Material Safety Data Sheet
Tech Shield Spray Cans
January 2008
I. Identity
Trade Name: D.O.T. # 2.1 UN# 1950
Tech Shield Spray Cans
D.O.T. Hazardous Class
Product Class: Aerosols, Flammable
Distributors Address: Distributor Phone Number:
Brooks Tech Emergency: (952) 898-3200
14551 Judicial Road, Ste 115 Chemtree: 1-800-424-9300
Burnsville, MN 55306
II. Ingredients
CAS WT% ACGIH ACGIH OSHA OSHA
INGREDIENT
NUMBER TLV-TWA TLV-STEL PEL-TWA PEL-STEL
Toluene 108-88-3 42 50 PPM (skin) 100PPM 150PPM
-
Hydrocarbon-Resin 68441-37-2 11.4 N/A N/A N/A N/A
Thermo Plastic Rubber 66070-58-4 5.4 N/A N/A N/A N/A
Anti-Oxidant 68610-51-5 1.2 N/A N/A N/A N/A
Propane 74-98-6 27.2 1000PPM 1000PPM
N.Butane, Volume 106-97-8 12.8 800PPM 800 PPM
HMIS RATING HMIS HAZARD IDENTIFICATION SYSTEM
Health -2 0 - Minimal 3 - High
Fire -3 1 - Slight 4 - Extreme
Reactivity -0 2 - Moderate
III. Physical Data
WT/Gallon:
Boiling Point (掳F): 7.5#
230-232 Deg F
Volatile by (%) Volume: Evaporation Rate (Butyl Acetate=1)
70 1.5 Initial
Vapor Density (Air=1) 3.2
IV. Fire & Explosion Hazard Data
Flash Point (TTC): Upper Flammable Limits (% in Air)
45 Deg F 7.0
Lower flammable Limits (% in Air)
1.0
Extinguishing Media Carbon Dioxide Foam, Dry Chemical and Water
Special Fire Fighting Procedures Firefighters should wear Self-Contained Breathing Apparatus
Unusual Fire & Explosion Hazards Irritating and/or toxic gases or fumes may be generated by
Thermal Decomposition and Combustions. Closed containers may rupture or explode (Due to
Pressure Build-up) when exposed to extreme heat. Vapor density is heavier than air and
may travel along the ground to be re-ignited at locations distant from the source.
Flashback of flame may occur
V. Reactivity Data
Stability: Stable
Conditions to Avoid: All Sources of ignition, sparks and extreme heat
Incompatibility (Materials to Avoid): Strong Oxidizing agents
Hazardous Decomposition and Decomposition Products: Carbon Monoxide, Carbon Dioxide, Aldehydes
and other Organic Decomposition Products
VI. Toxicological Properties
Routes of Entry: Eyes, Skin and Inhalation
Effect of Exposure to Products: May case some transient reddening of skin
Effects of Chronic Exposure to Products: None currently known
Exposure Limits: Irritancy to Product:
N/A No Evidence
Sensitivity to Product: Carcinogenicity of Product: No Evidence
No Evidence
Reproductive Toxicity: No Evidence Mutagenicity: No Evidence
Synergistic Products: No Evidence
VII. Preventative Measures
PERSONAL PROTECTIVE EQUIPMENT
Respirator: NIOSH approved Organic Vapor Mask
Gloves: Wear protective gloves
Eye: Goggles or glasses with side shields
Clothing: Follow good industrial standards
Ventilation: Use mechanical ventilation to minimize fumes in use area
Handling Procedure: Avoid contact with skin, eyes and avoid prolonged breathing
Leaks and Spills Procedure: Contain and pick up with an absorbent material as required
Storage Requirements: Store in cool, dry place away from acids and oxidizers
Waste Disposal: Dispose of according to Local, State, and Federal Regulations
Hygienic Practices: Observe Normal Industrial Hygienic Practices
VIII. First Aid and Measures
SPECIFIC MEASURES
Eye Contact: Flush with water for at least 15 minutes, consult Physician
Skin Contact: Remove with soap and water, if irritated consult Physician
Inhalation: Remove to fresh air, contact Physician, resuscitate and administer oxygen as
necessary
Ingestion: Do not induce vomiting. Contact Physician immediately
IX. SARA Section 313 Supplier Notification
CAS# Chemical Name Percent by WT.
108-88-3 Toluene 42
X. Preparation Information
Prepared by: Research & Development Phone Number: 952-882-0917
OTHER COMMENTS
Disclaimer of Liability
The information in this MSDS was obtained from sources, which we believe are reliable. However, the
information is provided without any warranty, expressed or implied regarding it correctness. Some
information presented and conclusions drawn herein are from sources other than direct test data on the
substance itself. This MSDS was prepared and is to be used only for this product. If the product is
used as a component in another product, this MSDS information may not be applicable. User should make
their own investigations to determine the suitability of the information or products of their
particular purpose
The conditions or methods of handling, storage, use, and disposal of the product are beyond our
control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility
and expressly disclaim liability of loss, damage or expense arising out of or in any way connected
with handling, storage, use or disposal of the product.
|