MATERIAL SAFETY DATA SHEET
May be used to comply with OSHA鈥檚 Hazard Communication
HMIS HAZARD RATING
Standard 29 CFR 1910.1200. Standard must be consulted for
specific requirements.
HEALTH 2 0 = INSIGNIFICANT 3 = HIGH
FLAMMABILITY 1 1 = SLIGHT 4 = EXTREME
REACTIVITY 0 2 = MODERATE
SAFETEC OF AMERICA TRANSPORTATION INFORMATION
PROPER SHIPPING NAME Not Regulated
HAZARD CLASS / PKG. GRP. None / None REF. Not Applicable
IDENTIFICATION NUMBER None LABEL None Required
SECTION 1 - PRODUCT / COMPANY IDENTIFICATION
IDENTITY (AS USED ON LABEL AND LIST) Page 1 of 2
TM
Safetec Burn Gel
MANUFACTURER鈥橲 NAME EMERGENCY TELEPHONE NUMBER (24 Hours)
Safetec of America, Inc. (800) 255-3924
ADDRESS (NUMBER, STREET, P.O. BOX) TELEPHONE NUMBER FOR INFORMATION
1055 East Delavan Avenue (716) 895-1822
(CITY, STATE AND ZIP CODE) DATE PREPARED June 04, 2001
SUPERSEDES March 02, 2001
Buffalo, NY 14215
SECTION 2 - HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
CAS # % (wt.) OSHA PEL/STEL ACGIH TLV/TWA/STEL
HAZARDOUS COMPONENTS
MG/M3 MG/M3
(SPECIFIC CHEMICAL IDENTITY; COMMON NAME(S)) (OPTIONAL) PPM PPM
Lidocaine HCl 6108-05-0 2 None Established None Established
Menthol 2216-51-5 None Established None Established
This product is not known to contain a substance subject to Section 313 of Title III of the Superfund Amendments
and Reauthorization Act of 1986 (SARA) and 40 CFR 372 at or above minimal amounts.
SECTION 3 - HEALTH HAZARD DATA
ROUTES OF ENTRY - SIGNS AND SYMPTOMS OF EXPOSURE EMERGENCY AND FIRST AID PROCEDURES
EYES: Brief contact may cause mild irritation; prolonged Flush eyes with clear running water for a minimum of 15
contact may cause moderate irritation associated with minutes while holding eyelids open; if irritation persists, seek
redness. medical attention.
SKIN: Prolonged or repeated skin contact may cause mild Flush with clear running water for a minimum of 15 minutes;
irritation. if irritation persists, seek medical attention.
INGESTION: Small amounts swallowed incidental to normal DO NOT induce vomiting; seek immediate medical attention.
handling are not likely to cause injury. Swallowing larger
amounts may cause injury.
HEALTH HAZARDS (ACUTE AND CHRONIC): Acute effects are possible irritation and discomfort; chronic effects are
possible with the ingestion of large amounts to the nervous system. Do not use on abraded skin.
NTP? No IARC MONOGRAPHS? No OSHA REGULATED? No
CARCINOGENICITY
No additional information
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Preexisting skin or eye disorders may become
aggravated through prolonged exposure.
Form Revised 1/99
MATERIAL SAFETY DATA SHEET
IDENTITY (AS USED ON LABEL AND LIST) Page 2 of 2
Safetec Burn Gel TM Date: June 04, 2001
SECTION 4 - FIRE FIGHTING MEASURES
FLASH POINT (TOC) FLAMMABLE LIMITS (% Volume in Air for Lowest Flashing Component)
84.2掳C LEL: Not Applicable UEL: Not Applicable
EXTINGUISHING MEDIA
Water, water spray, dry chemicals, chemical foam, CO2
SPECIAL FIRE FIGHTING PROCEDURES
DO NOT enter confine fire space without full bunker gear (Helmet with face shield, bunker coats, gloves and rubber boots. Wear
NIOSH/MSHA approved self contained breathing apparatus. Cool fire exposed containers with water.
UNUSUAL FIRE AND EXPLOSIVE HAZARDS
None known
SECTION 5 - PRECAUTIONS FOR SAFE HANDLING AND USE / LEAK PROCEDURES
STEPS TO BE TAKEN IF MATERIAL IS SPILLED OR RELEASED
Small spills may be flushed with large amounts of water; larger spills should be collected with approved absorbent for disposal.
WASTE DISPOSAL METHODS
Dispose of in accordance with Local, State, and Federal regulations. Products classified as non-hazardous may become hazardous
waste upon contact with other products. Refer to "40 CFR Protection of Environment Parts 260-299" for complete waste disposal
regulations. Consult your Local, State, or Federal Environmental Protection Agency before disposing of any chemicals.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Keep container(s) tightly closed when not in use. Store in cool, dry area. Keep this and other chemicals out of reach of children.
SECTION 6 - EXPOSURE CONTROLS / PERSONAL PROTECTION
RESPIRATORY PROTECTION VENTILATION LOCAL EXHAUST: None Required
Ordinarily, none required MECHANICAL (GENERAL): No
PROTECTIVE GLOVES EYE PROTECTION
Ordinarily, none required Ordinarily, none required
OTHER PROTECTIVE CLOTHING OR EQUIPMENT WORK / HYGIENIC PRACTICES
Ordinarily, none required Practice safe work habits. Use according to label instructions.
SECTION 7 - PHYSICAL / CHEMICAL PROPERTIES
BOILING POINT SPECIFIC GRAVITY (WATER=1)
0.997
Approximately 212掳F
VAPOR PRESSURE (mm Hg) MELTING POINT
Not Determined Not applicable
VAPOR DENSITY (AIR=1) pH
Not Determined Approximately 6.5
SOLUBILITY IN WATER EVAPORATION RATE (n-BUTYL ACETATE=1)
Complete Not Determined
APPEARANCE AND ODOR % VOLATILES (BY WEIGHT)
Opaque-white, viscous gel. Not Determined
SECTION 8 - STABILITY AND REACTIVITY
STABILITY CONDITIONS TO AVOID
UNSTABLE:
STABLE: XXX Extreme temperatures
INCOMPATIBILITIES (MATERIALS TO AVOID)
Strong oxidizing agents
HAZARDOUS DECOMPOSITION OR BYPRODUCTS
Decomposition will not occur if handled / stored properly. Thermal decomposition may produce carbon monoxide, small amounts of
nitrogen oxides, halogenated compounds or propionaldehyde may also be formed.
HAZARDOUS POLYMERIZATION CONDITIONS TO AVOID
MAY OCCUR:
WILL NOT OCCUR: XXX None known
The information contained herein is believed to be accurate but is not warranted to be so. Users are advised to confirm in advance of need that information
is current, applicable and suited to the circumstances of use. Vendor assumes no responsibility for injury to vendee or third persons proximately caused by
the material if reasonable safety procedures are not adhered to as stipulated in the data sheet. Furthermore, vendor assumes no responsibility for injury
caused by abnormal use of this material even if reasonable safety procedures are followed.
MSDS PREPARED BY: Safetec of America, Inc., 1055 East Delavan Avenue, Buffalo, NY 14215 (716) 895-1822
Form Revised 1/99
|