MATERIAL SAFETY DATA SHEET
FLOOR VARNISH Page: 1
DATE PRINTED: 08/07/2006
================================================================================
REVISION DATE: 08/07/06
PRODUCT NAME: FLOOR VARNISH
PRODUCT CODE: 06-960-XX
HMIS: HEALTH: 2* , FIRE: 2 , REACTIVITY: 1 , PERSONAL PROTECTION:
4 = EXTREME, 3 = HIGH, 2 = MODERATE, 1 = SLIGHT, 0 = INSIGNIFICANT, * = CHRONIC
================== SECTION I - MANUFACTURER IDENTIFICATION =================
MANUFACTURER'S NAME: Columbia Paint & Coatings
ADDRESS : N112 Haven, P.O. Box 4569
Spokane, WA 99202-4569
24 HOUR EMERGENCY PHONE NO: 800-424-9300 NAME OF PREPARER : GEO. STAVNES
INFORMATION PHONE NO : 509-535-6311
========== SECTION II - HAZARDOUS INGREDIENTS/SARA III INFORMATION =========
REPORTABLE EXPOSURE WEIGHT VAPOR PRESSURE
COMPONENTS LIMITS (TLV, PEL) CAS NUMBER PERCENT mm Hg @ TEMP (F)
--------------------------------------------------------------------------------------
---------------------------------------
Petroleum Distillate 8052-41-3 46.71 2 68
ACGIH: 100 ppm (525 mg/m3) TWA
OSHA: 100 ppm (400 mg/m3) TWA
* Cobalt 2-ethylhexanoate 136-52-7 0.16 NA NA
OSHA: as Co: 0.1 mg/m3 TWA
* Indicates toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Emergency and Community Right-to-Know Act of 1986 and of
40 CFR 372.
This product contains hazardous components which may become airborne and result
in exposure when removed by abrasive blasting, sanding, or grinding. Ventilate
and avoid breathing dust.
=============== SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS ============
BOILING RANGE (F): 300
SPECIFIC GRAVITY (H2O=1): 0.91 POUNDS PER GALLON: 7.60 lb/gl
% VOLATILE BY WT: 48.04% % VOLATILE BY VOL: 55.37%
VAPOR DENSITY: Heavier than air.
EVAPORATION RATE: Slower than n-butyl acetate.
V.O.C.(lb/gal): 3.65 lb/gl V.O.C.(g/l): 438 g/l
SOLUBILITY IN WATER: NA
APPEARANCE: Clear liquid. ODOR: Solvent odor.
================= SECTION IV - FIRE AND EXPLOSION HAZARD DATA ==============
FLAMMABILITY CLASS: DOT combustible liquid (100 F<= flash point <141 F) for
ground transportation. Flammable liquid for air/water transportation.
OSHA Class II (100 F<= flash point <140 F).
FLASH POINT (F): 106.0 METHOD USED : TCC
FLAMMABLE LIMITS IN AIR BY VOLUME- LOWER: 2.1 UPPER: 14.4
EXTINGUISHING MEDIA: Foam. CO2. Dry chemical.
MATERIAL SAFETY DATA SHEET
FLOOR VARNISH Page: 2
DATE PRINTED: 08/07/2006
================================================================================
SPECIAL FIREFIGHTING PROCEDURES
Evacuate hazard area of unprotected personnel.
Water spray may be ineffective. However, water may be used to cool closed
containers to prevent pressure buildup. Full protective equipment is
recommended including self contained breathing apparatus, to protect
firefighters from hazardous combustion products.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Isolate from heat, sparks, electrical equipment, and open flame. Vapors will
form explosive concentrations with air. Vapors travel long distances and may
flashback. Use mechanical ventilation when necessary to keep percent vapor
below the "Lower Explosion Level" (LEL). In closed containers, pressure buildup
may occur due to heat exposure. During emergency conditions, overexposure to
decomposition products may cause a health hazard. Symptoms may not be
immediately apparent. Obtain medical attention.
Vapors are heavier than air and will accumulate.
======================== SECTION V - REACTIVITY DATA =======================
STABILITY: Stable.
CONDITIONS TO AVOID
High temperatures or direct heating.
INCOMPATIBILITY (MATERIALS TO AVOID)
Oxygen and strong oxidants. Strong acids. Strong bases. Amines.
Will dissolve or soften some plastics and rubber.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS
Fumes produced when heated to decomposition, such as in welding, may include one
or more of the following: Carbon dioxide. Carbon monoxide. Oxides of nitrogen.
Acrolein.
HAZARDOUS POLYMERIZATION: Will not occur.
==================== SECTION VI - HEALTH HAZARD DATA =======================
PRIMARY ROUTES OF EXPOSURE: Dermal: X Inhalation: X Ingestion:
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Overexposure via inhalation may cause central nervous system depression with
symptoms ranging from headaches, dizziness, loss of coordination, to
unconsciousness.
Deliberately breathing concentrated solvent vapor (glue sniffing) may result in
permanent brain and nervous system damage or death.
May cause respiratory irritation.
