MATERIAL SAFETY DATA SHEET
May be used to comply with OSHA's Hazard Communication Standard, 29 SFR 1910.1200. Standard must be consulted for specific requirements.
HMIS Rating
Scot Laboratories Phone: (440) 543-3033 Health- 1
16841 Park Circle Drive Fax: (440) 543-1825 Fire- 0
Chagrin Falls, OH 44023 Date: August 16, 2000 Reactivity-0
0= minimal, 1= slight, 2= moderate, 3= serious, 4= severe
PRODUCT NAME: Foame鈥? Antibacterial Hand Soap (melon)
SECTION II - Hazardous Ingredients/Identity
Hazardous Components (Specific Chem. Ident.) CAS No. OSHA PEL ACGIH TLV OTHER LT
None
Active Ingrtedient: Triclosan Other ingredients: Water, Sodium Lauryl Sulfate, Sodium Laureth Sulfate, Cocamide DEA, Cocamidopropyl Betaine, Nonoxynol-11,
Propylene Glycol, Fragrance, DMDM Hydantoin, Citric Acid, D&C Green #8, FD&C Blue #1
SECTION III - Physical/Chemical Characteristics
212o F
Boiling Point Specific Gravity (H2 O=1) 1.00
32o F
Vapor Pressure (mm Hg) Unknown Melting Point
Vapor Density (AIR=1) Heavier than air Evaporation Rate <1 (Butyl Acetate=1)
Solubility in Water Complete Appearance and Odor Clear green liquid, fruity floral scent
SECTION IV - Fire and Explosion Hazard Data
Flash Pt.(Method Used): None Flammable Limits: None LEL: N/A UEL: N/A
Extinguishing Media: NA
Fire Fighting Procedure: None
Odd Fire & Explosion Hazards: None
SECTION V - Reactivity Data
Stability: Stable under normal conditions
Conditions to Avoid: Avoid temperatures above 140 F o
Materials to Avoid: Do not mix with other chemicals or household cleaners. Follow directions.
Hazardous Decomposition or Byproducts: Unknown
Hazardous Polymerization: Will not Occur
SECTION VI - Health Hazard Data
Route of Entry Inhalation? X Skin? N/A
Health Hazards (acute & chronic) INGESTION- May cause nausea and diarrhea
INHALATION- May cause dizziness or headaches
Carcinogenicity: NTP?: Not listed IARC Monographs?: Not listed OSHA Regulated: Not listed
Medical Conditions Aggravated by Exposure: Unknown
Emergency & First Aid Procedures:
INGESTION- Drink large quantities of water. Consult a physician immediately.
INHALATION- Remove person to fresh air. If breathing has stopped, apply artificial respiration. Consult a physician
EYE CONTACT- Flush with water for 15 minutes. Consult a physician if redness or irritation persists
SECTION VII - Precautions for Safe Handling and Use
Steps to Be Taken in Case of Release or Spill: Recover liquid with adsorbents (sand, earth, clay, sawdust). Mop up or wet vac. Rinse well to remove all traces of product.
Waste Disposal Method: Small amounts may be disposed of down drain or sanitary landfill. Larger amounts must be disposed of in accordance with regulations.
Precautions to Be Taken in Handling and Storing: Do not allow to freeze. Do not store near heat.
Other Precautions: If frozen, allow to thaw to room temperature. Mix before using.
SECTION VIII - Control Measures
Respiratory Protection: Not normally necessary
Ventilation: Local exhaust is normally adequate
Protective Gloves: None
Eye Protection: None
Other Protective Clothing or Equipment: None
Work/Hygienic Practices: Follow good manufacturing and housekeeping practices.
SECTION IX - Special Precautions - None
SECTION X - Department of Transportation
Shipping Hazard Classification: None
DISCLAIMER
The information contained herein was obtained from current and reliable sources. However, the data is provided without any warranty, expressed or implied, regarding
its correctness or accuracy. Since the conditions for use, handling, storage and disposal of this product are beyond Scot Laboratories' control, it is the user's responsibility
both to determine safe conditions for use of this product and to assume liability for loss, injury, damage or expense arising from the product's improper use. No warranty,
expressed or implied, regarding the product described herein shall be created by or inferred from any statement or omission in this MSDS. Various government agencies
(e.g., DOT, EPA, FDA) may have specific regulations concerning the transportation, handling, storage, use or disposal of this product which may not be reflected in this
MSDS. The user should review these regulations to ensure full compliance.
|