Material Name: Roofing Accessories Safety Data Sheet
ID: 3201
Section 1 - Product and Company Identification
Hazard Label None Required
Company Information
Johns Manville Telephone: 303-978-2000 8:00AM-5:00PM M-F
Roofing Systems Internet Address: http://www.jm.com
P.O. Box 5108 Emergency: 800-424-9300 (Chemtrec, In English)
Denver, CO 80127 USA
Trade Names:
AlumaWeld RetroDrain; JM TPO & TPO Extra Fastening System;
CD-10 Fasteners & Plates; LWC CR Base Sheet Fasteners;
DynaTred & DynaTred Plus Walkway Pads; NTB Fasteners;
EPDM Splice Tabs, Uncured; PC/PET RetroDrain;
Expand-O-Flash庐 Expansion Joint Covers; Polymer Auger Fasteners;
Expand-O-Flex庐 Flexible Closure; Pre-Cut Cricket;
Expand-O-Gard庐 Expansion Joints & Transitions; Pre-Cut Miter;
Extra High Load Fasteners and Plates; Presto Lock庐 Fascia & Coping Systems;
Flex-I-Drain庐; Presto Stop鈩? Systems;
Foil Tape; Presto-Tite鈩? Fascia System;
FP-10 One Way庐 Vents; PVC Fasteners (Pitch Pocket, Termination Bars);
Hercules RetroDrain; RetroDrain庐;
High Load ASAP Fasteners; Single Ply All Purpose Fasteners;
High Load Fasteners and Plates; SPM庐 Fasteners, Bars, Disks, & Plates;
Intersections & Transition Details; Structural Concrete Deck Fasteners;
JM EPDM Corners (inside & outside); SuperDome RetroDrain;
JM EPDM Membrane Battens; UIA Application Cart;
JM EPDM Metal/Membrane Flashing; UltraFast庐: Fasteners & Plates, ASAP Fasteners, Pre-
JM EPDM Penetration Pan; Assembled Fasteners;
JM EPDM Termination Systems; UltraLok鈩?;
JM Polyester Mat Protection Slipsheet; USII RetroDrain
Section 2 - Hazards Identification
Emergency Overview
Under normal conditions of use and handling, this product is not expected to create any health or safety hazards.
Inhalation
Not expected under normal conditions of use.
Skin
Not expected under normal conditions of use.
Ingestion
Not expected under normal conditions of use.
Eyes
Not expected under normal conditions of use.
Section 3 - Composition/Information on Ingredients
General Product Description
Various shapes, designs and colors with metal and rubber parts.
Section 4 - First Aid Measures
First Aid: Inhalation
None required
First Aid: Skin
None required
First Aid: Ingestion
None required
First Aid: Eyes
None required
____________________________________________________________
Page 1 of 4 Issue Date: 07/30/2008 Revision: 1.0011
Material Name: Roofing Accessories Safety Data Sheet
ID: 3201
Section 5 - Fire Fighting Measures
Flash Point: Not applicable Method Used: Not applicable
Upper Flammable Limit (UFL): Not applicable Lower Flammable Limit (LFL): Not applicable
Auto Ignition: Not determined Flammability Classification: Not determined
Rate of Burning: Not determined
General Fire Hazards
There is no potential for spontaneous fire or explosion.
Extinguishing Media
Carbon dioxide (CO2), water, water fog, dry chemical.
Fire Fighting Equipment/Instructions
No special procedures are expected to be necessary for this product. Normal fire fighting procedures should be followed to
avoid inhalation of smoke and gases.
Section 6 - Accidental Release Measures
Clean-Up Procedures
Pick up large pieces. Vacuum dusts.
Section 7 - Handling and Storage
Handling Procedures
Use protective equipment as described in Section 8 of this safety data sheet when handling uncontained material. Handle in
accordance with good industrial hygiene and safety practices.
Storage Procedures
Warehouse storage should be in accordance with package directions, if any. Material should be kept clean, dry, and in original
packaging.
Section 8 - Exposure Controls / Personal Protection
A: Component Exposure Limits
This material has no components listed.
PERSONAL PROTECTIVE EQUIPMENT
Personal Protective Equipment: Eyes/Face
None required
Personal Protective Equipment: Skin
None required
Personal Protective Equipment: Respiratory
None required
Ventilation
None required
Section 9 - Physical & Chemical Properties
Appearance: Odor:
Various shapes, designs and colors No significant odor
with metal and rubber parts
Physical State: pH:
Solid Not determined
Vapor Pressure: Vapor Density:
Not applicable Not applicable
Boiling Point: Melting Point:
Not determined Not applicable
Solubility (H2O): Specific Gravity:
Nil Variable
Freezing Point: Evaporation Rate:
Not applicable Not applicable
Viscosity: Percent Volatile:
Not applicable 0
VOC: Not applicable
Section 10 - Stability & Reactivity Information
Stability
These products are not reactive.