Repeated overexposure to solvent vapors may result in damage to one or more of
the following: central nervous system, blood, liver, kidney, and/or hearing.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Prolonged or repeated skin contact may dry and defat the skin leading to
irritation and/or dermatitis.
Eye contact may cause severe irritation, redness, tearing, and/or blurred
vision.
No chronic skin effects known at this time.
MATERIAL SAFETY DATA SHEET
FLOOR VARNISH Page: 3
DATE PRINTED: 08/07/2006
================================================================================
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
No acute effects known at this time.
No chronic effects known at this time.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Harmful or fatal if swallowed.
Ingestion may result in gastrointestinal irritation, nausea, vomiting, and/or
diarrhea.
No chronic effects known at this time.
OTHER HEALTH HAZARDS (ACUTE AND CHRONIC)
No other acute effects known at this time.
No other chronic effects known at this time.
CARCINOGENICITY: CONTAINS CARCINOGENS: Yes OSHA REGULATED: Yes
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Pre-existing disorders, chronic respiratory diseases.
EMERGENCY AND FIRST AID PROCEDURES
If overcome by vapor, remove from exposure immediately; call a physician. If
breathing is irregular or stopped, start resuscitation; administer oxygen.
If ingested, do NOT induce vomiting; call a physician.
If splashed into the eyes, flush eyes with clear water for 15 minutes or until
irritation subsides; consult a physician as required.
In case of skin contact, remove any contaminated clothing and wash skin with
soap and warm water.
================== SECTION VII - SPILL OR LEAK PROCEDURES ===================
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Remove all sources of ignition (flame, hot surfaces, and electrical, static or
frictional sparks), ventilate area, contain and remove with inert absorbent and
non-sparking tools. Refer to other hazard cautions contained on this sheet
before attempting clean-up.
WASTE DISPOSAL METHOD
DANGER-Rags, towels, steel wool, or material waste (including overspray dustand
spray booth filters) contaminated with this product may spontaneously catch fire
if improperly discarded. Immediately after use, place rags, towels, steel wool,
or material waste in a sealed water-filled metal container.
Do not incinerate closed containers.
Dispose in accordance with local, state, and federal regulations.
============== SECTION VIII - SAFE HANDLING AND USE INFORMATION ==============
RESPIRATORY PROTECTION
Do not breathe vapors or mists. Wear a properly fitted vapor/particulate
respirator approved by NIOSH/MSHA during application until all vapors and spray
mists are exhausted. Do not permit anyone without protection in the painting
area.
In confined areas, use NIOSH/MSHA approved positive-pressure, air supplied
respirator or use hoods.
MATERIAL SAFETY DATA SHEET
FLOOR VARNISH Page: 4
DATE PRINTED: 08/07/2006
================================================================================
Use ventilation to keep levels below exposure guidelines (see Section II.) User
should test and monitor exposure levels to insure all personnel exposure is
below guidelines. If not sure or if not able to monitor levels, use a
NIOSH/MSHA approved air purifying respirator.
VENTILATION
Pockets of heavy and/or flammable vapor must not be permitted to form.
Ventilation and respiratory protection must be adequate to prevent the TLV's of
hazardous ingredients from being exceeded.
All application areas should be ventilated in accordance with OSHA regulations.
PROTECTIVE GLOVES
Chemical resistant nitrile, neoprene or rubber gloves required.
EYE PROTECTION
Use safety eyewear with splash guards or side shields.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Use protective apron and clothing.
WORK/HYGIENIC PRACTICES
Wash hands before eating or using washroom. Smoke in smoking areas only. Wash
clothes before reuse.
===================== SECTION IX - SPECIAL PRECAUTIONS ======================
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Do not store or use near heat, sparks, or flame. No smoking or open lights.
Use with adequate ventilation.
OTHER PRECAUTIONS
Store in sealed containers away from space heating equipment.
Avoid contact with eyes. Avoid prolonged or repeated contact with skin. Avoid
prolonged or repeated breathing of vapors.
WARNING! If you scrape, sand, remove old paint, you may release lead dust. LEAD
IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully
with a HEPA vacuum and a wet mop. Before you start, find out how to protect
yourself and your family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
========================= SECTION X - DISCLAIMER ==========================
Although the information and recommendations set forth herein (hereinafter
"information") are presented in good faith and believed to be correct as of the
date of this material data sheet, Columbia Paint & Coatings makes no
representations as to the completeness and accuracy thereof. Information is
supplied upon the condition that persons receiving same will make their own
determination as to its suitability for their purposes prior to use. In no
event will Columbia Paint & Coatings be responsible for damages of any nature
whatsoever resulting from the use of, misuse or reliance upon information. No
representations, guarantees, or warranties (either expressed or implied),
merchantability, fitness for a particular purpose, or any other nature are made
hereunder with respect to information or the material to which information
refers. Regulatory requirements are subject to change and may differ from one
location to another. It is the user's sole responsibility to ensure its
activities comply with federal, state or provincial, and local laws and
MATERIAL SAFETY DATA SHEET
FLOOR VARNISH Page: 5
DATE PRINTED: 08/07/2006
================================================================================
regulations. This information must be included with all MSDS's that are copied
and distributed for this material.
|