Material Safety Data Sheet
E3-G - 2 CU FT UNIT PART A
Version 1.3 Print Date 07/12/2007
REVISION DATE: 08/27/2006
SECTION 1 - PRODUCT IDENTIFICATION / PREPARATION INFORMATION
Product Information
Trade name : E3-G - 2 CU FT UNIT PART A
Product code : 040G 2A
Supplier : Euclid Canada
2835 Grande-All茅e
St-Hubert, QC J4T 2R4
Telephone : 1-800-667-0920
Emergency Phone: : (613) 996-6666
Preparation Information
Prepared by: : Sewnauth Raghunandan
Date: : 08/27/2006
Telephone : (416) 421-3300
SECTION 2 - HAZARDS IDENTIFICATION
Emergency Overview
Clear. Liquid. May cause slight irritation to the respiratory system. Leave area to breathe fresh air. Avoid
further overexposure. If symptoms persist, get medical attention.
Acute Potential Health Effects/ Routes of Entry
Inhalation May cause slight irritation to the respiratory system.
:
Eyes Slightly irritating.
:
Ingestion May cause gastrointestinal irritation, nausea, and vomiting.
:
Skin May cause sensitization.
:
Aggravated Medical Conditions
Pre-existing eye, skin and respiratory disorders may be aggravated by exposure.
Chronic Health Effects
May cause sensitization by contact. Prolonged or repeated exposure to epoxy resin can cause irritation to skin,
eyes, skin sensitization, temporary eye injury. Certain epoxy resins are reported to be mutagenic in some
laboratory tests. Fillers are encapsulated and not expected to be released from product under normal conditions
of use.
Target Organs: Skin, Eye, Ingestion
SECTION 3 : HAZARDOUS INGREDIENTS
Chemical Name CAS-No. Weight % Range
Bisphenol A Polyglycidyl Ether Resin 25068-38-6 > 60.0
The ingredients listed above are hazardous as defined in the controlled products regulation. (CPR).
1/5 040G 2A
Material Safety Data Sheet
E3-G - 2 CU FT UNIT PART A
Version 1.3 Print Date 07/12/2007
REVISION DATE: 08/27/2006
SECTION 4 - FIRST AID MEASURES
Get immediate medical attention for any significant overexposure.
Inhalation : Leave area to breathe fresh air. Avoid further overexposure. If symptoms persist, get
medical attention.
Eye contact : Flush with water for 15 minutes. If irritation persists, get medical attention.
Skin contact : Wash with water. If irritation, rash or other disorders develop, get medical attention
immediately.
Ingestion : Do not induce vomiting unless advised by a physician. Call nearest Poison Control
Center or Physician immediately.
SECTION 5: FIRE / EXPLOSION HAZARDS
Flash point : > 200 掳 > 93 掳
F, C
Method : Setaflash Closed Cup
Lower explosion limit : Not available.
Upper explosion limit : Not available.
Autoignition temperature : Not available.
Extinguishing media : This product is not expected to burn under normal conditions of use.
Hazardous combustion : Smoke, fumes.
products
Protective equipment for : Use accepted fire fighting techniques. Wear full firefighting protective
firefighters clothing, including self-contained breathing apparatus (SCBA).
Fire and explosion conditions : This product not expected to ignite under normal conditions of use.
SECTION 6 - SPILLS / LEAKS / ACCIDENTAL RELEASE MEASURES
Stop flow. Contain spill. Keep out of water courses. Absorb spill in sand, earth or other suitable material.
Transfer to appropriate container for disposal.
SECTION 7 - HANDLING AND STORAGE
Prevent inhalation of vapor, ingestion, and contact with skin eyes and clothing. Keep container closed when
not in use. Precautions also apply to emptied containers. Store in sealed containers in a dry, ventilated
warehouse location above freezing.
SECTION 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION
Personal protection equipment
Respiratory protection : Not required under normal conditions of use.
Hand protection : Use suitable impervious rubber or vinyl gloves and protective apparel to
2/5 040G 2A
Material Safety Data Sheet
E3-G - 2 CU FT UNIT PART A
Version 1.3 Print Date 07/12/2007
REVISION DATE: 08/27/2006
reduce exposure.
Eye protection : Wear appropriate eye protection.
Skin and body protection : Not required.
Protective measures : Use professional judgment in the selection, care, and use.Other equipment
not normally required.
Engineering measures : General ventilation is sufficient.
Exposure Limits
No known components with exposure limits.
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
Physical State : Liquid
Form : Liquid
Color : Clear
Odor : Epoxy
pH : Not available.
Vapour pressure : Not available.
Vapor density : Heavier than air
Melting point/range : Not available.
Freezing point : Not available.
Boiling point/range : > 500 掳 > 260 掳
F, C
Water solubility : Insoluble
Evaporation Rate: : Not available.
Specific Gravity : 1.0817
% Volatile Weight : 0%
SECTION 10 - REACTIVITY / STABILITY
Substances to avoid : Acids and bases.Amines.Epoxy curing agents.
SECTION 11 - TOXICOLOGICAL INFORMATION
No Data Available
3/5 040G 2A
Material Safety Data Sheet
E3-G - 2 CU FT UNIT PART A
Version 1.3 Print Date 07/12/2007
REVISION DATE: 08/27/2006
SECTION 12 - ECOLOGICAL INFORMATION
No Data Available
SECTION 13 - WASTE DISPOSAL CONSIDERATIONS
Disposal Method : Dispose as hazardous waste according to all local, state, federal and provincial
regulations.
SECTION 14 - TRANSPORTATION / SHIPPING DATA
TDG / DOT Shipping Description:
NOT REGULATED
SECTION 15 - REGULATORY INFORMATION
North American Inventories:
All components are listed or exempt from the TSCA inventory.
This product or its components are listed on, or exempt from the Canadian Domestic Substances List.
Canadian Regulations:
WHMIS Classification : D2B
This is a "controlled product" under the Canadian Workplace Hazardous Materials Information System
(WHMIS).
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations
(CPR) and the MSDS contains all of the information required by the CPR.
Other Regulations:
Regulatory VOC (less water and : 0 g/l
exempt solvent)
SECTION 16 - OTHER INFORMATION
HMIS Rating :
Health 1 0 = Minimum
1 = Slight
Flammability 1
2 = Moderate
Reactivity 0
3 = Serious
PPE
4 = Severe
Further information:
For Industrial Use Only. Keep out of Reach of Children. The hazard information herein is offered solely for the
consideration of the user, subject to their own investigation of compliance with applicable regulations, including
the safe use of the product under every foreseeable condition.
4/5 040G 2A
Material Safety Data Sheet
E3-G - 2 CU FT UNIT PART A
Version 1.3 Print Date 07/12/2007
REVISION DATE: 08/27/2006
Prepared by: Sewnauth Raghunandan
Legend
ACGIH - American Conference of Governmental Hygienists OSHA - Occupational Safety and Health Administration
DOT - Department of Transportation PEL - Permissible Exposure Limit
DSL - Domestic Substance List RCRA - Resource Conservation and Recovery Act
EPA - Environmental Protection Agency STEL - Short Term Exposure Limit
HMIS - Hazardous Materials Information System TLV - Threshold Limit Value
IARC - International Agency for Research on Cancer TSCA - Toxic Substances Control Act
MSHA - Mine Safety Health Administration TWA - Time Weighted Average
NDSL - Non-Domestic Substance List V - Volume
NIOSH - National Institute for Occupational Safety and Health VOC - Volatile Organic Compound
NTP - National Toxicology Program WHMIS - Workplace Hazardous Materials Information System
5/5 040G 2A
|