MATERIAL SAFETY DATA SHEET
PRODUCT NAME: MAXIM ADVANCED
CP04
NFPA/HMIS: Health 1
Flammability 0
Reactivity 0
MATERIAL SAFETY DATA SHEET U.S. DEPARTMENT OF LABOR
COMPLIES WITH USDL SAFETY AND HEALTH REGULATIONS 29CFR1910.1200
________________________________________________________________________
SECTION 1 COMPANY AND PRODUCT IDENTIFICATION
PRODUCT NAME: Maxim Advanced
MANUFACTURER:
Bridgepoint Systems
542 W. Confluence Avenue
Salt Lake City, UT 84123
Telephone: 801-261-1282
June 26, 2007
EMERGENCIES: (800) 535-5053 (Infotrac)
__________________________________________________________________
SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS
Components
Material CAS Number %
Water 7732-18-5 94-98.5
Acrylic Copolymer .5-2.25
Partially Fluorinated Urethane Polymer 0.25-1.5
Phenolic Resin Condensate .5-1.5
SECTION 3 HAZARDS IDENTIFICATION
Potential Health Effects
Skin contact may cause mild skin irritation with discomfort or rash.
Eye contact may cause eye irritation with discomfort, tearing or blurring of vision.
Inhalation may cause irritation of the nose and throat with sneezing, sore throat, or runny nose.
Inhalation of respirable particles may cause lung irritation effects with cough, discomfort, difficulty
breathing, and shortness of breath; or pulmonary edema (body fluid in the lungs. Symptoms may
be modest initially, followed in hours by severe shortness of breath requiring prompt medical
attention.
Carcinogenicity Information
None of the components present in this material at concentrations equal to or greater than 0.1% are listed by IARC,
NTP, OSHA or ACGIH as a carcinogen.
SECTION 4 FIRST AID MEASURES
First Aid
INHALATION
If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is
difficult, give oxygen. Call a physician.
SKIN CONTACT
Flush skin with water after contact. Wash contaminated clothing before reuse.
EYE CONTACT
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Call a
physician.
INGESTION
If swallowed, do not induce vomiting. Immediately give 2 glasses of water. Never give
anything by mouth to an unconscious person. Call a physician.
Notes to Physicians
Activated charcoal mixture may be administered. To prepare
activated charcoal mixture, suspend 50 grams activated charcoal in 400 mL water and mix
thoroughly. Administer 5 mL/kg, or 350 mL for an average adult.
SECTION 5 FIRE FIGHTING MEASURES
Flammable Properties
Hazardous decomposition products including carbon dioxide, carbon monoxide, hydrogen
fluoride, toxic gases or particles may be formed during combustion. These products may cause
severe eye, nose, and throat irritation or toxic effects.
Extinguishing Media
Use media appropriate for surrounding material.
Fire Fighting Instructions
Keep personnel removed and upwind of fire. Wear self-contained breathing
apparatus. Wear full protective equipment.
SECTION 6 ACCIDENTAL RELEASE MEASURES
NOTE: Review FIRE FIGHTING MEASURES and HANDLING (PERSONNEL) sections before
proceeding with clean-up. Use appropriate PERSONAL PROTECTIVE EQUIPMENT
during clean-up.
Accidental Release Measures
Prevent liquid from entering storm sewers, waterways or low areas. Soak up with sawdust,
sand, oil dry or other absorbent material. Shovel or sweep up. Place in container for disposal.
SECTION 7 HANDLING AND STORAGE
Handling (Personnel)
Avoid contact with eyes, skin, or clothing. Wash thoroughly after handling.
Handling (Physical Aspects)
Avoid circumstances that produce respirable particles unless suitable ventilation and respirator
are used.
Storage
Keep container tightly closed. Keep from freezing.
SECTION 8 EXPOSURE CONTROLS/
Engineering Controls
Use only with adequate ventilation.
Vent dryer fumes outside work area. Do not aerosolize. In spray applications, use airless
type pressure spray equipment at less than 60 psi and exhaust ducts, drip pans, or other design
features to minimize worker exposure to mists and overspray.
Personal Protective Equipment
EYE/FACE
Wear coverall chemical splash goggles.
RESPIRATORS
Wear NIOSH approved respiratory protection, as appropriate. PROTECTIVE CLOTHING
Where there is potential for skin contact have available and wear as appropriate impervious gloves, apron, pants,
and jacket.
Exposure Limits
Maxim Advanced
PEL (OSHA) : None Established
TLV (ACGIH) : None Established
Exposure Guideline Comments
No AEL has been established for this product. Other products with fluorinated material
components have an AEL of 0.1 mg/m3 to 1 mg/m3 (8 hour TWA) for respirable size
aerosol particles.
Air monitoring studies conducted at customer sites indicates that the use of the
recommended low pressure (less than 60 psi) airless type, garden type or deck specific
hand pump sprayer with spray tip orifice minimum of 0.031 inches in diameter does not
produce respirable size aerosol particle concentrations near the AEL.
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Physical Data
Boiling Point : 100 C (212 F)
% Volatiles : 85 WT%
Solubility in Water : 100 %
pH : 4-6
Form : Opaque Liquid
Color : Tan
Specific Gravity : 1.15 @ 20C (68F)
Density : 8.6 lb/gal @ 25 C (77 F)
SECTION 10 STABILITY AND REACTIVITY
Chemical Stability
Stable at normal temperatures and storage conditions. Incompatibility with Other
Materials
Incompatible with cationics and mineral acids. Decomposition
Hazardous decomposition products including carbon dioxide, carbon monoxide, hydrogen fluoride,
toxic gases or particles may be formed during combustion. These products may cause severe
eye, nose, and throat irritation or toxic effects.
Polymerization
Polymerization will not occur.
SECTION 11 TOXICOLOGICAL INFORMATION
Animal Data
Partially Fluorinated Urethane Polymer
Inhalation 4 hour ALC: 590 mg/m3 in rats Oral ALD :
>11,000 mg/kg in rats
Partially Fluorinated Urethane Polymer is a moderate eye irritant and is not a skin irritant in
animals. It low oral toxicity.
SECTION 12 DISPOSAL CONSIDERATIONS
Waste Disposal
Treatment, storage, transportation, and disposal must be in accordance with applicable Federal,
State/Provincial, and Local regulations. Do not burn.
SECTION 13 TRANSPORTATION INFORMATION
Shipping Information
DOT/IMO
Proper Shipping Name : Not Regulated
SECTION 14 REGULATORY INFORMATION
U.S. Federal Regulations
TSCA Inventory Status : Reported/Included. TITLE III HAZARD
CLASSIFICATIONS SECTIONS 311, 312
Acute : Yes
Chronic : No
Fire :No
Reactivity : No
Pressure : No
SECTION 15 OTHER INFORMATION
NFPA, NPCA-HMIS
NPCA-HMIS Rating
Health :1
Flammability :0
Reactivity :0
Personal Protection rating to be supplied by user depending on use conditions.
The data in this Material Safety Data Sheet relates only to the specific material designated herein
and does not relate to use in combination with any other material or in any process.
|