MATERIAL SAFETY DATA SHEET
Stain Magic A Date Prepared: 6/20/2000
SECTION 1 鈥? MATERIAL AND MANUFACTURER IDENTIFICATION
Product Identifier: Stain Magic A
Product Use: Stain Remover
MANUFACTURER
CTI (Chemical Technologies International Inc.)
P.O. Box 968
Rancho Cordova, CA 95741
Phone: (916) 638-1315 Fax: (916) 638-0712
Emergency Assistance Calls: Chemtrec (800) 424-9300 (U.S.A.) 24hrs.
SECTION 2 鈥? COMPOSITION / INFORMATION ON INGREDIENTS
COMPONENT CAS #
1. Trade Secret N/A
(SEE SECTION 8 FOR EXPOSURE GUIDELINES )
SECTION 3 鈥? Hazards Identification
Emergency Overview
Clear liquid with light odor.
Irritating to respiratory and digestive tract, eyes and skin, harmful if swallowed.
Potential Health Effects
Routes of entry: (skin: yes) (inhalation: yes) (ingestion: yes) (eye: yes)
Inhalation:
Inhalation will cause irritation of the respiratory tract.
Eye Contact:
Vapors may irritate eyes. Direct or prolonged contact with eyes will be painful and irritating may also cause possible
permanent damage.
Skin Contact:
Exposure may cause skin irritation, drying, chapping.
Ingestion:
If swallowed will cause GI irritation.
Other effects: Sensory irritation.
SECTION 4 鈥? FIRST AID MEASURES
Inhalation: Remove to fresh air. If breathing is difficult , have trained person administer oxygen. If breathing stops
administer artificial respiration. Get medical attention immediately.
Eye Contact: Immediately flush eyes with a directed stream of water for at least 15 minutes, forcibly holding eyelids
apart to ensure complete irrigation of all eye and lid tissue. Washing eyes within several seconds is essential to
achieve maximum effectiveness. Get medical attention immediately.
MSDS Product: Stain Magic part A 1
Page1 of 5, Revised Date: 6/16/044:02 PM
MATERIAL SAFETY DATA SHEET
Skin Contact: Flush thoroughly with cool water while removing any contaminated clothing and shoes. Wash clothing
before reuse. Get medical attention if irritation persists after washing.
Ingestion: Get medical attention immediately.
Do not induce vomiting. Never give anything by mouth to an unconscious person. Give large quantities of water and
if available give several glasses of milk. If vomiting occurs spontaneously, keep airway clear and give more water.
SECTION 5 鈥? Fire Fighting Measures
Flashpoint: Non-Flammable, Non-Combustible.
Flammable Limits: N/A
Auto ignition Temperature: N/A
General Hazard:
During a fire smoke may contain the original material in addition to toxic and or irritating compounds. Avoid heat
sparks or open flame.
Fire Fighting Instructions:
Use dry chemical or CO2 . Use water (only to cool) nearby containers and structures exposed to fire. Direct water
stream may spread fire. Keep people away from fire, isolate fire area and deny unnecessary entry.
Fire fighting equipment:
Fire fighters should wear a self contained, positive pressure breathing apparatus and full protective clothing
(NICSH/MSHA APPROVED).
Hazardous combustion products:
None Established.
SECTION 6 鈥? ACCIDENTAL RELEASE MEASURES
Small Spills: Wipe or mop up and dispose of in DOT approved waste container, wear protective clothing.
Large Spills: Wear protective clothing, contain by diking with soil or other non-combustible sorbant material, then
dispose into DOT approved waste container. Comply with all applicable governmental regulations on spill reporting,
handling and disposal of waste.
Contain all spills or leaks to prevent discharge into the environment. All spills or releases should be reported to the
appropriate local, state and federal agencies.
SECTION 7 鈥? PRECAUTIONS FOR SAFE HANDLING AND STORAGE
The manufacturer and seller warrants that this product conforms to its standard specifications when used according to
directions. As the conditions of method of its use are beyond our control, we do not assume any responsib ility and
expressly disclaim any liability for use of this product. Information contained herein is believed to be true but all
statements and suggestions are made without any warranty, expressed or implied, regarding accuracy of the
information. The hazards connected with the use of this material and the results to be obtained from the use thereof.
For use by professionals ONLY.
Avoid breathing vapors of this product.
Always ensure good ventilation of surroundings during use of this chemical. Do not use this chemical in a poorly
ventilated area.
Always keep container tightly closed and properly labels.
Avoid contact with skin, eyes or clothing.
Wash thoroughly after handling
Loosen closures cautiously.
MSDS Product: Stain Magic part A
Page 2 of 5, Revised Date: 6/16/044:02 PM
MATERIAL SAFETY DATA SHEET
Storage temperature: Store in cool dry place
Storage pressure: Atmospheric
Avoid excessive heat. Avoid storage with oxidizing agents, acids.
