================  Disposal Considerations  ====================

Waste Disposal Methods:CONTAMINATED AREA SHOULD BE VENTILATED
    THOROUGHLY. SOLID CARBON DIOXIDE SHOULD BE REMOVED OUT OF DOORS AND
    ALLOWED TO SUBLIMATE.ALLOW GAS TO BLEED OFF AT A MODERATE
    RATE.DISPOSAL SHOULD BE IN ACCORDAN CE WITH LOCAL, STATE AND
    FEDERAL REGULATIONS.

===================  MSDS Transport Information  ===================

Transport Information:SIZE I, 5 1/4 OZ MINIMUM; SIZE II, 8 1/4 OZ
    MINIMUM PER MIL-C-24224.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***