Hazardous Polymerization
Will not occur.
____________________________________________________________
Page 2 of 4 Issue Date: 07/30/2008 Revision: 1.0011
Material Name: Roofing Accessories Safety Data Sheet
ID: 3201
Section 11 - Toxicological Information
Component Analysis - LD50/LC50
This material has no components listed.
Component Carcinogenicity
This material has no components listed.
Section 12 - Ecological Information
Ecotoxicity
A: General Product Information
Not expected to be dangerous to the environment.
B: Component Analysis - Ecotoxicity - Aquatic Toxicity
This material has no components listed.
Section 13 - Disposal Considerations
US EPA Waste Number & Descriptions
A: General Product Information
This product is not expected to be a hazardous waste when it is disposed of according to the U.S. Environmental Protection
Agency (EPA) under Resource Conservation and Recovery Act (RCRA) regulations. Product characterization after use is
recommended to ensure proper disposal under federal and/or state requirements.
B: Component Waste Numbers
This material has no components listed.
Disposal Instructions
Dispose of waste material according to Local, State, Federal, and Provincial Environmental Regulations.
Section 14 - Transport Information
International Transport Regulations
These products are not classified as dangerous goods according to international transport regulations.
Section 15 - Regulatory Information
US Federal Regulations
A: General Product Information
SARA 311/312: This product is not classified as hazardous under SARA 311/312.
B: Component Analysis
This material has no components listed.
State Regulations
A: General Product Information
Other state regulations may apply. Check individual state requirements.
B: Component Analysis - State
This material has no components listed.
A: TSCA Status
This material has no components listed.
International Regulations
A: General Product Information
These products are considered articles under both U.S. and international product regulations and as such, these products do
not require registration or notification on the various country-specific inventories.
B: Component Analysis - WHMIS IDL
This material has no components listed.
WHMIS Classification
This is not a WHMIS controlled product. This product has been classified in accordance with the hazard criteria of the
Controlled Products Regulations. This SDS contains all the information required by the Controlled Products Regulations.
Section 16 - Other Information
Other Information
Prepared for:
Johns Manville
Roofing Systems
____________________________________________________________
Page 3 of 4 Issue Date: 07/30/2008 Revision: 1.0011
Material Name: Roofing Accessories Safety Data Sheet
ID: 3201
P. O. Box 5108
Denver, CO USA 80217-5108
Prepared by:
Johns Manville Technical Center
P.O. Box 625005
Littleton, CO USA 80162-5005
The information herein is presented in good faith and believed to be accurate as of the effective date given. However, no
warranty, expressed or implied, is given. It is the buyer's responsibility to ensure that its activities comply with Federal, State or
provincial, and local laws.
Date MSDS # Reason
08/01/00 3201-1.0000 New MSDS authoring system.
10/26/00 3201-1.0001 Sect. 1, Trade Names: added 'EPDM Strips, Peel and Stick'
02/27/02 3201-1.0002 Sect. 1 Trade Names, added UIA Application Cart.
05/06/03 3201-1.0003 Sect. 1, added trade names: UG EPDM Penetration Pan, UG
EPDM corners inside/outside.
01/14/04 3201-1.0004 Minor edits.
03/17/04 3201-1.0005 Sect. 1, Trade Names: added UltraLok鈩?
09/14/05 3201-1.0006 Addition of UltraGard TPO & TPO Extra Fastening System to trade
names.
12/30/05 3201-1.0007, Section 14 Transportation addition of DOT, IATA, and IMDG info for
1.0008 EPDM Splice Kit containing JM SA Primer and Urethane Sealant
only.
07/10/06 3201-1.0009 'UltraGard' replaced by 'JM' for EPDM products. Addition of Extra
High Load Fasteners and Plates, Hercules RetroDrain, PC/PET
RetroDrain, Polymer Auger Fasteners, Pre-Cut Cricket, Pre-Cut
Miter, Structural Concrete Deck Fasteners, SuperDome RetroDrain,
& USII RetroDrain. Moved EPDM Strips, Peel and Stick to MSDS
3010.
03/14/2007 3201-1.0010 Addition of Single Ply All Purpose Fasteners to trade names.
07/30/08 3201-1.0011 Addition of AlumaWeld Drain to trade names. Updated SDS to GHS
format.
End of Sheet 3201
____________________________________________________________
Page 4 of 4 Issue Date: 07/30/2008 Revision: 1.0011
|