SECTION 8 鈥? EXPOSURE / PERSONAL PROTECTION
EXPOSURE LIMITS
#
COMPONENT OSHA ACGIH OTHER
PEL TLV LIMIT
Not Available
Respiratory: These precautions are not usually necessary in adequately ventilated areas. Wear NIOSH/MSHA
approved respirator when ventilation is not adequate. A NIOSH /MSHA 鈥揳pproved air purifying respirator with an
organic vapor cartridge or canister may be advisable under certain circumstances where airborne concentrations are
expected to exceed exposure limits. Protection provided by air purifying respirators is limited. Use a positive
pressure, air supplied respirator if there is any potential for uncontrolled release, exposure levels are unknown, or any
other circumstances where air-purifying respirators may not provide adequate protection.
Ventilation: Always assure adequate ventilation.
Eye Protection: Wear safety goggles to protect against contact when appropriate.
Skin: Wear protective clothing to minimize skin contact. Wash skin after use. Wash contaminated clothing and dry
before reuse.
Other: Emergency shower and eyewash facility of some kind should be in close proximity.
One should always use chemicals with an awareness of the potential hazard of the effect on the human system.
To minimize employee exposure to all chemicals, including this product, use good industrial hygiene practices.
SECTION 9 鈥? Physical and Chemical properties
PH: 4.0
Vapor pressure: not available
Vapor density: not available
Boiling point: not available
Freezing/Melting point: N/A
Solubility in water: soluble
Density:
Flammability: not established
Particle size: N/A
Evaporation rate: not available
SECTION 10 鈥? Stability and Reactivity
Chemical Stability: Stable at room temperature and atmospheric pressure. Stable under recommended storage and
handling conditions.
Conditions to avoid: Keep away from heat or excessive pressure.
Incompatibility with other materials: Although the mixture has no known incompatibilities, some components of this
mixture are not compatible with acids, metals, and strong oxidizers.
Hazardous decomposition products: There are no known hazardous decomposition materials of this mixture.
Hazardous polymerization: Not established
MSDS Product: Stain Magic part A
Page 3 of 5, Revised Date: 6/16/044:02 PM
MATERIAL SAFETY DATA SHEET
Section 11- Toxicological Information
Toxicological information not available on this mixture.
Section 12- Ecological Information
Ecological information not established on this mixture, although ecological information on components within this
mixture are given.
6.25 ppm/24hr trout/ lethal/ fresh water., 15ppm/ 48hr sunfish/Tlm/ Philadelphia tap water.,
Section 13- Disposal practices
Dispose of all waste, empty bottles and contaminated equipment in accordance with all applicable federal, state and
local health and environmental regulations.
Do not dump into storm drains, sanitary sewers or any body of water. All disposal methods must be in compliance
with all federal, State/ Province and local laws and regulations. Regulations may vary in different locations.
Waste characterizations and compliance with applicable laws are the responsibility solely of the waste generator. The
vendor has no control over the management practices or the processes by which the party who handles or uses this
material. The information presented here pertains only to the product as shipped in its intended condition and
recommended usage.
Section 14- Transport information
Shipping Instructions as shipped are: ORMD/LTD QTY Exemptions Used 173.152 LTD QTY & ORM-D
Consult 49 CFR to assure compliance with all applicable federal, state/provincial and local laws and
regulations that may apply to you.
Section 15- Regulatory Information
US Federal Regulations:
OSHA standards require that information be provided to employees regarding the hazards of chemicals by means of a
hazard communication program including labeling, MSDS sheets, training and access to written records. We request
that you, and it is your legal duty to, make all information in this material safety data sheet (MSDS) available to your
employees and those who handle or consume the product.
To aid our customers in complying with regulatory requirements regulatory information for components of this
product are indicated below.
This mixture has no established regulatory information all regulatory information given is based on individual
components of the mixture by component number.
1. CERCLA RQ: 1,000 lbs, Massachusetts Haz. Substance code: F8, Pennsylvania Haz. Substance Code: E,
2. CERCLA RQ: 1,000 lbs., DOT Haz. Material see49 CFR 173.154, Florida: This chemical is listed as a
toxic substance by the state of Florida, Massachusetts Haz. Code 2,4,5,F8, F9, Pennsylvania Haz code: E.
MSDS Product: Stain Magic part A
Page 4 of 5, Revised Date: 6/16/044:02 PM
MATERIAL SAFETY DATA SHEET
Section 16- Other Information
All information appearing herin is based upon data obtained from the manufacturer and /or recognized technical
sources of each individual component. While the information is believed to be accurate, CTI makes no representations
as to its accuracy or sufficiency. Conditions of use are beyond CTI鈥檚 control and therefore users are responsible to
verify this data under their own operating conditions to determine whether this product is suitable for their particular
purposes and they assume all risks of their use, handling, and disposal of the product, or from the publication or use of,
or reliance on information contained herin. This information relates only to the product designated herin, and does not
relate to its use in combination with any other material or in any other process.
Legend:
References:
MSDS Product: Stain Magic part A
Page 5 of 5, Revised Date: 6/16/044:02 PM
|